arXiv subjects

Charles

Publications and source records attributed to Charles.

6 recordsLinked to original sources

arXiv2026

Spatial Mapping and Capacitor Trimming Developments to Improve Usable Pixel Yield in PRIMA FIRESS Kilo-Pixel Arrays

The Probe far-Infrared Mission for Astrophysics (PRIMA) will use 8 kilo-pixel kinetic inductance detector (KID) arrays in its spectrometer module. We present an improved resonant frequency to spatial position mapping system designed to preserve each array's mapping after transferring it from the mapping apparatus to the flight housing. Such a mapping is necessary for astronomical observations, and additionally allows us to laser trim the capacitive elements of KIDs to optimize resonance separation in frequency space. This increases the operating yield by eliminating collided resonances, reduces crosstalk, and reduces the sensitivity to frequency drift over time.

astro-ph.IM↗

arXiv2026

Radiation Total Dose for PRIMA: Cold Exposure with Alpha Particles

The Probe far-Infrared Mission for Astrophysics (PRIMA) is a far-infrared (24-261 micron wavelengths) probe-class space observatory currently under Phase A study, which promises orders-of-magnitude improvement in mapping speed over its predecessors. PRIMA will field exquisitely sensitive kilopixel arrays of kinetic inductance detectors (KIDs) for the Far-Infrared Enhanced Survey Spectrometer (FIRESS) instrument. PRIMA will orbit in space at the Sun-Earth L2 point, where Planck found the energetic particle flux to be about 300/min/cm2. Thus, the possible effect of a high fluence of energetic particles on the detector sensitivity must be characterized. Previous work has suggested that bombardment of KIDs by ions can reduce the quasiparticle lifetime (Barends et. al. 2009), but the conditions of the experiment were not representative of a detector which is continuously held at sub-Kelvin temperatures in the energetic particle environment of L2 orbit. To better replicate the damage which would be produced by energetic particles in this environment, we developed a fully cryogenic irradiation experiment in which a stepper motor controls a screen which can block or reveal an alpha particle emitter. This setup can be used to irradiate aluminum KID arrays fabricated for FIRESS to well-controlled dose levels. In this work, we calculate the damage dose expected for a 5-year mission in L2 orbit, and we irradiate an array to approximately 62 percent of this level. Before and after irradiation, we measure the quasiparticle lifetimes, resonant frequencies, and quality factors of the detectors.

astro-ph.IM↗

arXiv2024

Development of an ultra-sensitive 210-micron array of KIDs for far-IR astronomy

The Probe far-Infrared Mission for Astrophysics (PRIMA) is a proposed space observatory which will use arrays of thousands of kinetic inductance detectors (KIDs) to perform low- and moderate-resolution spectroscopy throughout the far-infrared. The detectors must have noise equivalent powers (NEPs) at or below 0.1 aW/sqrt(Hz) to be subdominant to noise from sky backgrounds and thermal noise from PRIMA's cryogenically cooled primary mirror. Using a Radio Frequency System on a Chip for multitone readout, we measure the NEPs of detectors on a flight-like array designed to observe at a wavelength of 210 microns. We find that 92% of the KIDs measured have an NEP below 0.1 aW/sqrt(Hz) at a noise frequency of 10 Hz.

astro-ph.IM↗

arXiv2023

Modeling of cosmic rays and near-IR photons in aluminum KIDs

The PRobe far-Infrared Mission for Astrophysics (PRIMA) is working to develop kinetic inductance detectors (KIDs) that can meet the sensitivity targets of a far-infrared spectrometer on a cryogenically cooled space telescope. An important ingredient for achieving high sensitivity is increasing the fractional-frequency responsivity. Here we present a study of the responsivity of aluminum KIDs fabricated at the Jet Propulsion Laboratory. Specifically, we model the KID's temporal response to pair-breaking excitations in the framework of the Mattis-Bardeen theory, incorporating quasiparticle recombination dynamics and the pair-breaking efficiency. Using a near-IR laser, we measure time-resolved photon pulses and fit them to our model, extracting the time-resolved quasiparticle density and the quasiparticle recombination lifetime. Comparing the fit to the known energy of the laser provides a measurement of the pair-breaking efficiency. In addition to photon-sourced excitations, it is important to understand the KID's response to phonon-sourced excitations from cosmic rays. We measure the rate of secondary cosmic rays detected by our devices, and predict the dead time due to cosmic rays for an array in L2 orbit. This work provides confidence in KIDs' robustness to cosmic ray events in the space environment.

astro-ph.IM↗

arXiv2023

High-sensitivity Kinetic Inductance Detector Arrays for the Probe Far-Infrared Mission for Astrophysics

Far-infrared (far-IR) astrophysics missions featuring actively cooled telescopes will offer orders of magnitude observing speed improvement at wavelengths where galaxies and forming planetary systems emit most of their light. The PRobe far-Infrared Mission for Astrophysics (PRIMA), which is currently under study, emphasizes low and moderate resolution spectroscopy throughout the far-IR. Full utilization of PRIMA's cold telescope requires far-IR detector arrays with per-pixel noise equivalent powers (NEPs) at or below 1 x 10-19 W/rtHz. We are developing low-volume Aluminum kinetic inductance detector (KID) arrays to reach these sensitivities. We will present on the development of our long-wavelength (210 um) array approach, with a focus on multitone measurements of our 1,008-pixel arrays. We measure an NEP below 1 x 10-19 W/rtHz for 73 percent of our pixels.

astro-ph.IM↗

arXiv2023

High-sensitivity transition-edge-sensed bolometers: improved speed and characterization with AC and DC bias

We report on efforts to improve the speed of low-G far-infrared transition-edged-sensed bolometers. We use a fabrication process that does not require any dry etch steps to reduce heat capacity on the suspended device and measure a reduction in the detector time constant. However, we also measure an increase in the temperature-normalized thermal conductance (G), and a corresponding increase in the noise-equivalent power (NEP). We employ a new near-IR photon-noise technique using a near-IR laser to calibrate the frequency-domain multiplexed AC system and compare the results to a well-understood DC circuit. We measure an NEP white noise level of 0.8 aW/rtHz with a 1/f knee below 0.1 Hz and a time constant of 3.2 ms.

physics.app-ph↗