arXiv subjects

Dongyao Wang

Publications and source records attributed to Dongyao Wang.

3 recordsLinked to original sources

arXiv2026

Nonlinear exceptional points in an integrated acoustic-wave oscillator for longwave infrared sensing

Exceptional points (EP) featuring enhanced responsivity and rich dynamics have attracted extensive attentions in device developments and sensing applications. However, it remains debated whether employing EP systems is beneficial in practical sensing applications. Here, we demonstrate that a nonlinear EP in our microwave-frequency acoustic-wave oscillator improves longwave infrared (LWIR) detection under practical conditions. By phase tuning the nonlinear gain, our detector can be operated at different conditions with respect to the nonlinear EP. Compared with operation away from EP, our detector at EP shows a 33-fold improvement in responsivity and an 8.75-fold extension of 3-dB bandwidth. We observe a 6-fold enhancement in signal-to-noise ratio at an input modulation frequency of 6.2 kHz. At the incident LWIR wavelength of 9.6 um, our detector at EP exhibits a noise equivalent power (NEP) of 310 pW*Hz^-1/2 at input frequency of 10 kHz, yielding a figure of merit, product of NEP and time constant, of 9.87*10^-3 pW*Hz^-3/2, a 10-fold improvement over operation away from EP. Our integrated acoustic devices offer a versatile platform for exploring noise dynamics and developing practical sensors that exploit non-Hermitian nonlinearities.

physics.optics↗

arXiv2025

Room-temperature mid-infrared detection using metasurface-absorber-integrated phononic crystal oscillator

Mid-infrared (MIR) detectors find extensive applications in chemical sensing, spectroscopy, communications, biomedical diagnosis and space explorations. Alternative to semiconductor MIR photodiodes and bolometers, mechanical-resonator-based MIR detectors show advantages in higher sensitivity and lower noise at room temperature, especially towards longer wavelength infrared. Here, we demonstrate uncooled room-temperature MIR detectors based on lithium niobate surface acoustic wave phononic crystal (PnC) resonators integrated with wavelength-and-polarization-selective metasurface absorber arrays. The detection is based on the resonant frequency shift induced by the local temperature change due to MIR absorptions. The PnC resonator is configured in an oscillating mode, enabling active readout and low frequency noise. Compared with detectors based on tethered thin-film mechanical resonators, our non-suspended, fully supported PnC resonators offer lower noise, faster thermal response, and robustness in both fabrication and practical applications. Our 1-GHz oscillator-based MIR detector shows a relative frequency deviation of $5.24 \times 10^{-10}$ Hz$^{-1/2}$ at an integration time of 50 $μ$s, leading to an incident noise equivalent power of 197 pW/$\sqrt{\mathrm{Hz}}$ when input 6-$μ$m MIR light is modulated at 1.8 kHz, and a large dynamic range of 107 in incident MIR power. Our device architecture is compatible with the scalable manufacturing process and can be readily extended to a broader spectral range by tailoring the absorbing wavelengths of metasurface absorbers.

physics.optics↗

arXiv2025

Low-phase-noise surface-acoustic-wave oscillator using an edge mode of a phononic band gap

Low-phase-noise microwave-frequency integrated oscillators provide compact solutions for various applications in signal processing, communications, and sensing. Surface acoustic waves (SAW), featuring orders-of-magnitude shorter wavelength than electromagnetic waves at the same frequency, enable integrated microwave-frequency systems with much smaller footprint on chip. SAW devices also allow higher quality (Q) factors than electronic components at room temperature. Here, we demonstrate a low-phase-noise gigahertz-frequency SAW oscillator on 128°Y-cut lithium niobate, where the SAW resonator occupies a footprint of 0.05 mm$^2$. Leveraging phononic crystal bandgap-edge modes to balance between Q factors and insertion losses, our 1-GHz SAW oscillator features a low phase noise of -132.5 dBc/Hz at a 10 kHz offset frequency and an overlapping Hadamard deviation of $6.5\times10^{-10}$ at an analysis time of 64 ms. The SAW resonator-based oscillator holds high potential in developing low-noise sensors and acousto-optic integrated circuits.

physics.app-ph↗