SearcharxivSearch

arXiv subjects

Che-Hao Liao

Publications and source records attributed to Che-Hao Liao.

3 recordsLinked to original sources

Epitaxial Growth of $β$-Ga$_2$O$_3$ Coated Wide Bandgap Semiconductor Tape for Flexible UV Photodetector

The epitaxial growth of technically-important $β$-Ga$_2$O$_3$ semiconductor thin films have not been realized on flexible substrates due to limitations by the high-temperature crystallization conditions and the lattice-matching requirements. In this report, for the first time single crystal $β$-Ga$_2$O$_3$(-201) thin films is epitaxially grown on the flexible CeO2 (001)-buffered hastelloy tape. The results indicate that CeO$_2$ (001) has a small bi-axial lattice mismatch with $β$-Ga$_2$O$_3$ (-201), thus inducing a simultaneous double-domain epitaxial growth. Flexible photodetectors are fabricated based on the epitaxial $β$-Ga$_2$O$_3$ coated tapes. Measurements show that the obtained photodetectors have a responsivity of 40 mA/W, with an on/off ratio reaching 1000 under 250 nm incident light and 5 V bias voltage. Such photoelectrical performance is already within the mainstream level of the $β$-Ga$_2$O$_3$ based photodetectors by using the conventional rigid single crystal substrates; and more importantly remained robust against more than 1000 cycles of bending tests. In addition, the epitaxy technique described in the report also paves the way for the fabrication of a wide range of flexible epitaxial film devices that utilize the materials with lattice parameters similar to $β$-Ga$_2$O$_3$, including GaN, AlN and SiC.

physics.app-ph

\b{eta}-phase (AlxGa1-x)2O3 thin film with Al composition more than 70%

In this work, we have demonstrated wide-composition-range \b{eta}-(AlxGa1-x)2O3 thin films with record-high Al compositions up to 77% for \b{eta}-(AlxGa1-x)2O3 covering bandgaps from 4.9 to 6.4 eV. With optimized thermal annealing conditions, the \b{eta}-Ga2O3 binary thin films on sapphire substrates transformed to the \b{eta}-(AlGa)2O3 ternary thin films with different compositions. The binary to ternary transformation resulted from the Al atom diffusion from sapphire into the oxide layers; meanwhile, the Ga atoms diffused into sapphire leading to thicker thin films than the original thicknesses. The interdiffusion processes were confirmed by transmission electron microscopy, which enhanced in proportion to the annealing temperature. The strain states of the \b{eta}-(AlGa)2O3 films have been analyzed showing reduced in-plane compressive strain with higher annealing temperature; and the film eventually became strain-free when the temperature was 1400 oC corresponding to the Al composition of 77%. The proposed method is promising for the preparation of the \b{eta}-(AlGa)2O3 thin films without employing sophisticated direct-growth techniques for alloys.

physics.app-ph

Band structures and direct-to-indirect bandgap transitions in BAlN and BGaN alloys: a first principle study

In this work, the energy band structures of BGaN and BAlN alloys are systematically studied through first-principles calculation using HSE hybrid density functional theory by MedeA-VASP. Direct-indirect bandgap transition of BGaN alloys at B content around 44% and that of BAlN alloys at B content about 24% have been identified. The variation of electron and hole effective masses of both materials at different B compositions have also been demonstrated. A large change in hole effective masses of BGaN and BAlN alloys from B=0% to 25% has been observed. Finally, a picture of energy bandgap versus lattice constant of III-nitride family with boron is shown.

physics.app-ph