Chunxi Chen | Searcharxiv

arXiv2026

mmAlert: A Simultaneous Device Localization and Target Tracking System via Cooperative Passive Sensing

In this paper, a cooperative passive sensing system in millimeter-wave (mmWave) band for simultaneous device localization and target tracking, namely mmAlert, is proposed. Specifically, in uplink communication with at least two transmitters, the receiver receives the line-of-sight (LoS) signals and the scattered signals off a moving target, respectively. Based on the received signals of the sensing time intervals, when a passive target moves along one or multiple unknown trajectories, mmAlert could measure the angles-of-arrival (AoAs) and bistatic Doppler frequencies of the echoes from the sensing target, and then jointly estimate the locations of the transmitters and the trajectories of the target. Specifically, the transmitters' locations and the moving target's trajectories can be searched by minimizing the weighted mean squared error of the AoA and Doppler measurements. The optimal solution of the minimization problem is prohibitive due to the large number of variables. Hence, a low-complexity algorithm based on the alternating optimization is proposed, where the extended Kalman filter (EKF) is introduced to quickly shape the trajectories. The mmAlert is implemented in a 60GHz communication testbed. The experiment shows with the received signal spanning a single trajectory, the average localization error of the transmitters and average trajectory reconstruction error are 0.76 m and 0.29 m, respectively. The average errors are suppressed to 0.07 m and 0.2 m respectively, if the received signal spanning 50 trajectories is used. This justifies the benefit of trajectory diversity in localization and tracking.

cs.NI↗

arXiv2026

WiSLAT: A Simultaneous Device Localization and Target Tracking Method for Wi-Fi Systems

It has been shown that the channel state information (CSI) of a Wi-Fi system can be exploited to localize Wi-Fi devices or track trajectory of a moving target. In the existing literature, both sensing tasks are treated separately and some prior information is usually requested, including the signal fingerprints, the locations of some anchor devices in the Wi-Fi system, and etc. In the proposed WiSLAT method, however, it is shown that both sensing tasks can assist each other, such that the request on prior system information can be eliminated. Particularly, in a Wi-Fi system with an access point (AP) and at least three stations, where the locations of the stations are unknown, the WiSLAT is designed to detect the Doppler frequencies of the downlink CSI at the stations, such that their locations and the trajectory of the target with respect to the AP can be inferred. The joint detection can be conducted by searching the optimal stations' locations and target's trajectory, such that their corresponding Doppler frequencies fit the observed ones best. Due to the tremendous non-convex search space, a low-complexity sub-optimal algorithm integrating alternate optimization, extended Kalman filter and density-based clustering is proposed in WiSLAT. Experiments conducted in indoor environments demonstrate the effectiveness of WiSLAT, achieving a median trajectory-tracking error of 0.68 m.

eess.SP↗