arXiv subjects

E. Bellingeri

Publications and source records attributed to E. Bellingeri.

14 recordsLinked to original sources

arXiv2017

Current Induced Resistive State in Fe(Se,Te) Superconducting Nanobridges

We study the current-voltage characteristics of Fe(Se,Te) thin films deposited on CaF$_2$ substrates in form of nanostrips (width $w\simλ$, $λ$ the London penetration length). In view of a possible application of these materials to superconductive electronics and micro-electronics we focus on transport properties in small magnetic field, the one generated by the bias current. From the characteristics taken at different temperatures we derive estimates for the pinning potential $U$ and the pinning potential range $δ$. Since the sample lines are very narrow, the classical creep flow model provides a sufficiently accurate interpretation of the data only when the attractive interaction between magnetic flux lines of opposite sign is taken into account. The observed voltages and the induced detriment of the critical current of the nanostrips are compatible with the presence of few tens of magnetic field lines at the equilibrium and a strongly inhomogeneous current density distribution. In particular, we argue that the sharp corners defining the bridge geometry represent points of easy magnetic flux lines injection. The results are relevant for creep flow analysis in superconducting Fe(Se,Te) nanostrips.

cond-mat.supr-con↗

arXiv2014

Two-band conductivity of a FeSe$_{0.5}$Te$_{0.5}$ film by reflectance measurements in the terahertz and infrared range

We report an infrared spectroscopy study of a 200 nm thick FeSe$_{0.5}$Te$_{0.5}$ film grown on LaAlO$_3$ with T$_c$=13.7 K. We analyze the 20 K normal state absolute reflectance R$_N$ measured over a broad infrared range and the reflectance ratio R$_S$/R$_N$, R$_S$ being the superconducting state reflectance, measured at 6 K in the terahertz range down to 12 cm$^{-1}$. We show that the normal state model conductivity is given by two Drude components, one of which much broader and intense than the other. In the superconducting state, we find that a gap $Δ$=37$\pm$3 cm$^{-1}$ opens up in the narrow Drude band only, while the broad Drude band results to be ungapped, at least in the explored spectral range. Our results show that only a two-band model can coherently describe both normal and superconducting state data.

cond-mat.supr-con↗

arXiv2013

Highly effective and isotropic pinning in epitaxial Fe(Se,Te) thin films grown on CaF2 substrates

We report on the isotropic pinning obtained in epitaxial Fe(Se,Te) thin films grown on CaF2 (001) substrate. High critical current density values larger than 1 MA/cm2 in self field in liquid helium are reached together with a very weak dependence on the magnetic field and a complete isotropy. Analysis through Transmission Electron Microscopy evidences the presence of defects looking like lattice disorder at a very small scale, between 5 and 20 nm, which are thought to be responsible for such isotropic behavior in contrast to what observed on SrTiO3, where defects parallel to the c-axis enhance pinning in that direction

cond-mat.supr-con↗

arXiv2011

Significant enhancement of upper critical fields by doping and strain in Fe-based superconductors

We report measurements of Hc2(T) up to 85 Tesla on Ba1-xKxAs2Fe2 single crystals and FeSe1-xTex films tuned by doping and strain. We observed an Hc2 enhancement by nearly 25 T at 30 K for the optimally-doped Ba1-xKxAs2Fe2 as compared to the previous results and extraordinarily high slopes dHc2/dT = 250-500 T/K near Tc in FeSe1-xTex indicating an almost complete suppression of the orbital pair-breaking. Theoretical analysis of Hc2(T) in FeSe1-xTex and the optimally doped Ba1-xKxAs2Fe2 predicts an inhomogeneous Fulde-Ferrel-Larkin-Ovchinnikov state for H//ab and T < 3-10 K, and shows that Hc2 in multiband Fe based superconductor can be enhanced by doping and strain much more effectively than by the conventional way of increasing disorder.

cond-mat.supr-con↗

arXiv2011

Anisotropic critical currents in FeSe0.5Te0.5 films and the influence of neutron irradiation

We report on measurements of the superconducting properties of FeSe05Te05 thin films grown on lanthanum aluminate. The films have high transition temperatures (above 19 K) and sharp resistive transitions in fields up to 15 T. The temperature dependence of the upper critical field and the irreversibility lines are steep and anisotropic, as recently reported for single crystals. The critical current densities, assessed by magnetization measurements in a vector VSM, were found to be well above 10^9 Am-2 at low temperatures. In all samples, the critical current as a function of field orientation has a maximum, when the field is oriented parallel to the film surface. The maximum indicates the presence of correlated pinning centers. A minimum occurs in three films, when the field is applied perpendicular to the film plane. In the forth film, instead, a local maximum caused by c-axis correlated pinning centers was found at this orientation. The irradiation of two films with fast neutrons did not change the properties drastically, where a maximum enhancement of the critical current by a factor of two was found.

