arXiv subjects

Chunhua Tian

Publications and source records attributed to Chunhua Tian.

3 recordsLinked to original sources

arXiv2026

Stochastic twinning in confined volumes of Mg: Insights from in-situ micromechanical testing and atomistic simulations

Tensile twinning plays a central role in accommodating -axis plasticity in Mg. In bulk Mg, twinning typically shows a relatively deterministic response with a low critical stress, whereas in confined volumes it exhibits pronounced scatter, complicating the prediction of small-scale mechanical behavior. In this study, we investigate the origin of this stochasticity by combining site-specific micropillar compression with atomistic simulations. Experiments show that under -axis compression, plastic deformation is dominated by {10-12} twinning, with each discrete stress drop in the stress-strain response marking the activation and rapid advance of a twin. Atomistic simulations further separate twinning into two mechanistic regimes: nucleation and longitudinal propagation occur in a high-stress, shuffle-assisted regime, whereas lateral thickening proceeds in a low-stress regime controlled by disconnection glide. Linking these mechanistic insights with post-mortem characterization of deformed pillars demonstrates that the scatter in measured yield stresses arises from stochastic selection among competing twinning pathways, governed by the local defect landscape (presence, distribution, and morphology of pre-existing defects). Overall, this work identifies an atomistic basis for size-dependent stochastic twinning in Mg and provides a general framework for materials whose plasticity is controlled by discrete activation events.

cond-mat.mtrl-sci↗

arXiv2024

Fracture of the $C$15 CaAl$_2$ Laves phase at small length-scales

The cubic $C$15 CaAl$_2$ Laves phase is a crucial brittle intermetallic precipitate in Mg-Al-Ca alloys. Although knowledge of the mechanical properties of coexisting phases is essential for improved alloy design, the fracture toughness is not yet studied experimentally due to the need for miniaturised testing. Here, micropillar splitting and microcantilever bending are used to experimentally determine the toughness of CaAl$_2$. It is found that the toughness value of ~1 $MPa\cdot\sqrt m$ from pillar splitting is largely insensitive to sample heat treatment, ion beam used for fabrication, micropillar diameter, and surface orientation. From nanoindentation supported by electron channelling contrast imaging and backscatter diffraction, fracture is observed to take place mostly on {011} planes. Atomistic fracture simulations on a model $C$15 Laves phase showed that the preference of {011} cleavage planes over the more energetically favourable {111} is due to lattice trapping and kinetics controlling fracture. Using rectangular microcantilever bending tests where the notch plane was misoriented to the closest possible {112} cleavage plane by ~8°, and the closest {001}, {011} and {111} plane by >20°, a toughness of ca. 2 $MPa\cdot\sqrt m$ was determined along with the electron microscopy observation of significant deviations of the crack path, demonstrating that preferential crystallographic cleavage planes determine the toughness in this material. Further investigation using pentagonal microcantilevers with precise alignment of the notch with the cleavage planes revealed similar fracture toughness values for different low-index planes. The results presented here are the first detailed experimental study of fracture toughness of the $C$15 CaAl$_2$ Laves phase, and can be understood in terms of crack plane and crack front dependent fracture toughness.

cond-mat.mtrl-sci↗

arXiv2022

Preferred corrosion pathways for oxygen in Al2Ca-twin boundaries and dislocations

With an ongoing discussion on the oxygen diffusion along crystal defects remaining, it is difficult to study this phenomenon in Al containing intermetallic materials due to its rapid and passivating oxide formation. We report here the observation of enhanced oxygen diffusion along crystal defects, i.e. dislocations and twin boundaries, in the C15 Al 2 Ca Laves phase and how the presence of oxygen induces structural changes at these defects. Three main phases were identified and characterized structurally by aberration-corrected, atomic resolution scanning transmission electron microscopy, analytically by energy dispersive X-ray spectroscopy and electron energy loss spectroscopy. Unlike the C15 bulk phase, the twin boundary and dislocation transformed into a few nanometer wide amorphous phase, which depletes in Al and Ca but is highly enriched in oxygen. The dislocation even shows coexistence of the amorphous phase with a simple Al-rich A1 fcc phase. This A1 phase only depletes in Ca, not in Al (Al remains at bulk concentration), and is also enriched in oxygen. The Al-rich A1 phase is coherent with the C15 matrix. Electron energy loss spectroscopy revealed the amorphous phase to be Al 2 O 3 . We thereby show as one of the first studies that oxygen diffusion along crystal defects, especially also at the twin boundary can induce the formation of an amorphous oxide along themselves. The identification of oxygen-induced transformation at strained defects has to be considered when the material is exposed to air during plastic deformation at elevated temperatures.

cond-mat.mtrl-sci↗