arXiv subjects

Daniel Lobser

Publications and source records attributed to Daniel Lobser.

14 recordsLinked to original sources

arXiv2026

Revealing Noise in Axial Motion Through Quantum Noise Spectroscopy on a Trapped Ion Processor

Native noise processes in quantum processors are often difficult to isolate because multiple error mechanisms contribute to the same measured loss of coherence. Here we use dephasing-robust quantum noise spectroscopy to identify and characterize control noise induced by axial motion in an individually-addressed trapped-ion processor. When the ion motion is transverse to the addressing beam, thermal axial motion couples to the beam profile and produces effective amplitude control noise. We show that this noise is governed primarily by the local beam curvature and appears as a low-frequency contribution to the reconstructed control-noise spectrum. By varying the ion position within the beam profile, we separate curvature-dependent axial-motion noise from curvature-independent native control noise and extract motional parameters that are otherwise difficult to access on this platform. We also apply the protocol in parallel to a four-ion register, demonstrating a spectroscopic method for simultaneous characterization of position-dependent control noise across multiple qubits. The results of this study identify beam inflection points as operating regions that suppress axial-motion-induced noise at the cost of reduced Rabi rate, as found in PRX Quantum 3, 010334 (2022).

quant-ph↗

arXiv2026

Trigonometric Continuous-Variable Quantum Gates: Realization with Trapped Ions and Nonperturbative Wigner Negativity

We experimentally realize trigonometric continuous-variable gates on a trapped-ion processor, for which a motional mode acquires a phase proportional to the cosine of its position quadrature, and, for the first time, implement the two-mode generalization, coupling two modes through a single nonlinear phase. Such gates provide an experimentally accessible, nonpolynomial primitive for periodic interactions acting on both compact and noncompact degrees of freedom, including rotor models, sine-Gordon-type systems, and lattice gauge theories. Scanning gate strength, spatial frequency, and circuit depth, we resolve via blue-sideband spectroscopy the parity selection rule that fingerprints the exact cosine evolution, and find that an open-system model incorporating residual thermal occupation and motional dephasing reproduces the data. We then derive the asymptotics of the Wigner negativity generated by these gates and find three scaling regimes. The negativity is beyond all algebraic orders in the gate strength while the negative regions sit in far phase-space tails, becomes linear once they reach the bulk, where it saturates a first-order bound we establish, and logarithmic at strong gate strength. These results expose a general mechanism, first identified here through the cosine gate, by which every finite-order perturbative estimate of a non-Gaussian resource can vanish even though the resource itself remains nonzero. Together, our results establish trigonometric gates as controllable, experimentally realizable building blocks for bosonic quantum simulation, expanding the class of nonlinear dynamics accessible to continuous-variable quantum processors.

quant-ph↗

arXiv2024

Noise-Aware Circuit Compilations for a Continuously Parameterized Two-Qubit Gateset

State-of-the-art noisy-intermediate-scale quantum (NISQ) processors are currently implemented across a variety of hardware platforms, each with their own distinct gatesets. As such, circuit compilation should not only be aware of, but also deeply connect to, the native gateset and noise properties of each. Trapped-ion processors are one such platform that provides a gateset that can be continuously parameterized across both one- and two-qubit gates. Here we use the Quantum Scientific Computing Open User Testbed (QSCOUT) to study noise-aware compilations focused on continuously parameterized two-qubit $\mathcal{ZZ}$ gates (based on the M{\o}lmer-S{\o}rensen interaction) using $\textbf{Superstaq}$, a quantum software platform for hardware-aware circuit compiler optimizations. We discuss the realization of $\mathcal{ZZ}$ gates with arbitrary angle on the all-to-all connected trapped-ion system. Then we discuss a variety of different compiler optimizations that innately target these $\mathcal{ZZ}$ gates and their noise properties. These optimizations include moving from a restricted maximally entangling gateset to a continuously parameterized one, swap mirroring to further reduce total entangling angle of the operations, focusing the heaviest $\mathcal{ZZ}$ angle participation on the best performing gate pairs, and circuit approximation to remove the least impactful $\mathcal{ZZ}$ gates. We demonstrate these compilation approaches on the hardware with randomized quantum volume circuits, observing the potential to realize a larger quantum volume as a result of these optimizations. Using differing yet complementary analysis techniques, we observe the distinct improvements in system performance provided by these noise-aware compilations and study the role of stochastic and coherent error channels for each compilation choice.

quant-ph↗

arXiv2024

Scatter-Gather DMA Performance Analysis within an SoC-based Control System for Trapped-Ion Quantum Computing