cond-mat.supr-con↗

arXiv2009

Tc=21K in epitaxial FeSe0.5Te0.5 thin films with biaxial compressive strain

High purity epitaxial FeSe0.5Te0.5 thin films with different thickness were grown by Pulsed Laser Ablation on different substrates. By varying the film thickness, Tc up to 21K were observed, significantly larger than the bulk value. Structural analyses indicated that the a axis changes significantly with the film thickness and is linearly related to the Tc. The latter result indicates the important role of the compressive strain in enhancing Tc. Tc is also related to both the Fe-(Se,Te) bond length and angle, suggesting the possibility of further enhancement.

cond-mat.supr-con↗

arXiv2009

High quality epitaxial FeSe0.5Te0.5 thin films grown on SrTiO3 substrates by pulsed laser deposition

Superconducting epitaxial FeSe0.5Te0.5 thin films were prepared on SrTiO3 (001) substrates by pulsed laser deposition. The high purity of the phase, the quality of the growth and the epitaxy were studied with different experimental techniques: X-rays diffraction, reflection high energy electron diffraction, scanning tunnelling microscopy and atomic force microscopy. The substrate temperature during the deposition was found to be the main parameter governing sample morphology and superconducting critical temperature. Films obtained in the optimal conditions show an epitaxial growth with c axis perpendicular to the film surface and the a and b axis parallel to the substrates one, without the evidence of any other orientation. Moreover, such films show a metallic behavior over the whole measured temperature range and critical temperature above 17K, which is higher than the target one.

cond-mat.supr-con↗

arXiv2008

Thermal properties of SmFeAs(O1-xFx) as probe of the interplay between electrons and phonons

A comparative study of thermal properties of SmFeAsO, SmFeAs(O0.93F0.07) and SmFeAs(O0.85F0.15) samples is presented. Specific heat and thermal conductivity show clear evidences of the spin density wave (SDW) ordering below TSDW 135 K in undoped SmFeAsO. At low level of F-doping, SmFeAs(O0.93F0.07), SDW ordering is suppressed and superconducting features are not yet optimally developed in both specific heat and thermal conductivity. At optimal level of F-doping SmFeAs(O0.85F0.15) anomalies related to the superconducting transition are well noticeable. By a compared analysis of doped and undoped samples we conclude that, despite F-doping modifies definitely the electronic ground state, it does not substantially alter phonon and electron parameters, like phonon modes, Sommerfeld coefficient, electro-phonon coupling. The analysis of the thermal conductivity curves provides an evaluation of SDW and superconducting energy gap, showing that phonons can suitably probe features of electronic ground state.

cond-mat.supr-con↗

arXiv2004

Upper Critical Fields up to 60T in Dirty Magnesium Diboride Thin Films

Upper critical fields of several magnesium diboride thin films were measured up to 28 T at the Grenoble High Magnetic Field Laboratory (GHMFL) in Grenoble and up to 60 T at the Laboratoire National des Champs Magnetiques Pulses (LNCMP) in Toulouse. The samples were prepared both by pulsed laser deposition (PLD) and hybrid physical chemical vapour deposition (HPCVD) technique; they have critical temperatures between 29 and 39 K and normal state resistivities between 5 and 250 μohmcm; one of them has been intentionally doped with carbon. The measured critical fields were exceptionally high; we obtained the record value of 52 T at 4.2 K in the parallel orientation. In contrast with the BCS predictions, no saturation in Hc2 at low temperature was observed. Furthermore, films with a wide range of resistivity values showed similar critical fields, suggesting that in a two band system resistivity and Hc2 are not trivially linked. The high Hc2 values seem to be related with the expanded c-axis. The structure of one of the samples was carefully investigated with X-ray diffraction at European Synchrotron Radiation Facility (ESRF) in Grenoble.

cond-mat.supr-con↗

arXiv2004

Epitaxial MgB2 thin films on ZrB2 buffer layers: structural characterization by synchrotron radiation

