arXiv subjects

D. Kovačević

Publications and source records attributed to D. Kovačević.

3 recordsLinked to original sources

arXiv2025

A viscoplasticity model with an invariant-based non-Newtonian flow rule for unidirectional thermoplastic composites

A three-dimensional mesoscopic viscoplasticity model for simulating rate-dependent plasticity and creep in unidirectional thermoplastic composites is presented. The constitutive model is a transversely isotropic extension of an isotropic finite strain viscoplasticity model for neat polymers. Rate-dependent plasticity and creep are described by a non-Newtonian flow rule where the viscosity of the material depends on an equivalent stress measure through an Eyring-type relation. In the present formulation, transverse isotropy is incorporated by defining the equivalent stress measure and flow rule as functions of transversely isotropic stress invariants. In addition, the Eyring-type viscosity function is extended with anisotropic pressure dependence. As a result of the formulation, plastic flow in fiber direction is effectively excluded and pressure dependence of the polymer matrix is accounted for. The re-orientation of the transversely isotropic plane during plastic deformations is incorporated in the constitutive equations, allowing for an accurate large deformation response. The formulation is fully implicit and a consistent linearization of the algorithmic constitutive equations is performed to derive the consistent tangent modulus. The performance of the mesoscopic constitutive model is assessed through a comparison with a micromechanical model for carbon/PEEK, with the original isotropic viscoplastic version for the polymer matrix and with hyperelastic fibers. The micromodel is first used to determine the material parameters of the mesoscale model with a few stress-strain curves. It is demonstrated that the mesoscale model gives a similar response to the micromodel under various loading conditions. Finally, the mesoscale model is validated against off-axis experiments on unidirectional thermoplastic composite plies.

cs.CE↗

arXiv2025

Surrogate-based multiscale analysis of experiments on thermoplastic composites under off-axis loading

In this paper, we present a surrogate-based multiscale approach to model constant strain-rate and creep experiments on unidirectional thermoplastic composites under off-axis loading. In previous contributions, these experiments were modeled through a single-scale micromechanical simulation under the assumption of macroscopic homogeneity. Although efficient and accurate in many scenarios, simulations with low-off axis angles showed significant discrepancies with the experiments. It was hypothesized that the mismatch was caused by macroscopic inhomogeneity, which would require a multiscale approach to capture it. However, full-field multiscale simulations remain computationally prohibitive. To address this issue, we replace the micromodel with a Physically Recurrent Neural Network (PRNN), a surrogate model that combines data-driven components with embedded constitutive models to capture history-dependent behavior naturally. The explainability of the latent space of this network is also explored in a transfer learning strategy that requires no re-training. With the surrogate-based simulations, we confirm the hypothesis raised on the inhomogeneity of the macroscopic strain field and gain insights into the influence of adjustment of the experimental setup with oblique end-tabs. Results from the surrogate-based multiscale approach show better agreement with experiments than the single-scale micromechanical approach over a wide range of settings, although with limited accuracy on the creep experiments, where macroscopic test effects were implicitly taken into account in the material properties calibration.

math.NA↗

arXiv2024

Physically recurrent neural network for rate and path-dependent heterogeneous materials in a finite strain framework

In this work, a hybrid physics-based data-driven surrogate model for the microscale analysis of heterogeneous material is investigated. The proposed model benefits from the physics-based knowledge contained in the constitutive models used in the full-order micromodel by embedding them in a neural network. Following previous developments, this paper extends the applicability of the physically recurrent neural network (PRNN) by introducing an architecture suitable for rate-dependent materials in a finite strain framework. In this model, the homogenized deformation gradient of the micromodel is encoded into a set of deformation gradients serving as input to the embedded constitutive models. These constitutive models compute stresses, which are combined in a decoder to predict the homogenized stress, such that the internal variables of the history-dependent constitutive models naturally provide physics-based memory for the network. To demonstrate the capabilities of the surrogate model, we consider a unidirectional composite micromodel with transversely isotropic elastic fibers and elasto-viscoplastic matrix material. The extrapolation properties of the surrogate model trained to replace such micromodel are tested on loading scenarios unseen during training, ranging from different strain-rates to cyclic loading and relaxation. Speed-ups of three orders of magnitude with respect to the runtime of the original micromodel are obtained.

cond-mat.mtrl-sci↗