arXiv subjects

Daniele Di Gioacchino

Publications and source records attributed to Daniele Di Gioacchino.

13 recordsLinked to original sources

arXiv2026

Global detector network to search for high-frequency gravitational waves (GravNet): conceptual design

We propose GravNet (Global detector network to search for high-frequency gravitational waves), a novel experimental scheme enabling the search for gravitational waves in the MHz to GHz frequency range. Such high-frequency gravitational waves could arise from a variety of phenomena connected to some of the most pressing and fundamental questions in modern cosmology. The GravNet concept is based on synchronous measurements of signals from multiple experimental measurement devices operating at geographically separated locations. While gravitational-wave-induced signatures may be present in the signal of a single detector, distinguishing them from instrumental or environmental noise is highly challenging. By analyzing correlations between signals from several distant detectors, the detection significance is substantially enhanced, while simultaneously enabling studies of the nature and origin of the gravitational-wave signal. In this work, we discuss the GravNet concept specifically in the context of cavities operated in strong magnetic fields, as these currently represent the most technically mature and experimentally advanced realization of the scheme. As part of this proposal, a first demonstration experiment using a non-superconducting cavity has been performed, providing the basis for the data-analysis strategies discussed in this work. Finally, we outline the prospects and future development of GravNet as a global network for high-frequency gravitational-wave searches.

astro-ph.IM↗

arXiv2025

Search for post-inflationary QCD axions with a quantum-limited tunable microwave receiver

A search for cosmological axions has been performed by scanning a frequency region of $38\,$MHz centered at about $10.2\,$GHz, corresponding to an axion mass $m_a \simeq 42\,μ$eV. The QUAX experimental apparatus, a haloscope comprised of a 1-liter volume tunable cavity immersed in an $8\,$T magnetic field and a quantum-limited detection chain, set limits on the axion-photon coupling at the $10^{-14}\,$GeV$^{-1}$ level. As no signal candidate has been observed, viable hadronic axion models are ruled out in a currently preferred post-inflationary region $m_a > 40\,μ$eV.

hep-ex↗

arXiv2024

Nonlinear Behavior of Josephson Traveling Wave Parametric Amplifiers

Recent advancements in quantum technologies and advanced detection experiments have underscored the pressing need for the detection of exceedingly weak signals within the microwave frequency spectrum. Addressing this challenge, the Josephson Traveling Wave Parametric Amplifier (JTWPA) has been proposed as a cryogenic front-end amplifier capable of approaching the quantum noise limit while providing a relevant bandwidth. This research is centered on a comprehensive numerical investigation of the JTWPA, without resorting to simplifications regarding the nonlinearity of the essential components. Specifically, this study focuses on a thorough examination of the system, characterized by coupled nonlinear differential equations representing all components of the device. Proper input and output signals at the device's boundaries are considered. The analysis of the output signals undergoing the parametric amplification process involves a detailed exploration of phase-space dynamics and Fourier spectral analysis of the output voltage. This study is conducted while considering the parameters ruling the response of the device under pump and signal excitations. In addition to the expected signal amplification, the findings reveal that the nonlinear nature of the system can give rise to unforeseen phenomena, depending on the system's operational conditions, which include: the generation of pump tone harmonics, modulation of the signal gain, and incommensurate frequency generation-effects that are not easily accommodated by simplistic linearized approaches

cond-mat.supr-con↗

arXiv2024

Broadband parametric amplification in DARTWARS

Superconducting parametric amplifiers offer the capability to amplify feeble signals with extremely low levels of added noise, potentially reaching quantum-limited amplification. This characteristic makes them essential components in the realm of high-fidelity quantum computing and serves to propel advancements in the field of quantum sensing. In particular, Traveling-Wave Parametric Amplifiers (TWPAs) may be especially suitable for practical applications due to their multi-Gigahertz amplification bandwidth, a feature lacking in Josephson Parametric Amplifiers (JPAs), despite the latter being a more established technology. This paper presents recent developments of the DARTWARS (Detector Array Readout with Traveling Wave AmplifieRS) project, focusing on the latest prototypes of Kinetic Inductance TWPAs (KITWPAs). The project aims to develop a KITWPA capable of achieving $20\,$ dB of amplification. To enhance the production yield, the first prototypes were fabricated with half the length and expected gain of the final device. In this paper, we present the results of the characterization of one of the half-length prototypes. The measurements revealed an average amplification of approximately $9\,$dB across a $2\,$GHz bandwidth for a KITWPA spanning $17\,$mm in length.

