arXiv subjects

D. Y. Lee

Publications and source records attributed to D. Y. Lee.

6 recordsLinked to original sources

arXiv2026

LiFE-SNS: LiF Experiment for keV-scale Sterile Neutrino Search

The LiF Experiment for keV-scale Sterile Neutrino Search (LiFE-SNS) aims to probe sterile neutrinos through precision measurements of the tritium $β$ spectrum. Tritium nuclei are produced and embedded in LiF crystals via the ${}^{6}\mathrm{Li}(n,α){}^{3}\mathrm{H}$ reaction, allowing thermal calorimetric detection of $β$ decays with magnetic microcalorimeters (MMCs) operated at millikelvin temperatures. We present the detector configuration, background studies, and calibration method, including modeling of position-dependent response and characterization of detector nonlinearity. We also discuss potential sources of systematic uncertainty relevant to the sterile-neutrino search. While the first phase of LiFE-SNS has been completed, this paper focuses on calibration and detector characterization. The achieved performance enables precision $β$-spectrum measurements, and projected sensitivities indicate competitive reach in the keV mass region.

hep-ex↗

arXiv2025

Development of MMC-based lithium molybdate cryogenic calorimeters for AMoRE-II

The AMoRE collaboration searches for neutrinoless double beta decay of $^{100}$Mo using molybdate scintillating crystals via low temperature thermal calorimetric detection. The early phases of the experiment, AMoRE-pilot and AMoRE-I, have demonstrated competitive discovery potential. Presently, the AMoRE-II experiment, featuring a large detector array with about 90 kg of $^{100}$Mo isotope, is under construction. This paper discusses the baseline design and characterization of the lithium molybdate cryogenic calorimeters to be used in the AMoRE-II detector modules. The results from prototype setups that incorporate new housing structures and two different crystal masses (316 g and 517 - 521 g), operated at 10 mK temperature, show energy resolutions (FWHM) of 7.55 - 8.82 keV at the 2.615 MeV $^{208}$Tl $γ$ line, and effective light detection of 0.79 - 0.96 keV/MeV. The simultaneous heat and light detection enables clear separation of alpha particles with a discrimination power of 12.37 - 19.50 at the energy region around $^6$Li(n, $α$)$^3$H with Q-value = 4.785 MeV. Promising detector performances were demonstrated at temperatures as high as 30 mK, which relaxes the temperature constraints for operating the large AMoRE-II array.

physics.ins-det↗

arXiv2024

Development of decay energy spectroscopy for radio impurity analysis

We present the development of a decay energy spectroscopy (DES) method for the analysis of radioactive impurities using magnetic microcalorimeters (MMCs). The DES system was designed to analyze radionuclides, such as Ra-226, Th-228, and their daughter nuclides, in materials like copper, commonly used in rare-event search experiments. We tested the DES system with a gold foil absorber measuring 20x20x0.05 mm^3, large enough to accommodate a significant drop of source solution. Using this large absorber and an MMC sensor, we conducted a long-term measurement over ten days of live time, requiring 11 ADR cooling cycles. The combined spectrum achieved an energy resolution of 45 keV FWHM, sufficient to identify most alpha and DES peaks of interest. Specific decay events from radionuclide contaminants in the absorber were identified. This experiment confirms the capability of the DES system to measure alpha decay chains of Ra-226 and Th-228, offering a promising method for radio-impurity evaluation in ultra-low background experiments.

physics.ins-det↗

arXiv2024

Projected background and sensitivity of AMoRE-II

AMoRE-II aims to search for neutrinoless double beta decay with an array of 423 Li$_2$$^{100}$MoO$_4$ crystals operating in the cryogenic system as the main phase of the Advanced Molybdenum-based Rare process Experiment (AMoRE). AMoRE has been planned to operate in three phases: AMoRE-pilot, AMoRE-I, and AMoRE-II. AMoRE-II is currently being installed at the Yemi Underground Laboratory, located approximately 1000 meters deep in Jeongseon, Korea. The goal of AMoRE-II is to reach up to $T^{0νββ}_{1/2}$ $\sim$ 6 $\times$ 10$^{26}$ years, corresponding to an effective Majorana mass of 15 - 29 meV, covering all the inverted mass hierarchy regions. To achieve this, the background level of the experimental configurations and possible background sources of gamma and beta events should be well understood. We have intensively performed Monte Carlo simulations using the GEANT4 toolkit in all the experimental configurations with potential sources. We report the estimated background level that meets the 10$^{-4}$counts/(keV$\cdot$kg$\cdot$yr) requirement for AMoRE-II in the region of interest (ROI) and show the projected half-life sensitivity based on the simulation study.

physics.ins-det↗

arXiv2019

Entropy production and fluctuation theorems on complex networks

Entropy production (EP) is known as a fundamental quantity for measuring the irreversibility of processes in thermal equilibrium and states far from equilibrium. In stochastic thermodynamics, the EP becomes more visible in terms of the probability density functions of the trajectories of a particle in the state space. Inspired by a previous result that complex networks can serve as state spaces, we consider a data packet transport problem on complex networks. Entropy is produced owing to the complexity of pathways as the packet travels back and forth between two nodes. The EPs are exactly enumerated along the shortest paths between every pair of nodes, and the functional form of the EP distribution is determined by extreme value analysis. The asymptote of the accumulated EP distribution is found to follow the Gumbel distribution.

cond-mat.stat-mech↗

arXiv2014

Genetic Studies of Physiological Traits with Their Application to Sleep Apnea

Advances of modern sensing and sequencing technologies generate a deluge of high dimensional space-temporal physiological and next-generation sequencing (NGS) data. Physiological traits are observed either as continuous random functions, or on a dense grid and referred to as function-valued traits. Both physiological and NGS data are highly correlated data with their inherent order, spacing, and functional nature which are ignored by traditional summary-based univariate and multivariate regression methods designed for quantitative genetic analysis of scalar trait and common variants. To capture morphological and dynamic features of the data and utilize their dependent structure, we propose a functional linear model (FLM) in which a trait curve is modeled as a response function, the genetic variation in a genomic region or gene is modeled as a functional predictor, and the genetic effects are modeled as a function of both time and genomic position (FLMF) for genetic analysis of function-valued trait with both GWAS and NGS data. By extensive simulations, we demonstrate that the FLMF has the correct type 1 error rates and much higher power to detect association than the existing methods. The FLMF is applied to sleep data from Starr County health studies where oxygen saturation were measured in 22,670 seconds on average for 833 individuals. We found 65 genes that were significantly associated with oxygen saturation functional trait with P-values ranging from 2.40E-06 to 2.53E-21. The results clearly demonstrate that the FLMF substantially outperforms the traditional genetic models with scalar trait.

q-bio.GN↗