arXiv subjects

Conor M. Mow-Lowry

Publications and source records attributed to Conor M. Mow-Lowry.

9 recordsLinked to original sources

arXiv2025

Non-Smooth Multi-objective Controller Synthesis for Test-Mass Actuation in Gravitational-Wave Detectors

This paper proposes a non-smooth controller optimization method and shows the results of ongoing research on the implementation of this method for gravitational wave applications. Typical performance requirements concerning these type of suspensions are defined in terms of both H2- and Hinf-type constraints. A non-smooth optimization approach is investigated, which allows the use of non-convex cost functions that are often a result of mixed H2/Hinf optimization problems. Besides the controller, the distribution of the actuation is integrated with the optimization to investigate the feasibility of simultaneous controller and actuator optimization. The results demonstrate that the proposed non-smooth optimization method is able to find suitable solutions for the control and actuator distribution that satisfy all required performance and design constraints.

astro-ph.IM↗

arXiv2024

Angular control noise in Advanced Virgo and implications for the Einstein Telescope

With significantly improved sensitivity, the Einstein Telescope (ET), along with other upcoming gravitational wave detectors, will mark the beginning of precision gravitational wave astronomy. However, the pursuit of surpassing current detector capabilities requires careful consideration of technical constraints inherent in existing designs. The significant improvement of ET lies in the low-frequency range, where it anticipates a one million-fold increase in sensitivity compared to current detectors. Angular control noise is a primary limitation for LIGO detectors in this frequency range, originating from the need to maintain optical alignment. Given the expected improvements in ET's low-frequency range, precise assessment of angular control noise becomes crucial for achieving target sensitivity. To address this, we developed a model of the angular control system of Advanced Virgo, closely matching experimental data and providing a robust foundation for modeling future-generation detectors. Our model, for the first time, enables replication of the measured coupling level between angle and length. Additionally, our findings confirm that Virgo, unlike LIGO, is not constrained by alignment control noise, even if the detector were operating at full power.

astro-ph.IM↗

arXiv2022

Metasurface Enhanced Spatial Mode Decomposition

Acquiring precise information about the mode content of a laser is critical for multiplexed optical communications, optical imaging with active wave-front control, and quantum-limited interferometric measurements. Hologram-based mode decomposition devices, such as spatial light modulators, allow a fast, direct measurement of the mode content, but they have limited precision due to cross-coupling between modes. Here we report the first proof-of-principle demonstration of mode decomposition with a metasurface, resulting in significantly enhanced precision. A mode-weight fluctuation of $6\times 10^{-7}$ was be measured with 1 second of averaging at a Fourier frequency of 80 Hz, an improvement of more than three orders of magnitude compared to the state-of-the-art spatial light modulator decomposition. The improvement is attributable to the reduction in cross-coupling enabled by the exceptional small pixel size of the metasurface. We show a systematic study of the limiting sources of noise, and we show that there is a promising path towards complete mode decomposition with similar precision.

physics.optics↗

arXiv2020

Particle swarming of sensor correction filters

Reducing the impact of seismic activity on the motion of suspended optics is essential for the operation of ground-based gravitational wave detectors. During periods of increased seismic activity, low-frequency ground translation and tilt cause the Advanced LIGO observatories to lose `lock', reducing their duty cycles. This paper applies modern global-optimisation algorithms to aid in the design of the `sensor correction' filter, used in the control of the active platforms. It is shown that a particle swarm algorithm that minimises a cost-function approximating the differential RMS velocity between platforms can produce control filters that perform better across most frequencies in the control bandwidth than those currently installed. These tests were conducted using training data from the LIGO Hanford Observatory seismic instruments and simulations of the HAM-ISI (Horizontal Access Module Internal Seismic Isolation) platforms. These results show that new methods of producing control filters are ready for use at LIGO. The filters were implemented at LIGO's Hanford Observatory, and use the resulting data to refine the cost function.

astro-ph.IM↗

arXiv2019

A 6D interferometric inertial isolation system

We present a novel inertial-isolation scheme based on six degree-of-freedom (6D) interferometric sensing of a single reference mass. It is capable of reducing inertial motion by more than two orders of magnitude at 100\,mHz compared with what is achievable with state-of-the-art seismometers. This will enable substantial improvements in the low-frequency sensitivity of gravitational-wave detectors. The scheme is inherently two-stage, the reference mass is softly suspended within the platform to be isolated, which is itself suspended from the ground. The platform is held constant relative to the reference mass and this closed-loop control effectively transfers the low acceleration-noise of the reference mass to the platform. A high loop gain also reduces non-linear couplings and dynamic range requirements in the soft-suspension mechanics and the interferometric sensing.

astro-ph.IM↗

arXiv2018

A Review of Compact Interferometers

Compact interferometers, called phasemeters, make it possible to operate over a large range while ensuring a high resolution. Such performance is required for the stabilization of large instruments dedicated to experimental physics such as gravitational wave detectors. This paper aims at presenting the working principle of the different types of phasemeters developed in the literature. These devices can be classified into two categories: homodyne and heterodyne interferometers. Improvement of resolution and accuracy has been studied for both devices. Resolution is related to the noise sources that are added to the signal. Accuracy corresponds to distortion of the phase measured with respect to the real phase, called non-linearity. The solutions proposed to improve the device resolution and accuracy are discussed based on a comparison of the reached resolutions and of the residual non-linearities.

astro-ph.IM↗

arXiv2018

Feasibility of near-unstable cavities for future gravitational wave detectors

Near-unstable cavities have been proposed as an enabling technology for future gravitational wave detectors, as their compact structure and large beam spots can reduce the coating thermal noise of the interferometer. We present a tabletop experiment investigating the behaviour of an optical cavity as it is parametrically pushed to geometrical instability. We report on the observed degeneracies of the cavity's eigenmodes as the cavity becomes unstable and the resonance conditions become hyper-sensitive to mirror surface imperfections. A simple model of the cavity and precise measurements of the resonant frequencies allow us to characterize the stability of the cavity and give an estimate of the mirror astigmatism. The significance of these results for gravitational wave detectors is discussed, and avenues for further research are suggested.

astro-ph.IM↗

arXiv2017

Thermal modelling of Advanced LIGO test masses

High-reflectivity fused silica mirrors are at the epicentre of current advanced gravitational wave detectors. In these detectors, the mirrors interact with high power laser beams. As a result of finite absorption in the high reflectivity coatings the mirrors suffer from a variety of thermal effects that impact on the detectors performance. We propose a model of the Advanced LIGO mirrors that introduces an empirical term to account for the radiative heat transfer between the mirror and its surroundings. The mechanical mode frequency is used as a probe for the overall temperature of the mirror. The thermal transient after power build-up in the optical cavities is used to refine and test the model. The model provides a coating absorption estimate of 1.5 to 2.0 ppm and estimates that 0.3 to 1.3 ppm of the circulating light is scattered on to the ring heater.

astro-ph.IM↗

arXiv2015

Thermal noise of gram-scale cantilever flexures

We present measurements of thermal noise in niobium and aluminium flexures. Our measurements cover the audio frequency band from 10Hz to 10kHz, which is of particular relevance to ground-based interferometric gravitational wave detectors, and span up to an order of magnitude above and below the fundamental flexure resonances at 50Hz - 300Hz. Our results are well-explained by a simple model in which both structural and thermoelastic loss play a role. The ability of such a model to explain this interplay is important for investigations of quantum-radiation-pressure noise and the standard quantum limit.

physics.ins-det↗