quant-ph↗

arXiv2024

Development of KI-TWPAs for the DARTWARS project

Noise at the quantum limit over a broad bandwidth is a fundamental requirement for future cryogenic experiments for neutrino mass measurements, dark matter searches and Cosmic Microwave Background (CMB) measurements as well as for fast high-fidelity read-out of superconducting qubits. In the last years, Josephson Parametric Amplifiers (JPA) have demonstrated noise levels close to the quantum limit, but due to their narrow bandwidth, only few detectors or qubits per line can be read out in parallel. An alternative and innovative solution is based on superconducting parametric amplification exploiting the travelling-wave concept. Within the DARTWARS (Detector Array Readout with Travelling Wave AmplifieRS) project, we develop Kinetic Inductance Travelling-Wave Parametric Amplifiers (KI-TWPAs) for low temperature detectors and qubit read-out. KI-TWPAs are typically operated in a threewave mixing (3WM) mode and are characterised by a high gain, a high saturation power, a large amplification bandwidth and nearly quantum limited noise performance. The goal of the DARTWARS project is to optimise the KI-TWPA design, explore new materials, and investigate alternative fabrication processes in order to enhance the overall performance of the amplifier. In this contribution we present the advancements made by the DARTWARS collaboration to produce a working prototype of a KI-TWPA, from the fabrication to the characterisation.

quant-ph↗

arXiv2024

Characterization of a Transmon Qubit in a 3D Cavity for Quantum Machine Learning and Photon Counting

In this paper we report the use of superconducting transmon qubit in a 3D cavity for quantum machine learning and photon counting applications. We first describe the realization and characterization of a transmon qubit coupled to a 3D resonator, providing a detailed description of the simulation framework and of the experimental measurement of important parameters, like the dispersive shift and the qubit anharmonicity. We then report on a Quantum Machine Learning application implemented on the single-qubit device to fit the u-quark parton distribution function of the proton. In the final section of the manuscript we present a new microwave photon detection scheme based on two qubits coupled to the same 3D resonator. This could in principle decrease the dark count rate, favouring applications like axion dark matter searches.

quant-ph↗

arXiv2024

Design and simulation of a transmon qubit chip for Axion detection

Quantum Sensing is a rapidly expanding research field that finds one of its applications in Fundamental Physics, as the search for Dark Matter. Devices based on superconducting qubits have already been successfully applied in detecting few-GHz single photons via Quantum Non-Demolition measurement (QND). This technique allows us to perform repeatable measurements, bringing remarkable sensitivity improvements and dark count rate suppression in experiments based on high-precision microwave photon detection, such as for Axions and Dark Photons search. In this context, the INFN Qub-IT project goal is to realize an itinerant single-photon counter based on superconducting qubits that will exploit QND for enhancing Axion search experiments. In this study, we present Qub-IT's status towards the realization of its first superconducting qubit device, illustrating design and simulation procedures and the characterization of fabricated Coplanar Waveguide Resonators (CPWs) for readout. We match target qubit parameters and assess a few-percent level agreement between lumped and distributed element simulation models. We reach a maximum internal quality factor of 9.2x10^5 for -92 dBm on-chip readout power.

quant-ph↗

arXiv2023

The future search for low-frequency axions and new physics with the FLASH resonant cavity experiment at Frascati National Laboratories

We present a proposal for a new experiment, the FINUDA magnet for Light Axion SearcH (FLASH), a large resonant-cavity haloscope in a high static magnetic field which is planned to probe new physics in the form of dark matter (DM) axions, scalar fields, chameleons, hidden photons, as well as high frequency gravitational waves (GWs). Concerning the QCD axion, FLASH will search for these particles as the DM in the mass range (0.49-1.49) ueV, thus filling the mass gap between the ranges covered by other planned searches. A dedicated Microstrip SQUID operating at ultra-cryogenic temperatures will amplify the signal. The frequency range accessible overlaps with the Very High Frequency (VHF) range of the radio wave spectrum and allows for a search in GWs in the frequency range (100-300) MHz. The experiment will make use of the cryogenic plant and magnet of the FINUDA experiment at INFN Frascati National Laboratories near Rome (Italy); the operations needed to restore the functionalities of the apparatus are currently underway. We present the setup of the experiment and the sensitivity forecasts for the detection of axions, scalar fields, chameleons, hidden photons, and GWs.

physics.ins-det↗

arXiv2021

Impact of the superconductors properties on the measurement sensitivity of resonant-based axion detectors

