Searcharxiv⌕ Search

arXiv subjects

Daniel Crovo

Publications and source records attributed to Daniel Crovo.

2 recordsLinked to original sources

Adaptive carrier signal synthesis for frequency-division multiplexed cryogenic detector readout

Frequency-domain multiplexing is a fundamental technology for readout of cryogenic detector arrays on a single transmission line. Synthesizing a large number of static carrier tones for resonator stimulation eventually drives the cryogenic low-noise amplifier beyond its P1dB, introducing detector signal distortion. Scaling array sizes to O(10^6) detector pixels therefore demands minimizing the total power on the transmission line by continuous tracking of the resonances, which requires the readout electronics to be capable of updating the carrier tones dynamically. This work presents an scalable FPGA-based implementation for carrier signal synthesis based on a numerically controlled oscillator and a polyphase filter bank, enabling real-time frequency adaptivity as well as frequency resolution of 4 mHz to precisely tune the operating point, while simultaneously reducing resource usage compared to the current memory-based implementation.

physics.ins-det↗

CryoDE: a Digital Cryogenic Detector Emulator for Microwave SQUID Multiplexed Systems

Simultaneous readout of large-scale cryogenic detector arrays relies on multiplexing schemes such as the FDM (Frequency-Division Multiplexing) with microwave SQUID multiplexers and highly customized readout electronics. In traditional detector systems, where mixed-signal ASICs are used in detector front-ends and typically provide a digital interface, HIL (Hardware-in-the-Loop) testing can be readily implemented by reusing the existing digital logic of the front-end for emulation purposes. Such straightforward emulation is not possible for FDM low-temperature detectors, where the sensor signal is encoded in a high-frequency microwave carrier via a two-stage modulation scheme depending on the cryogenic resonators and the SQUID response. To address this challenge, we present CryoDE, a digital cryogenic-detector emulator for microwave SQUID multiplexed detector systems. CryoDE generates the encoded detector signals, including realistic pulse responses, enabling full HIL testing of the room-temperature DAQ system without requiring the cryogenic hardware. This resource-efficient FPGA-based detector twin integrates seamlessly into existing DAQ systems and allows experiment-specific adjustment of detector-signal parameters. We describe the internal architecture and capabilities of CryoDE within our custom HIL framework and demonstrate its use in evaluating the performance of real-time signal processing firmware optimized for different microwave SQUID multiplexed cryogenic-detector experiments.

physics.ins-det↗