arXiv subjects

D. Ceresoli

Publications and source records attributed to D. Ceresoli.

21 records · Page 2Linked to original sources

arXiv2005

Why Are Alkali Halide Solid Surfaces Not Wetted By Their Own Melt?

Alkali halide (100) crystal surfaces are anomalous, being very poorly wetted by their own melt at the triple point. We present extensive simulations for NaCl, followed by calculations of the solid-vapor, solid-liquid, and liquid-vapor free energies showing that solid NaCl(100) is a nonmelting surface, and that its full behavior can quantitatively be accounted for within a simple Born-Meyer-Huggins-Fumi-Tosi model potential. The incomplete wetting is traced to the conspiracy of three factors: surface anharmonicities stabilizing the solid surface; a large density jump causing bad liquid-solid adhesion; incipient NaCl molecular correlations destabilizing the liquid surface. The latter is pursued in detail, and it is shown that surface short-range charge order acts to raise the surface tension because incipient NaCl molecular formation anomalously reduces the surface entropy of liquid NaCl much below that of solid NaCl(100).

cond-mat.other↗

arXiv2005

Exciton self-trapping in bulk polyethylene

We studied theoretically the behavior of an injected electron-hole pair in crystalline polyethylene. Time-dependent adiabatic evolution by ab-initio molecular dynamics simulations show that the pair will become self-trapped in the perfect crystal, with a trapping energy of about 0.38 eV, with formation of a pair of trans-gauche conformational defects, three C$_2$H$_4$ units apart on the same chain. The electron is confined in the inter-chain pocket created by a local, 120$^\circ$ rotation of the chain between the two defects, while the hole resides on the chain and is much less bound. Despite the large energy stored in the trapped excitation, there does not appear to be a direct non-radiative channel for electron-hole recombination. This suggests that intrinsic self-trapping of electron-hole pairs inside the ideal quasi-crystalline fraction of PE might not be directly relevant for electrical damage in high-voltage cables.

cond-mat.mtrl-sci↗

arXiv2004

NaCl nanodroplet on NaCl(100) at the melting point

The self-wetting properties of ionic crystal surfaces are studied, using NaCl(100) as a prototype case. The anomalously large contact angle measured long ago by Mutaftschiev is well reproduced by realistic molecular dynamics simulations. Based on these results, and on independent determinations of the liquid-vapor and the solid-vapor interface free energy, an estimate of the solid-liquid interface free energy is extracted. The solid-vapor surface free energy turns out to be small and similar to the liquid-vapor one, providing a direct thermodynamic explanation of the reduced wetting ability of the ionic melt.

cond-mat.mtrl-sci↗