arXiv subjects

Daniel Schulte

Publications and source records attributed to Daniel Schulte.

At least 19 recordsLinked to original sources

arXiv2025

MuCol Milestone Report No. 7: Consolidated Parameters

This document is comprised of a collection of consolidated parameters for the key parts of the muon collider. These consolidated parameters follow on from the October 2024 Preliminary Parameters Report. Attention has been given to a high-level consistent set of baseline parameters throughout all systems of the complex, following a 10 TeV center-of-mass design. Additional details of the designs contributing to this baseline design are featured in the appendix. Likewise, explorative variations from this baseline set can be found in the appendix. The data is collected from a collaborative spreadsheet and transferred to overleaf.

physics.acc-ph↗

arXiv2025

The Compact Linear e$^+$e$^-$ Collider (CLIC)

The Compact Linear Collider (CLIC) is a TeV-scale high-luminosity linear e$^+$e$^-$ collider studied by the international CLIC and CLICdp collaborations. CLIC uses a two-beam acceleration scheme, in which normal-conducting high-gradient 12 GHz accelerating structures are powered via a high-current drive beam. CLIC is foreseen to be built and operated in stages. The initial 380 GeV stage, with a site length of 11 km, optimally combines the exploration of Higgs and top-quark physics, including a top threshold scan near 350 GeV. A higher-energy stage, still using the initial single drive-beam complex, can be optimised for any energy up to 2 TeV. Parameters are presented in detail for a 1.5 TeV stage, with a site length of 29 km. Since the 2018 ESPPU reporting, significant effort was invested in CLIC accelerator optimisation, technology developments and system tests, including collaboration with new-generation light sources and free-electron lasers. CLIC implementation aspects at CERN have covered detailed studies of civil engineering, electrical networks, cooling and ventilation, scheduling, and costing. The CLIC baseline at 380 GeV is now 100 Hz operation, with a luminosity of 4.5$\times 10^{34}$ cm$^{-2}$s$^{-1}$ and a power consumption of 166 MW. Compared to the 2018 design, this gives three times higher luminosity-per-power. The new baseline has two beam-delivery systems, allowing for two detectors operating in parallel. The cost estimate of the 380 GeV baseline is approximately 7.2 billion CHF. The construction of the first CLIC energy stage could start as early as ~2034/35 with first beams following a decade later. This report summarises the CLIC project, its implementation and running scenarios, with emphasis on new developments and recent progress. It concludes with an update on the CLIC detector studies and on the physics potential in light of the improved accelerator performance.

physics.acc-ph↗

arXiv2022

Simulated Detector Performance at the Muon Collider

In this paper we report on the current status of studies on the expected performance for a detector designed to operate in a muon collider environment. Beam-induced backgrounds (BIB) represent the main challenge in the design of the detector and the event reconstruction algorithms. The current detector design aims to show that satisfactory performance can be achieved, while further optimizations are expected to significantly improve the overall performance. We present the characterization of the expected beam-induced background, describe the detector design and software used for detailed event simulations taking into account BIB effects. The expected performance of charged-particle reconstruction, jets, electrons, photons and muons is discussed, including an initial study on heavy-flavor jet tagging. A simple method to measure the delivered luminosity is also described. Overall, the proposed design and reconstruction algorithms can successfully reconstruct the high transverse-momentum objects needed to carry out a broad physics program.

hep-ex↗

arXiv2022

Muon Collider Physics Summary

The perspective of designing muon colliders with high energy and luminosity, which is being investigated by the International Muon Collider Collaboration, has triggered a growing interest in their physics reach. We present a concise summary of the muon colliders potential to explore new physics, leveraging on the unique possibility of combining high available energy with very precise measurements.

hep-ph↗

arXiv2022

Promising Technologies and R&D Directions for the Future Muon Collider Detectors

Among the post-LHC generation of particle accelerators, the muon collider represents a unique machine with capability to provide very high energy leptonic collisions and to open the path to a vast and mostly unexplored physics programme. However, on the experimental side, such great physics potential is accompanied by unprecedented technological challenges, due to the fact that muons are unstable particles. Their decay products interact with the machine elements and produce an intense flux of background particles that eventually reach the detector and may degrade its performance. In this paper, we present technologies that have a potential to match the challenging specifications of a muon collider detector and outline a path forward for the future R&D efforts.

physics.ins-det↗

arXiv2021

$\mathrm{e}^+$$\mathrm{e}^-$ Beam-beam Parameter Study for a TeV-scale PWFA Linear Collider

