arXiv subjects

Claude Samson

Publications and source records attributed to Claude Samson.

9 recordsLinked to original sources

arXiv2025

A Simple Algebraic Solution for Estimating the Pose of a Camera from Planar Point Features

This paper presents a simple algebraic method to estimate the pose of a camera relative to a planar target from $n \geq 4$ reference points with known coordinates in the target frame and their corresponding bearing measurements in the camera frame. The proposed approach follows a hierarchical structure; first, the unit vector normal to the target plane is determined, followed by the camera's position vector, its distance to the target plane, and finally, the full orientation. To improve the method's robustness to measurement noise, an averaging methodology is introduced to refine the estimation of the target's normal direction. The accuracy and robustness of the approach are validated through extensive experiments.

cs.CV↗

arXiv2023

Control of convertible UAV with vectorized thrust

This paper is an addition to an article previously published by three of the authors that addresses the control of convertible fixed-wing aircraft with vectorized thrust. The control solution here developed extends the one presented in the former paper by complementing it with a strategy for the hovering flight and a control policy to handle the transition phase between low and high airspeed. An estimator of the air velocity required in all flight phases is also proposed. Realistic simulation results on a tri-tilt rotor Unmanned Aerial Vehicle (UAV) illustrate and assess the methodology.

eess.SY↗

arXiv2020

Correction to:"Position estimation from direction or range measurements"

This technical communiqu\'e aims at correcting an erroneous statement (Lemma 2.4) in an earlier paper by the same authors concerning a sufficient condition of uniform observability for a Linear Time-Varying (LTV) system. In this earlier paper, the proofs of two other lemmas, about body-pose estimation from range measurements, relied on this erroneous statement. For the sake of conciseness, only a new proof of one of these lemmas is presented, the proof of the second lemma being a simpler version of it.

eess.SY↗

arXiv2017

Riccati observers for velocity-aided attitude estimation of accelerated vehicles using coupled velocity measurements

Motivated by drone autonomous navigation applications we address a novel problem of velocity-aided attitude estimation by combining two linear velocity components measured in a body-fixed frame and a linear velocity component measured in an inertial frame with the measurements of an Inertial Measurement Unit (IMU). The main contributions of the present paper are the design of Riccati nonlinear observers, which may be viewed as deterministic versions of an Extended Kalman filter (EKF), and an analysis of observability conditions under which local exponential stability of the observer is achieved. Reported simulation results further indicate that the observers' domain of convergence is large.

math.OC↗

arXiv2016

Riccati observers for position and velocity bias estimation from either direction or range measurements

This paper revisits the problems of estimating the position of an object moving in $n$ ($\geq 2$)-dimensional Euclidean space using velocity measurements and either direction or range measurements of one or multiple source points. The proposed solutions exploit the Continuous Riccati Equation (CRE) to calculate observer gains yielding global exponential stability of zero estimation errors, even in the case where the measured velocity is biased by an unknown constant perturbation. These results are obtained under persistent excitation (p.e.) conditions depending on the number of source points and body motion that ensure both uniform observability and good conditioning of the CRE solutions. With respect to prior contributions on these subjects some of the proposed solutions are entirely novel while others are adapted from existing ones with the preoccupation of stating simpler and more explicit conditions under which uniform exponential stability is achieved. A complementary contribution, related to the delicate tuning of the observers gains, is the derivation of a lower-bound of the exponential rate of convergence specified as a function of the amount of persistent excitation. Simulation results illustrate the performance of the proposed observers.

eess.SY↗

arXiv2015

Observer design for position and velocity bias estimation from a single direction output

This paper addresses the problem of estimating the position of an object moving in $R^n$ from direction and velocity measurements. After addressing observability issues associated with this problem, a nonlinear observer is designed so as to encompass the case where the measured velocity is corrupted by a constant bias. Global exponential convergence of the estimation error is proved under a condition of persistent excitation upon the direction measurements. Simulation results illustrate the performance of the observer.

eess.SY↗

arXiv2014

Nonlinear Feedback Control of Axisymmetric Aerial Vehicles

We investigate the use of simple aerodynamic models for the feedback control of aerial vehicles with large flight envelopes. Thrust-propelled vehicles with a body shape symmetric with respect to the thrust axis are considered. Upon a condition on the aerodynamic characteristics of the vehicle, we show that the equilibrium orientation can be explicitly determined as a function of the desired flight velocity. This allows for the adaptation of previously proposed control design approaches based on the thrust direction control paradigm. Simulation results conducted by using measured aerodynamic characteristics of quasi-axisymmetric bodies illustrate the soundness of the proposed approach.

eess.SY↗

arXiv2013

Control of VTOL Vehicles with Thrust-direction Tilting

An approach to the control of a VTOL vehicle equipped with complementary thrust-direction tilting capabilities that nominally yield full actuation of the vehicle's position and attitude is developed. The particularity and difficulty of the control problem are epitomized by the existence of a maximal thrust-tilting angle which forbids complete and decoupled control of the vehicle's position and attitude in all situations. This problem is here addressed via the formalism of primary and secondary objectives and by extending a solution previously derived in the fixed thrust-direction case. The proposed control design is also illustrated by simulation results involving a quadrotor UAV with all propellers axes pointing in the same monitored tilted direction.

math.OC↗

arXiv2012

Modeling for Control of Symmetric Aerial Vehicles Subjected to Aerodynamic Forces

This paper participates in the development of a unified approach to the control of aerial vehicles with extended flight envelopes. More precisely, modeling for control purposes of a class of thrust-propelled aerial vehicles subjected to lift and drag aerodynamic forces is addressed assuming a rotational symmetry of the vehicle's shape about the thrust force axis. A condition upon aerodynamic characteristics that allows one to recast the control problem into the simpler case of a spherical vehicle is pointed out. Beside showing how to adapt nonlinear controllers developed for this latter case, the paper extends a previous work by the authors in two directions. First, the 3D case is addressed whereas only motions in a single vertical plane was considered. Secondly, the family of models of aerodynamic forces for which the aforementioned transformation holds is enlarged.

eess.SY↗