SearcharxivSearch

arXiv subjects

Carl Gustafson

Publications and source records attributed to Carl Gustafson.

3 recordsLinked to original sources

The COST IRACON Geometry-based Stochastic Channel Model for Vehicle-to-Vehicle Communication in Intersections

Vehicle-to-vehicle (V2V) wireless communications can improve traffic safety at road intersections and enable congestion avoidance. However, detailed knowledge about the wireless propagation channel is needed for the development and realistic assessment of V2V communication systems. We present a novel geometry-based stochastic MIMO channel model with support for frequencies in the band of 5.2-6.2 GHz. The model is based on extensive high-resolution measurements at different road intersections in the city of Berlin, Germany. We extend existing models, by including the effects of various obstructions, higher order interactions, and by introducing an angular gain function for the scatterers. Scatterer locations have been identified and mapped to measured multi-path trajectories using a measurement-based ray tracing method and a subsequent RANSAC algorithm. The developed model is parameterized, and using the measured propagation paths that have been mapped to scatterer locations, model parameters are estimated. The time variant power fading of individual multi-path components is found to be best modeled by a Gamma process with an exponential autocorrelation. The path coherence distance is estimated to be in the range of 0-2 m. The model is also validated against measurement data, showing that the developed model accurately captures the behavior of the measured channel gain, Doppler spread, and delay spread. This is also the case for intersections that have not been used when estimating model parameters.

eess.SP

A Measurement Based Multilink Shadowing Model for V2V Network Simulations of Highway Scenarios

Shadowing from vehicles can significantly degrade the performance of vehicle-to-vehicle (V2V) communication in multilink systems, e.g., vehicular ad-hoc networks (VANETs). It is thus important to characterize and model the influence of common shadowing objects like cars properly when designing these VANETs. Despite the fact that for multilink systems it is essential to model the joint effects on the different links, the multilink shadowing effects of V2V channels on VANET simulations are not yet well understood. In this paper we present a measurement based analysis of multilink shadowing effects in a V2V communication system with cars as blocking objects. In particular we analyze, characterize and model the large scale fading, both regarding the autocorrelation and the joint multilink cross-correlation process, for communication at 5.9 GHz between four cars in a highway convoy scenario. The results show that it is essential to separate the instantaneous propagation condition into line-of-sight (LOS) and obstructed LOS (OLOS), by other cars, and then apply an appropriate pathloss model for each of the two cases. The choice of the pathloss model not only influences the autocorrelation but also changes the cross-correlation of the large scale fading process between different links. By this, we conclude that it is important that VANET simulators should use geometry based models, that distinguish between LOS and OLOS communication. Otherwise, the VANET simulators need to consider the cross-correlation between different communication links to achieve results close to reality.

cs.NI

Statistical Modeling and Estimation of Censored Pathloss Data

Pathloss is typically modeled using a log-distance power law with a large-scale fading term that is log-normal. However, the received signal is affected by the dynamic range and noise floor of the measurement system used to sound the channel, which can cause measurement samples to be truncated or censored. If the information about the censored samples are not included in the estimation method, as in ordinary least squares estimation, it can result in biased estimation of both the pathloss exponent and the large scale fading. This can be solved by applying a Tobit maximum-likelihood estimator, which provides consistent estimates for the pathloss parameters. This letter provides information about the Tobit maximum-likelihood estimator and its asymptotic variance under certain conditions.

cs.IT