arXiv subjects

Claude Marchand

Publications and source records attributed to Claude Marchand.

5 recordsLinked to original sources

arXiv2024

Design, fabrication and test of a 5 GHz klystron based on the kladistron principle

A new bunching method, named "kladistron" has been developed at CEA in order to provide high efficiency klystrons. A first "kladistron" prototype was designed and realized. It was adapted from the 4.9 GHz TH2166 from Thales, where the interaction line was transformed from 6 to 16 cavities. The design and fabrication phases of this prototype are developed in this paper. The kladistron prototype was tested in Thales facility. Its efficiency is finally lower (41 %) than expected (55 %), moreover it presents a spurious oscillation at 4.96 GHz. After analysis of the experimental results, it is concluded that the discrepancy between design and real frequencies is the cause for the low efficiency while the spurious oscillation results from a high gain peak at 4.96 GHz.

physics.acc-ph↗

arXiv2022

Coupled multiphysics analysis of a 4-vane RFQ accelerator under high power operation

The radiofrequency resonant four-quadrant mechanical structure of a 4-vane Radio Frequency Quadrupole (RFQ) has a high quality factor and narrow bandwidth, resulting in high sensitivity to frequency detuning caused by thermal expansion under high power operation, so minimization of frequency errors and affording dynamic tuning are very important design issues. Here we describe an optimization approach to figure out a suitable cooling design for a 4-vane RFQ in steady state. Besides, we investigate how the accelerator responds in transient thermal analysis that could help to guide commissioning and reduce frequency detuning. Multiphysics analysis utilized with CST and ANSYS for a recently developed 176 MHz 4-vane RFQ is taken as an example. This RFQ will dissipate 211 kW when reaching an inter-vane voltage of 80 kV, which is required for an acceleration of an 80-mA proton from 65 keV to 2.5 MeV in 5.3 meters.

physics.acc-ph↗

arXiv2022

High-frequency structure design and RF stability analysis of a 4-vane radio frequency quadrupole with pi-mode stabilizer loops

Compact accelerator-based neutron source facilities are garnering attention and play an important and expanding role in material and engineering sciences, as well as in neutron science education and training. Neutrons are produced by bombarding a low-energy proton beam onto a beryllium or lithium target. In such an accelerator-based neutron source, a radio frequency quadrupole (RFQ) is usually utilized to accelerate a high-intensity proton beam to a few MeV. This study mainly covers the high-frequency structure design optimizations of a 4-vane RFQ with pi-mode stabilizer loops (PISLs) and its RF stability analysis. A 176 MHz RFQ accelerator is designed to operate at a 10% duty factor and could accelerate an 80 mA proton beam from 65 keV to 2.5 MeV within a length of 5.3 m. The adoption of PISLs ensures high RF stability, eases the operation of the accelerator, and implies less stringent alignment and machining tolerances.

physics.acc-ph↗

arXiv2011

New pixelized Micromegas detector with low discharge rate for the COMPASS experiment

New Micromegas (Micro-mesh gaseous detectors) are being developed in view of the future physics projects planned by the COMPASS collaboration at CERN. Several major upgrades compared to present detectors are being studied: detectors standing five times higher luminosity with hadron beams, detection of beam particles (flux up to a few hundred of kHz/mm^{2}, 10 times larger than for the present Micromegas detectors) with pixelized read-out in the central part, light and integrated electronics, and improved robustness. Two solutions of reduction of discharge impact have been studied, with Micromegas detectors using resistive layers and using an additional GEM foil. Performance of such detectors has also been measured. A large size prototypes with nominal active area and pixelized read-out has been produced and installed at COMPASS in 2010. In 2011 prototypes featuring an additional GEM foil, as well as an resistive prototype, are installed at COMPASS and preliminary results from those detectors presented very good performance. We present here the project and report on its status, in particular the performance of large size prototypes with an additional GEM foil.

physics.ins-det↗

arXiv2009

New pixelized Micromegas detector for the COMPASS experiment

New Micromegas (Micro-mesh gaseous detectors) are being developed in view of the future physics projects planned by the COMPASS collaboration at CERN. Several major upgrades compared to present detectors are being studied: detectors standing five times higher luminosity with hadron beams, detection of beam particles (flux up to a few hundred of kHz/mm^2, 10 times larger than for the present detectors) with pixelized read-out in the central part, light and integrated electronics, and improved robustness. Studies were done with the present detectors moved in the beam, and two first pixelized prototypes are being tested with muon and hadron beams in real conditions at COMPASS. We present here this new project and report on two series of tests, with old detectors moved into the beam and with pixelized prototypes operated in real data taking condition with both muon and hadron beams.

physics.ins-det↗