arXiv subjects

Daniel Verenzuela

Publications and source records attributed to Daniel Verenzuela.

6 recordsLinked to original sources

arXiv2021

Massive-MIMO Iterative Channel Estimation and Decoding (MICED) in the Uplink

Massive MIMO uses a large number of antennas to increase the spectral efficiency (SE) through spatial multiplexing of users, which requires accurate channel state information. It is often assumed that regular pilots (RP), where a fraction of the time-frequency resources is reserved for pilots, suffices to provide high SE. However, the SE is limited by the pilot overhead and pilot contamination. An alternative is superimposed pilots (SP) where all resources are used for pilots and data. This removes the pilot overhead and reduces pilot contamination by using longer pilots. However, SP suffers from data interference that reduces the SE gains. This paper proposes the Massive-MIMO Iterative Channel Estimation and Decoding (MICED) algorithm where partially decoded data is used as side-information to improve the channel estimation and increase SE. We show that users with precise data estimates can help users with poor data estimates to decode. Numerical results with QPSK modulation and LDPC codes show that the MICED algorithm increases the SE and reduces the block-error-rate with RP and SP compared to conventional methods. The MICED algorithm with SP delivers the highest SE and it is especially effective in scenarios with short coherence blocks like high mobility or high frequencies.

cs.IT↗

arXiv2021

Optimal Per-Antenna ADC Bit Allocation in Correlated and Cell-Free Massive MIMO

In Massive MIMO base stations (BSs), the hardware design needs to balance high spectral efficiency (SE) with low complexity. The level of hardware impairments (HWIs) indicates how strong the signal distortion introduced by hardware imperfections is. In particular, the analog-to-digital converters (ADCs) have an important impact on signal distortion and power consumption. This article addresses the fundamental problem of selecting the optimal hardware quality in the Massive MIMO space. In particular, we examine the optimal HWI and ADC bit allocation per BS antenna to maximize the SE. The results show that in co-located arrays with low channel gain variations across antennas, equal ADC bit allocation is optimal. In contrast, cell-free Massive MIMO systems benefit the most from optimizing the ADC bit allocation achieving improvements in the order of 2 [bit-per-channel-use] per user equipment when using regularized zero-forcing (RZF). In addition, when including the impact of power consumption in cell-free Massive MIMO with RZF, allocating low values of mixed ADC bit resolutions across the BS antennas can increase the energy efficiency up to 30% compared to equal ADC bit allocation.

cs.IT↗

arXiv2018

Network Deployment for Maximal Energy Efficiency in Uplink with Multislope Path Loss

This work aims to design the uplink (UL) of a cellular network for maximal energy efficiency (EE). Each base station (BS) is randomly deployed within a given area and is equipped with $M$ antennas to serve $K$ user equipments (UEs). A multislope (distance-dependent) path loss model is considered and linear processing is used, under the assumption that channel state information is acquired by using pilot sequences (reused across the network). Within this setting, a lower bound on the UL spectral efficiency and a realistic circuit power consumption model are used to evaluate the network EE. Numerical results are first used to compute the optimal BS density and pilot reuse factor for a Massive MIMO network with three different detection schemes, namely, maximum ratio combining, zero-forcing (ZF) and multicell minimum mean-squared error. The numerical analysis shows that the EE is a unimodal function of BS density and achieves its maximum for a relatively small density of BS, irrespective of the employed detection scheme. This is in contrast to the single-slope (distance-independent) path loss model, for which the EE is a monotonic non-decreasing function of BS density. Then, we concentrate on ZF and use stochastic geometry to compute a new lower bound on the spectral efficiency, which is then used to optimize, for a given BS density, the pilot reuse factor, number of BS antennas and UEs. Closed- form expressions are computed from which valuable insights into the interplay between optimization variables, hardware characteristics, and propagation environment are obtained.

cs.IT↗

arXiv2017

Spectral and Energy Efficiency of Superimposed Pilots in Uplink Massive MIMO

Next generation wireless networks aim at providing substantial improvements in spectral efficiency (SE) and energy efficiency (EE). Massive MIMO has been proved to be a viable technology to achieve these goals by spatially multiplexing several users using many base station (BS) antennas. A potential limitation of Massive MIMO in multicell systems is pilot contamination, which arises in the channel estimation process from the interference caused by reusing pilots in neighboring cells. A standard method to reduce pilot contamination, known as regular pilot (RP), is to adjust the length of pilot sequences while transmitting data and pilot symbols disjointly. An alternative method, called superimposed pilot (SP), sends a superposition of pilot and data symbols. This allows to use longer pilots which, in turn, reduces pilot contamination. We consider the uplink of a multicell Massive MIMO network using maximum ratio combining detection and compare RP and SP in terms of SE and EE. To this end, we derive rigorous closed-form achievable rates with SP under a practical random BS deployment. We prove that the reduction of pilot contamination with SP is outweighed by the additional coherent and non-coherent interference. Numerical results show that when both methods are optimized, RP achieves comparable SE and EE to SP in practical scenarios.

eess.SP↗

arXiv2017

Network Deployment for Maximal Energy Efficiency in Uplink with Zero-Forcing

This work aims to design a cellular network for maximal energy efficiency (EE). In particular, we consider the uplink with multi-antenna base stations and assume that zero- forcing (ZF) combining is used for data detection with imperfect channel state information. Using stochastic geometry and a new lower bound on the average per-user spectral efficiency of the network, we optimize the pilot reuse factor, number of antennas and users per base station. Closed-form expressions are computed from which valuable insights into the interplay between the optimization variables, hardware characteristics, and propagation environment are obtained. Numerical results are used to validate the analysis and make comparisons with a network using maximum ratio (MR) combining. The results show that a Massive MIMO setup arises as the EE-optimal network configuration. In addition, ZF provides higher EE than MR while allowing a smaller pilot reuse factor and a more dense network deployment.

cs.IT↗

arXiv2016

Scalable Device-to-Device Communications For Frequency Reuse >> 1

Proximity based applications are becoming fast growing markets suggesting that Device-to-Device (D2D) communications is becoming an essential part of future mobile data networks. We propose scalable admission and power control methods for D2D communications underlay cellular networks to increase the reuse of frequency resources and thus network capacity while maintaining QoS to all users. The aim of the proposed methods is to maximize the number of D2D links under QoS constraints, therefore maximizing network frequency reuse, while considering different levels of complexity and available channel state information (CSI) in a multi-cell environment. Numerical results show that by using D2D and the proposed multi-cell interference coordination and low power transmission method, the network spectral efficiency can be increased by as much as ten times, while low outage probability can be assured to provided QoS for all users.

cs.NI↗