We perform a beam-beam parameter study for a TeV-scale PWFA (particle-driven plasma wakefield acceleration) $\mathrm{e}^+$$\mathrm{e}^-$ linear collider using GUINEA-PIG simulations. The study shows that the total luminosity follows the $1/\sqrt{σ_z}$-scaling predicted by beamstrahlung theory, where $σ_z$ is the rms beam length, which is advantageous for PWFA, as short beam lengths are preferred. We also derive a parameter set for a 3 TeV PWFA linear collider with main beam parameters optimised for luminosity and luminosity spread introduced by beamstrahlung. Lastly, the study also compare the performance for scenarios with reduced positron beam charge at 3 TeV and 14 TeV with CLIC parameters.

physics.acc-ph↗

arXiv2020

Operator-stable-like Processes

In the present paper, we introduce so-called operator-stable-like processes. Roughly speaking, they behave locally like operator-stable processes, but they need not to be homogenous in space. Having shown existence for this class of processes, we analyze maximal estimates, the existence of moments, the short- and long-time behavior of the sample paths and $p$-variation. The class introduced here includes stable-like processes as special case.

math.PR↗

arXiv2020

$γγ$ Beam-beam Parameter Study for a 3 TeV PWFA Linear Collider

Our beam-beam parameter study using beam-beam simulations and PWFA (particle-driven plasma acceleration) beam parameters indicates that at 3 TeV, for examined electron beam lengths ${2~μ\mathrm{m}\leqσ_z\leq 10~μ\mathrm{m}}$, the total luminosity, as well as the sharpness of the luminosity spectrum for a $γγ$ collider are independent of the beam length of the electron beams used to scatter the photons, given that the hourglass effect is avoided. The total luminosity can consequently be maximised by minimising the horizontal and vertical beta functions $β_{x,y}^*$ at the interaction point. Furthermore, we performed background studies in GUINEA-PIG where we considered the smallest currently achievable $β_{x,y}^*$ combined with PWFA beam parameters. Simulations results show that our proposed parameter set for a 3 TeV PWFA $γγ$ collider is able to deliver a total luminosity significantly higher than a $γγ$ collider based on CLIC parameters, but gives rise to more background particles.

physics.acc-ph↗

arXiv2020

Muon Colliders: Opening New Horizons for Particle Physics

Particle colliders have arguably been the most important instruments for particle physics over the past 50 years. As they became more powerful, they were used to push the frontier of our knowledge into previously uncharted territory. The LHC, the highest energy collider to date, at which the Higgs boson was discovered, is a prime example. To continue along the road into the Terra Promissa beyond the Standard Model requires colliders with energy reach even greater than that of the LHC. Beams of muons offer enormous potential for the exploration of the energy frontier. Since the muon is a fundamental particle, its full energy is available in collisions in contrast to protons which are composed of quarks and gluons. However, muon beams decay rapidly, which presents a special challenge for a collider. Recent research indicates that the technologies required to overcome this challenge are within our grasp and may offer a cost-effective and energy-efficient option to continue our explorations. A new international collaboration is forming to bring together the diverse expertise and complementary capabilities from around the world to realize the muon collider as the next-generation energy-frontier discovery machine.

physics.acc-ph↗

arXiv2020

FCC-hh Experimental Insertion Region Design

The Future Circular Collider study is exploring possible designs of circular colliders for the post-LHC era, as recommended by the European Strategy Group for High Energy Physics. One such option is FCC-hh, a proton-proton collider with a centre-of-mass energy of 100 TeV. The experimental insertion regions are key areas defining the performance of the collider. This paper presents the first insertion region designs with a complete assessment of the main challenges, as collision debris with two orders of magnitude larger power than current colliders, beam-beam interactions in long insertions, dynamic aperture for optics with peak $β$ functions one order of magnitude above current colliders, photon background from synchrotron radiation and cross talk between the insertion regions. An alternative design avoiding the use of crab cavities with a small impact on performance is also presented.

physics.acc-ph↗

arXiv2020

Modeling and simulation of transverse wakefields in PWFA

A simplified model describing the PWFA (plasma wakefield acceleration) transverse instability in the form of a wake function parameterized only with an effective cavity aperture radius $a$ is benchmarked against PIC-simulations. This wake function implies a $1/a^4$ scaling of the transverse wakefields, which indicates transverse intra-beam wakefields typically several orders of magnitude higher than in conventional acceleration structures. Furthermore, the wakefield formalism is utilized to perform a parameter study for a \SI{1.5}{\tera\electronvolt} plasma wakefield accelerator, where the constraint on drive beam to main beam efficiency imposed by transverse wakefields is taken into account. Eventually, a parameter set with promising properties in terms of energy spread, stability and luminosity per power was found.

physics.acc-ph↗

arXiv2019

Traveling wave method for simulating geometric beam coupling impedance of a beamscreen with pumping holes

