arXiv subjects

Christian Darsow-Fromm

Publications and source records attributed to Christian Darsow-Fromm.

8 recordsLinked to original sources

arXiv2025

Photodiode quantum efficiency for 2-μm light in the signal band of gravitational wave detectors

Quantum technologies with quantum correlated light require photodiodes with near-perfect `true' quantum efficiency, the definition of which adequately accounts for the photodiode dark noise. Future squeezed-light-enhanced gravitational wave detectors could in principle achieve higher sensitivities with a longer laser wavelength around 2 μm. Photodiodes made of extended InGaAs are available for this range, but the true quantum efficiency at room temperature and the low frequency band of gravitational waves is strongly reduced by dark noise. Here we characterize the change in performance of a commercial extended-InGaAs photodiode versus temperature. While the dark noise decreases as expected with decreasing temperature, the detection efficiency unfortunately also decreases monotonically. Our results indicate the need for a dedicated new design of photodiodes for gravitational wave detectors using 2-μm laser light.

quant-ph↗

arXiv2025

Integrating high-precision and fringe-scale displacement sensing using heterodyne cavity-tracking

We present a heterodyne stabilized cavity-based interferometer scheme that can serve as a compact and high-sensitivity displacement sensor with a fringe-scale operating range. The technique, in principle, can reach a sub-femtometer noise floor and an operating range on the order of one laser wavelength at $λ\approx 1\,μm$. With our current experimental setup, we achieve a sensitivity of about $260 fm/\sqrt{\mathrm{Hz}}$ at $1\,Hz$ and $46 fm/\sqrt{\mathrm{Hz}}$ at around $130\,Hz$. By probing a length actuated cavity, we demonstrate six orders of magnitude of dynamic range for displacement measurement, reaching a maximum motion of $0.15\,μm$. The tracking bandwidth and displacement range are limited by analog effects in the signal digitization and are extendable in the future.

physics.optics↗

arXiv2024

On the Development of an RFSoC-Based Ultra-Fast Phasemeter With GHz Bandwidth

Precise measurements of the frequency and phase of an electrical or optical signal play a key role in various branches of science and engineering. Tracking changing laser frequencies is especially demanding when the lasers themselves are noisy or if the frequencies rapidly change because they encode highly dynamic signals in, e.g., Doppler-ranging or dynamic cavity readout. Here, to address these and other possible applications, we report the development of a high signal bandwidth (> 2 GHz) and high tracking bandwidth (2 MHz) multi-channel Phasemeter. The implementation utilizes an all-digital phase-locked loop realized within the field programmable gate array (FPGA) part of a radio frequency system-on-chip (RFSoC), the programmable logic (PL). The new features of the phasemeter are obtained by operating the PL at its timing limits and introducing a multi-demodulation and phase accumulation scheme. We present performance measurements, discuss the role of the high tracking bandwidth for tracking highly dynamic signals, and demonstrate ultra-stable phase locking of a beat note between two widely tunable external cavity diode lasers. We achieve a phase-noise floor in the sub-milli radian regime when comparing two signals, even for GHz frequencies, and demonstrate stable tracking of signals with a frequency change rate of 240 GHz/s.

physics.ins-det↗

arXiv2024

Observation of Noise Suppression during High-Efficiency Wavelength Doubling of Intense Quasi-Monochromatic Laser Light

Ultra-stable, quasi-monochromatic laser light forms the basis for high-precision interferometric measurements, e.g. for observing gravitational waves and for time keeping with optical clocks. Optical frequency conversion enables access to wavelengths at which optical materials have the lowest absorption and the lowest mechanical loss. Here we report a 25 % reduction in relative intensity noise (of technical origin) when converting 1064 nm to 2128 nm for powers far above parametric oscillation threshold. The new wavelength has high potential for improving gravitational wave detection and other ultra-high-precision experiments as well. Our results provide a better understanding of the dynamics of nonlinear optical processes and have great potential for the stabilisation of laser sources in optical sensing and metrology.