Scatter-gather dynamic-memory-access (SG-DMA) is utilized in applications that require high bandwidth and low latency data transfers between memory and peripherals, where data blocks, described using buffer descriptors (BDs), are distributed throughout the memory system. The data transfer organization and requirements of a Trapped-Ion Quantum Computer (TIQC) possess characteristics similar to those targeted by SG-DMA. In particular, the ion qubits in a TIQC are manipulated by applying control sequences consisting primarily of modulated laser pulses. These optical pulses are defined by parameters that are (re)configured by the electrical control system. Variations in the operating environment and equipment make it necessary to create and run a wide range of control sequence permutations, which can be well represented as BD regions distributed across the main memory. In this paper, we experimentally evaluate the latency and throughput of SG-DMA on Xilinx radiofrequency SoC (RFSoC) devices under a variety of BD and payload sizes as a means of determining the benefits and limitations of an RFSoC system architecture for TIQC applications.

quant-ph↗

arXiv2023

Superstaq: Deep Optimization of Quantum Programs

We describe Superstaq, a quantum software platform that optimizes the execution of quantum programs by tailoring to underlying hardware primitives. For benchmarks such as the Bernstein-Vazirani algorithm and the Qubit Coupled Cluster chemistry method, we find that deep optimization can improve program execution performance by at least 10x compared to prevailing state-of-the-art compilers. To highlight the versatility of our approach, we present results from several hardware platforms: superconducting qubits (AQT @ LBNL, IBM Quantum, Rigetti), trapped ions (QSCOUT), and neutral atoms (Infleqtion). Across all platforms, we demonstrate new levels of performance and new capabilities that are enabled by deeper integration between quantum programs and the device physics of hardware.

quant-ph↗

arXiv2023

JaqalPaw: A Guide to Defining Pulses and Waveforms for Jaqal

One of the many challenges of developing an open user testbed such as QSCOUT is providing an interface that maintains simplicity without compromising expressibility or control. This interface comprises two distinct elements: a quantum assembly language designed for specifying quantum circuits at the gate level, and a low-level counterpart used for describing gates in terms of waveforms that realize specific quantum operations. Jaqal, or "Just another quantum assembly language," is the language used in QSCOUT for gate-level descriptions of quantum circuits. JaqalPaw, or "Jaqal pulses and waveforms," is its pulse-level counterpart. This document concerns the latter, and presents a description of the tools needed for precisely defining the underlying waveforms associated with a gate primitive.

quant-ph↗

arXiv2022

Frequency-robust M{\o}lmer-S{\o}rensen gates via balanced contributions of multiple motional modes

In this work, we design and implement frequency-robust Molmer-Sorensen gates on a linear chain of trapped ions, using Gaussian amplitude modulation and a constant laser frequency. We select this frequency to balance the entanglement accumulation of all motional modes during the gate to produce a strong robustness to frequency error, even for long ion chains. We demonstrate this technique on a three-ion chain, achieving $<\,1\%$ reduction from peak fidelity over a $20\,$kHz range of frequency offset, and we analyze the performance of this gate design through numerical simulations on chains of two to 33 ions.

quant-ph↗

arXiv2022

Design and analysis of digital communication within an SoC-based control system for trapped-ion quantum computing

Electronic control systems used for quantum computing have become increasingly complex as multiple qubit technologies employ larger numbers of qubits with higher fidelity targets. Whereas the control systems for different technologies share some similarities, parameters like pulse duration, throughput, real-time feedback, and latency requirements vary widely depending on the qubit type. In this paper, we evaluate the performance of modern System-on-Chip (SoC) architectures in meeting the control demands associated with performing quantum gates on trapped-ion qubits, particularly focusing on communication within the SoC. A principal focus of this paper is the data transfer latency and throughput of several high-speed on-chip mechanisms on Xilinx multi-processor SoCs, including those that utilize direct memory access (DMA). They are measured and evaluated to determine an upper bound on the time required to reconfigure a gate parameter. Worst-case and average-case bandwidth requirements for a custom gate sequencer core are compared with the experimental results. The lowest-variability, highest-throughput data-transfer mechanism is DMA between the real-time processing unit (RPU) and the PL, where bandwidths up to 19.2 GB/s are possible. For context, this enables reconfiguration of qubit gates in less than 2$\mu$s, comparable to the fastest gate time. Though this paper focuses on trapped-ion control systems, the gate abstraction scheme and measured communication rates are applicable to a broad range of quantum computing technologies.

quant-ph↗

arXiv2022

Performant coherent control: bridging the gap between high- and low-level operations on hardware

Scalable coherent control hardware for quantum information platforms is rapidly growing in priority as their number of available qubits continues to increase. As these systems scale, more calibration steps are needed, leading to challenges with system instability as calibrated parameters drift. Moreover, the sheer amount of data required to run circuits with large depth tends to balloon, especially when implementing state-of-the-art dynamical-decoupling gates which require advanced modulation techniques. We present a control system that addresses these challenges for trapped-ion systems, through a combination of novel features that eliminate the need for manual bookkeeping, reduction in data transfer bandwidth requirements via gate compression schemes, and other automated error handling techniques. Moreover, we describe an embedded pulse compiler that applies staged optimization, including compressed intermediate representations of parsed output products, performs in-situ mutation of compressed gate data to support high-level algorithmic feedback to account for drift, and can be run entirely on chip.

