SearcharxivSearch

arXiv subjects

D. A. Shaddock

Publications and source records attributed to D. A. Shaddock.

4 recordsLinked to original sources

Early Earthquake Detection with a Dual Torsion-Beam Gravimeter

Ground mass is redistributed during an earthquake causing the local gravitational potential to change. These gravitational fluctuations travel at the speed of light meaning they will arrive at a remote location significantly earlier than the fastest seismic waves. If these gravitational signals are measured by a gravimeter then early warning can be provided for an imminent earthquake. Earlier detection of earthquakes could be used to protect crucial infrastructure and save lives. The Torsion Pendulum Dual Oscillator (TorPeDO) is a gravity gradient sensor that has been constructed at the Australian National University. In this article we investigate the feasibility of measuring prompt gravitational transients from earthquakes with the TorPeDO. We simulated the response of the sensor to these signals and inserted these responses into scaled TorPeDO strain data to test their detection using a matched filter search. This simulation allows us to estimate the signal-to-noise ratio and detection time of the sensor to these transient signals, along with the influence of different detection thresholds on range and detection time. This article also proposes a method of earthquake localisation using TorPeDO sensors without the need for accurate signal timing. A real-time estimate of earthquake magnitude can be produced by combining this calculated location with TorPeDO strain data. We find that a TorPeDO system operating at design sensitivity would measure a moment magnitude 7.1 earthquake, 200~km away, reaching a signal-to-noise ratio of 5 at 15.7~s after the event starts. This will provide roughly 50.96~s of warning before the arrival of the first S waves.

physics.ins-det

Impact of backscattered light in a squeezing-enhanced interferometric gravitational-wave detector

Squeezed states of light have been recently used to improve the sensitivity of laser interferometric gravitational-wave detectors beyond the quantum limit. To completely establish quantum engineering as a realistic option for the next generation of detectors, it is crucial to study and quantify the noise coupling mechanisms which injection of squeezed states could potentially introduce. We present a direct measurement of the impact of backscattered light from a squeezed-light source deployed on one of the 4 km long detectors of the Laser Interferometric Gravitational Wave Observatory (LIGO). We also show how our measurements inform the design of squeezed light sources compatible with the even more sensitive advanced detectors currently under construction, such as Advanced LIGO.

quant-ph

Balanced Homodyne Detection of Optical Quantum States at Audio-Band Frequencies and Below

The advent of stable, highly squeezed states of light has generated great interest in the gravitational wave community as a means for improving the quantumnoise- limited performance of advanced interferometric detectors. To confidently measure these squeezed states, it is first necessary to measure the shot-noise across the frequency band of interest. Technical noise, such as non-stationary events, beam pointing, and parasitic interference, can corrupt shot-noise measurements at low Fourier frequencies, below tens of kilo-Hertz. In this paper we present a qualitative investigation into all of the relevant noise sources and the methods by which they can be identified and mitigated in order to achieve quantum noise limited balanced homodyne detection. Using these techniques, flat shot-noise down to Fourier frequencies below 0.5 Hz is produced. This enables the direct observation of large magnitudes of squeezing across the entire audio-band, of particular interest for ground-based interferometric gravitational wave detectors. 11.6 dB of shot-noise suppression is directly observed, with more than 10 dB down to 10 Hz.

quant-ph

Post-processed time-delay interferometry for LISA

High-precision interpolation of LISA phase measurements allows signal reconstruction and formulation of Time-Delay Interferometry (TDI) combinations to be conducted in post-processing. The reconstruction is based on phase measurements made at approximately 10 Hz, at regular intervals independent of the TDI delay times. Interpolation introduces an error less than 1e-8 with continuous data segments as short as two seconds in duration. Potential simplifications in the design and operation of LISA are presented.

gr-qc