In particle accelerators, pumping holes in a vacuum chamber can be a source of unwanted broadband coupling impedance, leading to beam instabilities. Analytical methods have been previously developed to estimate the impedance of holes in circular-like chambers e.g. the beamscreen of the Large Hadron Collider (LHC). More sophisticated chamber designs like that of the High Energy LHC (HE-LHC) and the Future Circular Collider (FCC-hh) call for a different way to calculate the impedance. We propose using decomposition of the wakefield into synchronous traveling waves and employing a numerical solver to find the impedance of each wave. This method is compared to the direct time domain wakefield calculation method and its greater sensitivity to small impedances is shown.

physics.acc-ph↗

arXiv2019

Muon Colliders

Muon colliders have a great potential for high-energy physics. They can offer collisions of point-like particles at very high energies, since muons can be accelerated in a ring without limitation from synchrotron radiation. However, the need for high luminosity faces technical challenges which arise from the short muon lifetime at rest and the difficulty of producing large numbers of muons in bunches with small emittance. Addressing these challenges requires the development of innovative concepts and demanding technologies. The document summarizes the work done, the progress achieved and new recent ideas on muon colliders. A set of further studies and actions is also identified to advance in the field. Finally, a set of recommendations is listed in order to make the muon technology mature enough to be favourably considered as a candidate for high-energy facilities in the future.

physics.acc-ph↗

arXiv2018

Machine Parameters and Projected Luminosity Performance of Proposed Future Colliders at CERN

In response to a request from the CERN Scientific Policy Committee (SPC), the machine parameters and expected luminosity performance for several proposed post-LHC collider projects at CERN are compiled: three types of hadron colliders (HL-LHC upgrade, FCC-hh and HE-LHC), a circular lepton collider (FCC-ee), a linear lepton collider (CLIC), and three options for lepton-hadron colliders (LHeC, HE-LHeC, and FCC-eh). Particular emphasis is put on availability, physics run time, and efficiency. The information contained in this document was presented at the SPC Meeting of September 2018. It will serve as one of the inputs to the 2019/20 Update of the European Strategy for Particle Physics.

physics.acc-ph↗

arXiv2014

Impact of Detector Solenoid on the CLIC Luminosity Performance

In order to obtain the necessary luminosity with a reasonable amount of beam power, the Compact Linear Collider (CLIC) design includes an unprecedented collision beam size of σ = 1 nm vertically and σ = 45 nm horizontally. Given the small and very flat beams, the luminosity can be significantly degraded from the impact of the experimental solenoid field in combination with a large crossing angle. Main effects include y-x'-coupling and increase of vertical dispersion. Additionally, Incoherent Synchrotron Radiation (ISR) from the orbit deflection created by the solenoid field, increases the beam emittance. A detailed study of the impact from a realistic solenoid field and the associated correction techniques for the CLIC Final Focus is presented. In particular, the impact of techniques to compensate the beam optics distortions due to the detector solenoid main field and its overlap with the final focus magnets are shown. The unrecoverable luminosity loss due to ISR has been evaluated, and found to be in the range 4-5 % for the solenoid design under study.

physics.acc-ph↗

arXiv2013

Physics at the CLIC e+e- Linear Collider -- Input to the Snowmass process 2013

This paper summarizes the physics potential of the CLIC high-energy e+e- linear collider. It provides input to the Snowmass 2013 process for the energy-frontier working groups on The Higgs Boson (HE1), Precision Study of Electroweak Interactions (HE2), Fully Understanding the Top Quark (HE3), as well as The Path Beyond the Standard Model -- New Particles, Forces, and Dimensions (HE4). It is accompanied by a paper describing the CLIC accelerator study, submitted to the Frontier Capabilities group of the Snowmass process.

hep-ex↗

arXiv2013

CLIC e+e- Linear Collider Studies - Input to the Snowmass process 2013

This paper addresses the issues in question for Energy Frontier Lepton and Gamma Colliders by the Frontier Capabilities group of the Snowmass 2013 process and is structured accordingly. It will be accompanied by a paper describing the Detector and Physics studies for the CLIC project currently in preparation for submission to the Energy Frontier group.

physics.acc-ph↗

arXiv2013

Report of the ICFA Beam Dynamics Workshop 'Accelerators for a Higgs Factory: Linear vs. Circular' (HF2012)

This paper is a summary report of the ICFA Beam Dynamics Workshop 'Accelerators for a Higgs Factory: Linear vs. Circular' (HF2012). It discusses four types of accelerators as possible candidates for a Higgs factory: linear e+e- colliders, circular e+e- colliders, muon collider and photon colliders. The comparison includes: physics reach, performance (energy and luminosity), upgrade potential, technology maturity and readiness, and technical challenges requiring further R&D.

physics.acc-ph↗