Structural and superconducting properties of magnesium diboride thin films grown by pulsed laser deposition on zirconium diboride buffer layers were studied. We demonstrate that the ZrB2 layer is compatible with the MgB2 two step deposition process. Synchrotron radiation measurements, in particular anomalous diffraction measurements, allowed to separate MgB2 peaks from ZrB2 ones and revealed that both layers have a single in plane orientation with a sharp interface between them. Moreover, the buffer layer avoids oxygen contamination from the sapphire substrate. The critical temperature of this film is near 37.6 K and the upper critical field measured at Grenoble High Magnetic Field Laboratory up to 20.3 T is comparable with the highest ones reported in literature.

cond-mat.supr-con↗

arXiv2002

Growth methods of c-axis oriented MgB2 thin films by pulsed laser deposition

High quality MgB2 thin films have been obtained by pulsed laser deposition both on MgO and on Al2O3 substrates using different methods. In the standard two-step procedure, an amorphous precursor layer is deposited at room temperature starting both from stoichiometric target and from boron target: after this first step, it is annealed in magnesium atmosphere in order to crystallize the superconducting phase. The so obtained films show a strong c-axis orientation, evidenced by XRD analysis, a critical temperature up to 38 K and very high critical fields along the basal planes, up to 22T at 15K. Also an in situ one step technique for the realization of superconducting MgB2 thin films has been developed. In this case, the presence of an argon buffer gas during deposition is crucial and we observe a strong dependence of the quality of the deposited film on the background gas pressure. The influence of the Ar atmosphere has been confirmed by time and space-resolved spectroscopy measurements on the emission spectrum of the plume. The Ar pressure modifies strongly the plasma kinetics by promoting excitation and ionization of the plume species, especially of the most volatile Mg atoms, increasing their internal energy.

cond-mat.supr-con↗

arXiv2001

Anisotropy in c-oriented MgB2 thin films grown by Pulsed Laser Deposition

The electronic anisotropy in MgB2, is still a not completely clear topic; high quality c-oriented films are suitable systems to investigate this property. In this work we present our results on MgB2 superconducting thin films grown on MgO and sapphire substrates. The films are deposited in high vacuum, at room temperature, by Laser Ablation, starting from two different targets: pure Boron and stoichiometric MgB2. In both cases, to obtain and crystallize the superconducting phase, an ex-situ annealing in magnesium vapor is needed. The films were characterized by Synchrotron radiation diffraction measurements; the films turned out to be strongly c-oriented, with the c-axis perpendicular to the film surface and an influence of the substrate on crystallographic parameters is observed. Resisivity measurements with the magnetic field perpendicular and parallel directions to the film surface evidenced an anisotropic upper critical field behavior. The Hc2 ratios (h) resulted in the range 1.2-1.8; this difference will be discussed also in comparison with the literature data.

cond-mat.supr-con↗

arXiv2001

Growth of c-oriented MgB2 thin films by Pulsed Laser Deposition: structural characterization and electronic anisotropy

MgB2 thin films were deposited using Pulsed Laser Deposition (PLD) and ex-situ annealing in Mg atmosphere. The films presented critical temperatures up to 36K and turned out to be preferentially c-oriented both on Al2O3 (r-cut) and MgO(100) substrates. Synchrotron analyses gave also some indications of in plane texturing. The films exhibit very fine grain size (1200angstromin the basal plane and 100angstrom along c-axis) but the general resistivity behavior and the remarkable extension of the irreversible region confirm that the grains boundaries are not barriers for supercurrents. Upper critical field measurements with the magnetic field perpendicular and parallel with respect to the film surface evidenced a field anisotropy ratio of 1.8. The Hc2 values are considerably higher with respect to the bulk ones, namely when the field lies in the basal plane, and the field-temperature phase diagram for the two magnetic field orientations suggest the possibility of strongly enhancing the pinning region by means of texturing.

cond-mat.supr-con↗

arXiv2001

In-situ Magnesium Diboride Superconducting Thin Films grown by Pulsed Laser Deposition

Superconducting thin films of MgB2 were deposited by Pulsed Laser Deposition on magnesium oxide and sapphire substrates. Samples grown at 450C in an argon buffer pressure of about 10-2 mbar by using a magnesium enriched target resulted to be superconducting with a transition temperature of about 25 K. Film deposited from a MgB2 sintered pellet target in ultra high vacuum conditions showed poor metallic or weak semiconducting behavior and they became superconducting only after an ex-situ annealing in Mg vapor atmosphere. Up to now, no difference in the superconducting properties of the films obtained by these two procedures has been evidenced.

cond-mat.supr-con↗