SearcharxivSearch

arXiv subjects

Chiara Casini

Publications and source records attributed to Chiara Casini.

3 recordsLinked to original sources

PRICM3: A novel Polarization Ratio framework for three-dimensional CME reconstruction

Coronal mass ejections (CMEs) are inherently three-dimensional (3D), but traditional white-light coronagraphs provide only two-dimensional (2D) projections. While the Polarization Ratio Technique (PRT) utilizes Thomson scattering to infer proxy 3D plasma locations, its results are typically limited to 2D topographical maps, hindering geometric interpretation. To address this, we introduce PRICM3 (Polarization Ratio Integrated CME Mapper in 3D), a framework that converts PRT-derived maps into explicit 3D point-cloud reconstructions. This tool enables intuitive visualization, multi-viewpoint comparison, and direct validation against geometric models such as the Graduated Cylindrical Shell (GCS). As a proof-of-concept, we analyzed a limb CME observed on 28 October 2021 using data from Solar Orbiter/Metis, SOHO/LASCO, and STEREO-A/COR2. The independent reconstructions converged into a consistent 3D volume that aligned remarkably well with the corresponding GCS geometry. These results prove that the 3D information embedded in PRT topographical maps can be successfully recovered through spatial reconstruction. PRICM3 offers a powerful, intuitive method for interpreting polarimetric coronagraph observations, providing a vital tool for current and future solar missions such as Proba-3/ASPIICS and PUNCH.

astro-ph.SR

Coronal Heating Rate in the Slow Solar Wind

This Letter reports the first observational estimate of the heating rate in the slowly expanding solar corona. The analysis exploits the simultaneous remote and local observations of the same coronal plasma volume with the Solar Orbiter/Metis and the Parker Solar Probe instruments, respectively, and relies on the basic solar wind magnetohydrodynamic equations. As expected, energy losses are a minor fraction of the solar wind energy flux, since most of the energy dissipation that feeds the heating and acceleration of the coronal flow occurs much closer to the Sun than the heights probed in the present study, which range from 6.3 to 13.3 solar radii. The energy deposited to the supersonic wind is then used to explain the observed slight residual wind acceleration and to maintain the plasma in a non-adiabatic state. As derived in the Wentzel-Kramers-Brillouin limit, the present energy transfer rate estimates provide a lower limit, which can be very useful in refining the turbulence-based modeling of coronal heating and subsequent solar wind acceleration.

astro-ph.SR

Exploring the Solar Wind from its Source on the Corona into the Inner Heliosphere during the First Solar Orbiter - Parker Solar Probe Quadrature

This Letter addresses the first Solar Orbiter (SO) -- Parker Solar Probe (PSP) quadrature, occurring on January 18, 2021, to investigate the evolution of solar wind from the extended corona to the inner heliosphere. Assuming ballistic propagation, the same plasma volume observed remotely in corona at altitudes between 3.5 and 6.3 solar radii above the solar limb with the Metis coronagraph on SO can be tracked to PSP, orbiting at 0.1 au, thus allowing the local properties of the solar wind to be linked to the coronal source region from where it originated. Thanks to the close approach of PSP to the Sun and the simultaneous Metis observation of the solar corona, the flow-aligned magnetic field and the bulk kinetic energy flux density can be empirically inferred along the coronal current sheet with an unprecedented accuracy, allowing in particular estimation of the Alfvén radius at 8.7 solar radii during the time of this event. This is thus the very first study of the same solar wind plasma as it expands from the sub-Alfvénic solar corona to just above the Alfvén surface.

astro-ph.SR