arXiv subjects

Daniel Sank

Publications and source records attributed to Daniel Sank.

29 records · Page 2Linked to original sources

arXiv2014

Compressed sensing quantum process tomography for superconducting quantum gates

We apply the method of compressed sensing (CS) quantum process tomography (QPT) to characterize quantum gates based on superconducting Xmon and phase qubits. Using experimental data for a two-qubit controlled-Z gate, we obtain an estimate for the process matrix $χ$ with reasonably high fidelity compared to full QPT, but using a significantly reduced set of initial states and measurement configurations. We show that the CS method still works when the amount of used data is so small that the standard QPT would have an underdetermined system of equations. We also apply the CS method to the analysis of the three-qubit Toffoli gate with numerically added noise, and similarly show that the method works well for a substantially reduced set of data. For the CS calculations we use two different bases in which the process matrix $χ$ is approximately sparse, and show that the resulting estimates of the process matrices match each ther with reasonably high fidelity. For both two-qubit and three-qubit gates, we characterize the quantum process by not only its process matrix and fidelity, but also by the corresponding standard deviation, defined via variation of the state fidelity for different initial states.

quant-ph↗

arXiv2014

Strong environmental coupling in a Josephson parametric amplifier

We present a lumped-element Josephson parametric amplifier designed to operate with strong coupling to the environment. In this regime, we observe broadband frequency dependent amplification with multi-peaked gain profiles. We account for this behaviour using the "pumpistor" model which allows for frequency dependent variation of the external impedance. Using this understanding, we demonstrate control over gain profiles through changes in the environment impedance at a given frequency. With strong coupling to a suitable external impedance we observe a significant increase in dynamic range, and large amplification bandwidth up to 700 MHz giving near quantum-limited performance.

cond-mat.supr-con↗

arXiv2014

Fast Scalable State Measurement with Superconducting Qubits

Progress in superconducting qubit experiments with greater numbers of qubits or advanced techniques such as feedback requires faster and more accurate state measurement. We have designed a multiplexed measurement system with a bandpass filter that allows fast measurement without increasing environmental damping of the qubits. We use this to demonstrate simultaneous measurement of four qubits on a single superconducting integrated circuit, the fastest of which can be measured to 99.8% accuracy in 140ns. This accuracy and speed is suitable for advanced multi-qubit experiments including surface code error correction.

quant-ph↗

arXiv2013

Fabrication and Characterization of Aluminum Airbridges for Superconducting Microwave Circuits

Superconducting microwave circuits based on coplanar waveguides (CPW) are susceptible to parasitic slotline modes which can lead to loss and decoherence. We motivate the use of superconducting airbridges as a reliable method for preventing the propagation of these modes. We describe the fabrication of these airbridges on superconducting resonators, which we use to measure the loss due to placing airbridges over CPW lines. We find that the additional loss at single photon levels is small, and decreases at higher drive powers.

cond-mat.mes-hall↗

arXiv2013

Design and characterization of a lumped element single-ended superconducting microwave parametric amplifier with on-chip flux bias line

We demonstrate a lumped-element Josephson parametric amplifier, using a single-ended design that includes an on-chip, high-bandwidth flux bias line. The amplifier can be pumped into its region of parametric gain through either the input port or through the flux bias line. Broadband amplification is achieved at a tunable frequency $ω/2 π$ between 5 to 7 GHz with quantum-limited noise performance, a gain-bandwidth product greater than 500 MHz, and an input saturation power in excess of -120 dBm. The bias line allows fast frequency tuning of the amplifier, with variations of hundreds of MHz over time scales shorter than 10 ns.

cond-mat.supr-con↗

arXiv2013

Sputtered TiN films for superconducting coplanar waveguide resonators

We present a systematic study of the properties of TiN films by varying the deposition conditions in an ultra-high-vacuum reactive magnetron sputtering chamber. By increasing the deposition pressure from 2 to 9 mTorr while keeping a nearly stoichiometric composition of Ti(1-x)N(x) (x=0.5), the film resistivity increases, the dominant crystal orientation changes from (100) to (111), grain boundaries become clearer, and the strong compressive strain changes to weak tensile strain. The TiN films absorb a high concentration of contaminants including hydrogen, carbon, and oxygen when they are exposed to air after deposition. With the target-substrate distance set to 88 mm the contaminant levels increase from ~0.1% to ~10% as the pressure is increased from 2 to 9 mTorr. The contaminant concentrations also correlate with in-plane distance from the center of the substrate and increase by roughly two orders of magnitude as the target-substrate distance is increased from 88 mm to 266 mm. These contaminants are found to strongly influence the properties of TiN films. For instance, the resistivity of stoichiometric films increases by around a factor of 5 as the oxygen content increases from 0.1% to 11%. These results suggest that the sputtered TiN particle energy is critical in determining the TiN film properties, and that it is important to control this energy to obtain high-quality TiN films. Superconducting coplanar waveguide resonators made from a series of nearly stoichiometric films grown at pressures from 2 mTorr to 7 mTorr show an increase in intrinsic quality factor from ~10^4 to ~10^6 as the magnitude of the compressive strain decreases from nearly 3800 MPa to approximately 150 MPa and the oxygen content increases from 0.1% to 8%. The films with a higher oxygen content exhibit lower loss, but the nonuniformity of the oxygen incorporation hinders the use of sputtered TiN in larger circuits.