physics.optics↗

arXiv2023

30 W ultra-stable laser light at 2128 nm for future gravitational-wave observatories

Thermal noise of the dielectric mirror coatings can limit laser-optical high-precision measurements. Coatings made of amorphous silicon and silicon nitride could provide a remedy for both gravitational-wave detectors and optical clocks. However, the absorption spectra of these materials require laser wavelengths around 2 $μ$m. For GW detectors, ultra-stable laser light of tens or hundreds of watts is needed. Here, we report the production of nearly 30 W of ultra-stable laser light at 2128 nm by frequency conversion of 1064 nm light from a master oscillator power amplifier system. We achieve an external conversion efficiency of (67.5 $\pm$ 0.5) % via optical parametric oscillation and a relative power noise in the range of $10^{-6}$/$\sqrt{\text{Hz}}$ at 100 Hz, which is almost as low as that of the input light and underlines the potential of our approach.

physics.optics↗

arXiv2021

NQontrol: An open-source platform for digital control-loops in quantum-optical experiments

Experiments in quantum optics often require a large number of control loops, e.g. for length-stabilization of optical cavities and control of phase gates. These control loops are generally implemented using one of three approaches: commercial (digital) controllers, self-built analog circuitry, or custom solutions based on Field Programmable Gate Arrays (FPGAs) and microcontrollers. Each of these approaches has individual drawbacks, such as high cost, lack of scalability and flexibility, or high maintenance effort. Here we present NQontrol, a solution based on the ADwin digital control platform that delivers eight simultaneous locking loops running with 200 kHz sampling frequency, and offers five second-order filtering sections per channel for optimal control performance. A comprehensive software package written in Python, together with a web-based graphical user interface (GUI), makes the system as easy to use as commercial products, while giving the full flexibility of open-source platforms.

physics.ins-det↗

arXiv2021

Squeezed light at 2128 nm for future gravitational-wave observatories

All gravitational-wave observatories (GWOs) have been using the laser wavelength of 1064 nm. Ultra-stable laser devices are at the sites of GEO 600, Kagra, LIGO and Virgo. Since 2019, not only GEO 600 but also LIGO and Virgo have been using separate devices for squeezing the uncertainty of the light, so-called squeeze lasers. The sensitivities of future GWOs will strongly gain from reducing the thermal noise of the suspended mirrors, which involves shifting the wavelength into the 2 $μ$m region. Our work aims for reusing the existing high-performance lasers at 1064 nm. Here, we report the realisation of a squeeze laser at 2128 nm that uses ultra-stable pump light at 1064 nm. We achieve the direct observation of 7.2 dB of squeezing, as the first step, at MHz sideband frequencies. The squeeze factor achieved is mainly limited by the photodiode's quantum efficiency, which we estimated to (92$\pm$3)%. Reaching larger squeeze factors seems feasible, also in the required audio and sub-audio sideband, provided photo diodes with sufficiently low dark noise will be available. Our result promotes 2128 nm as the new, cost-efficient wavelength of GWOs.

physics.optics↗

arXiv2020

Highly-efficient generation of coherent light at 2128 nm via degenerate optical-parametric oscillation

Cryogenic operation in conjunction with new test-mass materials promises to reduce the sensitivity limitations from thermal noise in gravitational-wave detectors. The currently most advanced materials under discussion are crystalline silicon as a substrate with amorphous silicon-based coatings. They require, however, operational wavelengths around 2 $\mathrmμ$m to avoid laser absorption. Here, we present a light source at 2128 nm based on a degenerate optical parametric oscillator (DOPO) to convert light from a 1064 nm non-planar ring-oscillator (NPRO). We achieve an external conversion efficiency of $(88.3\,\pm\,1.4)\,\%$ at a pump power of 52 mW in PPKTP (periodically-poled potassium titanyl phosphate, internal efficiency was 94 %), from which we infer an effective non-linearity of $(4.75\,\pm\,0.18)\,\mathrm{pm/V}$. With our approach, light from the established and existing laser sources can be efficiently converted to the 2 $\mathrmμ$m regime, while retaining the excellent stability properties.

physics.optics↗