Axions, hypothetical particles theorized to solve the strong CP-problem, are presently being considered as strong candidates as cold dark matter constituents. The signal power of resonant-based axion detectors, known as haloscopes, is directly proportional to their quality factor $Q$. In this paper, the impact of the use of superconductors in the performances of the haloscopes is studied by evaluating the obtainable $Q$. In particular, the surface resistance $R_s$ of NbTi, Nb$_3$Sn, YBa$_2$Cu$_3$O$_{7-δ}$ and FeSe$_{0.5}$Te$_{0.5}$ is computed in the frequency, magnetic field and temperature ranges of interest, starting from the measured vortex motion complex resistivity and screening lengths of these materials. From $R_s$ the quality factor $Q$ of a cylindrical haloscope with copper conical bases and superconductive lateral wall, operating with the TM$_{010}$ mode, is evaluated and used to perform a comparison of the performances of the different materials. Both YBa$_2$Cu$_3$O$_{7-δ}$ and FeSe$_{0.5}$Te$_{0.5}$ are shown to improve the measurement sensitivity by almost an order of magnitude with respect to a whole Cu cavity, while NbTi is shown to be suitable only at lower frequencies (<10 GHz). Nb$_3$Sn can give an intermediate improvement in the whole spectrum of interest.

physics.ins-det↗

arXiv2021

Status of the SIMP Project: Toward the Single Microwave Photon Detection

The Italian institute for nuclear physics (INFN) has financed the SIMP project (2019-2021) in order to strengthen its skills and technologies in the field of meV detectors with the ultimate aim of developing a single microwave photon detector. This goal will be pursued by improving the sensitivity and the dark count rate of two types of photodetectors: current biased Josephson Junction (JJ) for the frequency range 10-50 GHz and Transition Edge Sensor (TES) for the frequency range 30-100 GHz. Preliminary results on materials and devices characterization are presented.

physics.ins-det↗

arXiv2017

The KLASH Proposal

We propose a search of galactic axions with mass about 0.2 microeV using a large volume resonant cavity, about 50 m^3, cooled down to 4 K and immersed in a moderate axial magnetic field of about 0.6 T generated inside the superconducting magnet of the KLOE experiment located at the National Laboratory of Frascati of INFN. This experiment, called KLASH (KLoe magnet for Axion SearcH) in the following, has a potential sensitivity on the axion-to-photon coupling, g_agg, of about 6x10^-17 GeV-1, reaching the region predicted by KSVZ and DFSZ models of QCD axions.

physics.ins-det↗

arXiv2014

The AC multi-harmonic magnetic susceptibility measurement setup at the LNF-INFN

The AC magnetic susceptibility is a fundamental method in materials science, which allows to probe the dynamic magnetic response of magnetic materials and superconductors. The LAMPS laboratory at the Laboratori Nazionali di Frascati of the INFN hosts an AC multi-harmonic magnetometer that allows performing experiments with an AC magnetic field ranging from 0.1 to 20 Gauss and in the frequency range from 17 to 2070 Hz. A DC magnetic field from 0 to 8 T produced by a superconducting magnet can be applied, while data may be collected in the temperature range 4.2-300 K using a liquid He cryostat under different temperature cycles setups. The first seven AC magnetic multi-harmonic susceptibility components can be measured with a magnetic sensitivity of 1x10-6 emu and a temperature precision of 0.01 K. Here we will describe in detail about schematic of the magnetometer, special attention will be dedicated to the instruments control, data acquisition framework and the user-friendly LabVIEW-based software platform.

physics.ins-det↗

arXiv2012

Optimum inhomogeneity of local lattice distortions in La2CuO4+y

Electronic functionalities in materials from silicon to transition metal oxides are to a large extent controlled by defects and their relative arrangement. Outstanding examples are the oxides of copper, where defect order is correlated with their high superconducting transition temperatures. The oxygen defect order can be highly inhomogeneous, even in "optimal" superconducting samples, which raises the question of the nature of the sample regions where the order does not exist but which nonetheless form the "glue" binding the ordered regions together. Here we use scanning X-ray microdiffraction (with beam 300 nm in diameter) to show that for La2CuO4+y, the "glue" regions contain incommensurate modulated local lattice distortions, whose spatial extent is most pronounced for the best superconducting samples. For an underdoped single crystal with mobile oxygen interstitials in the spacer La2O2+y layers intercalated between the CuO2 layers, the incommensurate modulated local lattice distortions form droplets anticorrelated with the ordered oxygen interstitials, and whose spatial extent is most pronounced for the best superconducting samples. In this simplest of high temperature superconductors, there are therefore not one, but two networks of ordered defects which can be tuned to achieve optimal superconductivity. For a given stoichiometry, the highest transition temperature is obtained when both the ordered oxygen and lattice defects form fractal patterns, as opposed to appearing in isolated spots. We speculate that the relationship between material complexity and superconducting transition temperature Tc is actually underpinned by a fundamental relation between Tc and the distribution of ordered defect networks supported by the materials.

cond-mat.supr-con↗