cond-mat.supr-con↗

arXiv2012

Computing prime factors with a Josephson phase qubit quantum processor

A quantum processor (QuP) can be used to exploit quantum mechanics to find the prime factors of composite numbers[1]. Compiled versions of Shor's algorithm have been demonstrated on ensemble quantum systems[2] and photonic systems[3-5], however this has yet to be shown using solid state quantum bits (qubits). Two advantages of superconducting qubit architectures are the use of conventional microfabrication techniques, which allow straightforward scaling to large numbers of qubits, and a toolkit of circuit elements that can be used to engineer a variety of qubit types and interactions[6, 7]. Using a number of recent qubit control and hardware advances [7-13], here we demonstrate a nine-quantum-element solid-state QuP and show three experiments to highlight its capabilities. We begin by characterizing the device with spectroscopy. Next, we produces coherent interactions between five qubits and verify bi- and tripartite entanglement via quantum state tomography (QST) [8, 12, 14, 15]. In the final experiment, we run a three-qubit compiled version of Shor's algorithm to factor the number 15, and successfully find the prime factors 48% of the time. Improvements in the superconducting qubit coherence times and more complex circuits should provide the resources necessary to factor larger composite numbers and run more intricate quantum algorithms.

quant-ph↗

arXiv2011

Dynamic quantum Kerr effect in circuit quantum electrodynamics

A superconducting qubit coupled to a microwave resonator provides a controllable system that enables fundamental studies of light-matter interactions. In the dispersive regime, photons in the resonator exhibit induced frequency and phase shifts which are revealed in the resonator transmission spectrum measured with fixed qubit-resonator detuning. In this static detuning scheme, the phase shift is measured in the far-detuned, linear dispersion regime to avoid measurement-induced demolition of the qubit quantum state. Here we explore the qubit-resonator dispersive interaction over a much broader range of detunings, by using a dynamic procedure where the qubit transition is driven adiabatically. We use resonator Wigner tomography to monitor the interaction, revealing exotic non-linear effects on different photon states, e.g., Fock states, coherent states, and Schrodinger cat states, thereby demonstrating a quantum Kerr effect in the dynamic framework.

cond-mat.supr-con↗

arXiv2011

Surface spin fluctuations probed with flux noise and coherence in Josephson phase qubits

We measure the dependence of qubit phase coherence and surface spin induced flux noise on inductor loop geometry. While wider inductor traces change neither the flux noise power spectrum nor the qubit dephasing time, increased inductance leads to a simultaneous increase in both. Using our protocol for measuring low frequency flux noise, we make a direct comparison between the flux noise spectrum and qubit phase decay, finding agreement within 10% of theory. The dependence of the measured flux noise on inductor geometry is consistent with a noise source correlation length between 6 and 400 um.

cond-mat.mes-hall↗

arXiv2010

Reduced phase error through optimized control of a superconducting qubit

Minimizing phase and other errors in experimental quantum gates allows higher fidelity quantum processing. To quantify and correct for phase errors in particular, we have developed a new experimental metrology --- amplified phase error (APE) pulses --- that amplifies and helps identify phase errors in general multi-level qubit architectures. In order to correct for both phase and amplitude errors specific to virtual transitions and leakage outside of the qubit manifold, we implement "half derivative" an experimental simplification of derivative reduction by adiabatic gate (DRAG) control theory. The phase errors are lowered by about a factor of five using this method to $\sim 1.6^{\circ}$ per gate, and can be tuned to zero. Leakage outside the qubit manifold, to the qubit $|2\rangle$ state, is also reduced to $\sim 10^{-4}$ for $20\%$ faster gates.

quant-ph↗

arXiv2009

Quantum Process Tomography of a Universal Entangling Gate Implemented with Josephson Phase Qubits

Quantum logic gates must perform properly when operating on their standard input basis states, as well as when operating on complex superpositions of these states. Experiments using superconducting qubits have validated the truth table for particular implementations of e.g. the controlled-NOT gate [1,2], but have not fully characterized gate operation for arbitrary superpositions of input states. Here we demonstrate the use of quantum process tomography (QPT) [3,4] to fully characterize the performance of a universal entangling gate between two superconducting quantum bits. Process tomography permits complete gate analysis, but requires precise preparation of arbitrary input states, control over the subsequent qubit interaction, and simultaneous single-shot measurement of the output states. We use QPT to measure the fidelity of the entangling gate and to quantify the decoherence mechanisms affecting the gate performance. In addition to demonstrating a promising fidelity, our entangling gate has a on/off ratio of 300, a level of adjustable coupling that will become a requirement for future high-fidelity devices. This is the first solid-state demonstration of QPT in a two-qubit system, as solid-state process tomography has previously only been demonstrated with single qubits [5,6].

quant-ph↗