Dogyun Byeon | Searcharxiv

arXiv2025

Dynamics of Interfacial Diffusion Control in Amphiphilic Lipid-Coated Micro-Particles for Stochastic Release Systems

The release of hydrophilic solutes from micron scale particulate formulations can be understood as an interfacial transport problem in which diffusion across a heterogeneous amphiphilic coating competes with dissolution and convective removal in the surrounding medium. Here we reinterpret a glycerin fatty acid ester (GFAE) coated thiamine (vitamin B1) micro particle formulation as a condensed matter system: a soft matter core shell geometry whose effective permeability is set by the nanoscale organization of amphiphilic lipids at the interface. Using in vivo time course serum measurements in mice as a proxy for a stochastic sink, we compare the coated formulation (UTEV) with a composition matched uncoated comparator (UMFG). Early time systemic appearance is similar, whereas late time levels are enhanced for the coated particles, implying a reduced effective interfacial diffusivity and a broadened release-time distribution. We discuss the results in terms of diffusion barrier physics, heterogeneous interfacial energetics, and coarse grained transport models that map microstructural coating parameters to macroscopic persistence (AUC).

cond-mat.soft↗

arXiv2019

Distinctive Thermoelectric Properties of Supersaturated Si-Ge-P Compounds: Achieving Figure of Merit ZT > 3.6

The efficiency of energy conversion in thermoelectric generators (TEGs) is directly proportional to electrical conductivity and Seebeck coefficient while inversely to thermal conductivity. The challenge is to optimize these interdependent parameters simultaneously. In this work, the problem is addressed with a novel approach of nanostructuring and constructive electronic structure modification to achieve a very high value of dimensionless figure of merit ZT greater than 3.6 at 1000 K with negative Seebeck coefficient. Supersaturated solid-solutions of Si-Ge containing 1 atomic percent Fe and 10 atomic percent P are prepared by high-energy ball milling. The bulk samples consisting of ultra-fine nano-crystallites 9.7 nm are obtained by the sophisticated low-temperature & high-pressure sintering process. Despite that the electrical resistivity is slightly high due to the localization of electrons is associated with the highly disordered structure and low electrical density of states near the chemical potential, a very low thermal conductivity \k{appa} less than 1 W m-1K-1 and very large magnitude of Seebeck coefficient exceeding 470 uV K-1 are achieved in association with the nanostructuring and the Fe 3d impurity states, respectively, to realize a very large magnitude of ZT.

cond-mat.mtrl-sci↗