Davide Zanetti | Searcharxiv

arXiv2022

Calibration of the IXPE focal plane X-ray polarimeters to polarized radiation

IXPE (Imaging X-ray Polarimetry Explorer) is a NASA Small Explorer mission -- in partnership with the Italian Space Agency (ASI) -- dedicated to X-ray polarimetry in the 2--8 keV energy band. The IXPE telescope comprises three grazing incidence mirror modules coupled to three detector units hosting each one a Gas Pixel Detector (GPD), a gas detector that allows measuring the polarization degree by using the photoelectric effect. A wide and accurate ground calibration was carried out on the IXPE Detector Units (DUs) at INAF-IAPS, in Italy, where a dedicated facility was set-up at this aim. In this paper, we present the results obtained from this calibration campaign to study the IXPE focal plane detector response to polarized radiation. In particular, we report on the modulation factor, which is the main parameter to estimate the sensitivity of a polarimeter.

astro-ph.IM↗

arXiv2021

A DoE-based approach for the implementation of structural surrogate models in the early stage design of box-wing aircraft

One of the possible ways to face the challenge of reducing the environmental impact of aviation, without limiting the growth of air transport, is the introduction of more efficient, radically different aircraft architectures. Among these, the box-wing one represents a promising solution, at least in the case of its application to short-to-medium haul aircraft, which, according to the achievement of the H2020 project "PARSIFAL", would bring to a 20% reduction in terms of emitted CO2 per passenger-kilometre. The present paper faces the problem of estimating the structural mass of such a disruptive configuration in the early stages of the design, underlining the limitations in this capability of the approaches available by literature and proposing a DoE-based approach to define surrogate models suitable for such purpose. A test case from the project "PARSIFAL" is used for the first conception of the approach, starting from the Finite Element Model parametrization, then followed by the construction of a database of FEM results, hence introducing the regression models and implementing them in an optimization framework. Results achieved are investigated in order to validate both the wing sizing and the optimization procedure. Finally, an additional test case resulting from the application of the box-wing layout to the regional aircraft category within the Italian research project "PROSIB", is briefly presented to further assess the capabilities of the proposed approach.

eess.SY↗