quant-ph↗

arXiv2022

Quantum Computation of Hydrogen Bond Dynamics and Vibrational Spectra

Calculating the observable properties of chemical systems is often classically intractable and is widely viewed as a promising application of quantum information processing. Yet one of the most common and important chemical systems in nature - the hydrogen bond - has remained a challenge to study using quantum hardware on account of its anharmonic potential energy landscape. Here, we introduce a framework for solving hydrogen-bond systems and more generic chemical dynamics problems using quantum logic. We experimentally demonstrate a proof-of-principle instance of our method using the QSCOUT ion-trap quantum computer, in which we experimentally drive the ion-trap system to emulate the quantum wavepacket of the shared-proton within a hydrogen bond. Following the experimental creation of the shared-proton wavepacket, we then extract measurement observables such as its time-dependent spatial projection and its characteristic vibrational frequencies to spectroscopic accuracy (3.3 cm$^{-1}$ wavenumbers, corresponding to > 99.9% fidelity). Our approach introduces a new paradigm for studying the quantum chemical dynamics and vibrational spectra of molecules, and when combined with existing algorithms for electronic structure, opens the possibility to describe the complete behavior of complex molecular systems with unprecedented accuracy.

quant-ph↗

arXiv2021

Engineering the Quantum Scientific Computing Open User Testbed (QSCOUT): Design details and user guide

The Quantum Scientific Computing Open User Testbed (QSCOUT) at Sandia National Laboratories is a trapped-ion qubit system designed to evaluate the potential of near-term quantum hardware in scientific computing applications for the US Department of Energy (DOE) and its Advanced Scientific Computing Research (ASCR) program. Similar to commercially available platforms, most of which are based on superconducting qubits, it offers quantum hardware that researchers can use to perform quantum algorithms, investigate noise properties unique to quantum systems, and test novel ideas that will be useful for larger and more powerful systems in the future. However, unlike most other quantum computing testbeds, QSCOUT uses trapped $^{171}$Yb$^{+}$ ions as the qubits, provides full connectivity between qubits, and allows both quantum circuit and low-level pulse control access to study new modes of programming and optimization. The purpose of this manuscript is to provide users and the general community with details of the QSCOUT hardware and its interface, enabling them to take maximum advantage of its capabilities.

quant-ph↗

arXiv2021

Experimental Characterization of Crosstalk Errors with Simultaneous Gate Set Tomography

Crosstalk is a leading source of failure in multiqubit quantum information processors. It can arise from a wide range of disparate physical phenomena, and can introduce subtle correlations in the errors experienced by a device. Several hardware characterization protocols are able to detect the presence of crosstalk, but few provide sufficient information to distinguish various crosstalk errors from one another. In this article we describe how gate set tomography, a protocol for detailed characterization of quantum operations, can be used to identify and characterize crosstalk errors in quantum information processors. We demonstrate our methods on a two-qubit trapped-ion processor and a two-qubit subsystem of a superconducting transmon processor.

quant-ph↗

arXiv2019

Detecting and tracking drift in quantum information processors

If quantum information processors are to fulfill their potential, the diverse errors that affect them must be understood and suppressed. But errors typically fluctuate over time, and the most widely used tools for characterizing them assume static error modes and rates. This mismatch can cause unheralded failures, misidentified error modes, and wasted experimental effort. Here, we demonstrate a spectral analysis technique for resolving time dependence in quantum processors. Our method is fast, simple, and statistically sound. It can be applied to time-series data from any quantum processor experiment. We use data from simulations and trapped-ion qubit experiments to show how our method can resolve time dependence when applied to popular characterization protocols, including randomized benchmarking, gate set tomography, and Ramsey spectroscopy. In the experiments, we detect instability and localize its source, implement drift control techniques to compensate for this instability, and then demonstrate that the instability has been suppressed.

quant-ph↗

arXiv2017

Experimental demonstration of cheap and accurate phase estimation

We demonstrate experimental implementation of robust phase estimation (RPE) to learn the phases of X and Y rotations on a trapped $\textrm{Yb}^+$ ion qubit. We estimate these phases with uncertainties less than $4\cdot10^{-4}$ radians using as few as 176 total experimental samples per phase, and our estimates exhibit Heisenberg scaling. Unlike standard phase estimation protocols, RPE neither assumes perfect state preparation and measurement, nor requires access to ancillae. We cross-validate the results of RPE with the more resource-intensive protocol of gate set tomography.

quant-ph↗