arXiv subjects

D. Lamoen

Publications and source records attributed to D. Lamoen.

6 recordsLinked to original sources

arXiv2021

First-principles study of defects at $\Sigma3$ grain boundaries in CuGaSe$_2$

We present a first-principles computational study of cation-Se $Σ$3 (112) grain boundaries in CuGaSe$_2$. We discuss the structure of these grain boundaries, as well as the effect of native defects and Na impurities on their electronic properties. The formation energies show that the defects will tend to form preferentially at the grain boundaries, rather than in the grain interiors. We find that in Ga-rich growth conditions Cu vacancies as well as Ga at Cu and Cu at Ga antisites are mainly responsible for having the equilibrium Fermi level pinned toward the middle of the gap, resulting in carrier depletion. The Na at Cu impurity in its +1 charge state contributes to this. In Ga-poor growth conditions, on the other hand, the formation energies of Cu vacancies and Ga at Cu antisites are comparatively too high for any significant influence on carrier density or on the equilibrium Fermi level position. Thus, under these conditions, the Cu at Ga antisites give rise to a $p$-type grain boundary. Also, their formation energy is lower than the formation energy of Na at Cu impurities. Thus, the latter will fail to act as a hole barrier preventing recombination at the grain boundary, in contrast to what occurs in CuInSe$_2$ grain boundaries. We also discuss the effect of the defects on the electronic properties of bulk CuGaSe$_2$, which we assume reflect the properties of the grain interiors.

cond-mat.mtrl-sci↗

arXiv2018

First-principles study of CO and OH adsorption on In-doped ZnO surfaces

We present a first-principles computational study of non-polar ZnO (10$\bar{1}$0) surfaces doped with indium. The calculations were performed using a model ZnO slab. The position of the In dopants was varied from deep bulk-like layers to the surface layers. It was established that the preferential location of the In atoms is at the surface by examining the dependence of the defect formation energy as well as the surface energy on In location. The adsorption sites on the surface of ZnO and the energy of adsorption of CO molecules and OH-species were determined in connection to In doping. It was found that OH has higher bonding energy to the surface than CO. The presence of In atoms at the surface of ZnO is favorable for CO adsorption, resulting in an elongation of the C-O bond and in charge transfer to the surface. The effect of CO and OH adsorption on the electronic and conduction properties of surfaces was assessed. We conclude that In-doped ZnO surfaces should present a higher electronic response upon adsorption of CO.

cond-mat.mtrl-sci↗

arXiv2015

Extension of the basis set of linearized augmented plane wave method (LAPW) by using supplemented tight binding basis functions

In order to increase the accuracy of the linearized augmented plane wave method (LAPW) we present a new approach where the plane wave basis function is augmented by two different atomic radial components constructed at two different linearization energies corresponding to two different electron bands (or energy windows). We demonstrate that this case can be reduced to the standard treatment within the LAPW paradigm where the usual basis set is enriched by the basis functions of the tight binding type, which go to zero with zero derivative at the sphere boundary. We show that the task is closely related with the problem of extended core states which is currently solved by applying the LAPW method with local orbitals (LAPW+LO). In comparison with LAPW+LO, the number of supplemented basis functions in our approach is doubled, which opens up a new channel for the extension of the LAPW and LAPW+LO basis sets. The appearance of new supplemented basis functions absent in the LAPW+LO treatment is closely related with the existence of the $\dot{u}_l-$component in the canonical LAPW method. We discuss properties of additional tight binding basis functions and apply the extended basis set for computation of electron energy bands of lanthanum (face and body centered structures) and hexagonal close packed lattice of cadmium. We demonstrate that the new treatment gives lower total energies in comparison with both canonical LAPW and LAPW+LO, with the energy difference more pronounced for intermediate and poor LAPW basis sets.

cond-mat.mtrl-sci↗

arXiv2013

Origin of magnetism and quasiparticles properties in Cr-doped TiO$_2$

Combining LSDA+$U$ and an analysis of superexchange interactions beyond DFT, we describe the magnetic ground states in rutile and anatase Cr-doped TiO$_2$. In parallel, we correct our LSDA+$U$ ground state through GW corrections ($GW$@LSDA+$U$) that reproduce the position of impurity states and the band gaps in satisfying agreement with experiments. Because of the different topological coordinations of Cr-Cr bonds in the ground states of rutile and anatase, superexchange interactions induce either ferromagnetic or antiferromagnetic couplings of Cr ions. In Cr-doped anatase, this interaction leads to a new mechanism which stabilizes a ferromagnetic ground state, in keeping with experimental evidence, without the need to invoke F-center exchange.

cond-mat.str-el↗

arXiv2003

A new technique for the sp$^2$/sp$^3$ characterisation of carbon materials

We present a technique to determine the sp$^3$/sp$^2$ ratio of carbon materials which is based on the electron energy-loss spectroscopy and which uses the theoretical spectrum of graphite obtained from ab initio electronic structure calculations. The method relies on the separation of the $π^*$ and $σ^*$ components of the carbon K-edge of graphite. This $π^*$ spectrum is adopted and assumed to be transferable to other carbon systems given an appropriate parametrisation of the broadening. The method is applied on a series of Monte-Carlo generated amorphous carbon structures and is shown to be stable over a wide range of the energy windows for which spectral integration is performed. The results are found to be in good agreement with the sp$^3$ fraction obtained from a microscopic scheme which uses the $π-$orbital axis vector (POAV1) analysis. The technique was also applied on a series of experimental spectra of amorphous carbon and was found to be in good agreement with the results obtained from a functional fitting approach.

cond-mat↗

arXiv2003

Density functional theory calculations of the carbon ELNES of small diameter armchair and zigzag nanotubes: core-hole, curvature and momentum transfer orientation effects

We perform density functional theory calculations on a series of armchair and zigzag nanotubes of diameters less than 1nm using the all-electron Full-Potential(-Linearised)-Augmented-Plane-Wave (FPLAPW) method. Emphasis is laid on the effects of curvature, the electron beam orientation and the inclusion of the core-hole on the carbon electron energy loss K-edge. The electron energy loss near-edge spectra of all the studied tubes show strong curvature effects compared to that of flat graphene. The curvature induced $π-σ$ hybridisation is shown to have a more drastic effect on the electronic properties of zigzag tubes than on those of armchair tubes. We show that the core-hole effect must be accounted for in order to correctly reproduce electron energy loss measurements. We also find that, the energy loss near edge spectra of these carbon systems are dominantly dipole selected and that they can be expressed simply as a proportionality with the local momentum projected density of states, thus portraying the weak energy dependence of the transition matrix elements. Compared to graphite, the ELNES of carbon nanotubes show a reduced anisotropy.

cond-mat↗