arXiv subjects

E. D'Huys

Publications and source records attributed to E. D'Huys.

6 recordsLinked to original sources

arXiv2022

Prominence eruption observed in He II 304 Å up to $>6 R_\sun$ by EUI/FSI aboard Solar Orbiter

We report observations of a unique, large prominence eruption that was observed in the He II 304 Å passband of the the Extreme Ultraviolet Imager/Full Sun Imager telescope aboard Solar Orbiter on 15-16 February 2022. Observations from several vantage points (Solar Orbiter, the Solar-Terrestrial Relations Observatory, the Solar and Heliospheric Observatory, and Earth-orbiting satellites) were used to measure the kinematics of the erupting prominence and the associated coronal mass ejection. Three-dimensional reconstruction was used to calculate the deprojected positions and speeds of different parts of the prominence. Observations in several passbands allowed us to analyse the radiative properties of the erupting prominence. The leading parts of the erupting prominence and the leading edge of the corresponding coronal mass ejection propagate at speeds of around 1700 km/s and 2200 km/s, respectively, while the trailing parts of the prominence are significantly slower (around 500 km/s). Parts of the prominence are tracked up to heights of over $6 R_\sun$. The He II emission is probably produced via collisional excitation rather than scattering. Surprisingly, the brightness of a trailing feature increases with height. The reported prominence is the first observed in He II 304 Å emission at such a great height (above 6 $R_\sun$).

astro-ph.SR↗

arXiv2022

A Coronal Mass Ejection followed by a prominence eruption and a plasma blob as observed by Solar Orbiter

On February 12, 2021 two subsequent eruptions occurred above the West limb, as seen along the Sun-Earth line. The first event was a typical slow Coronal Mass Ejection (CME), followed $\sim 7$ hours later by a smaller and collimated prominence eruption, originating Southward with respect to the CME, followed by a plasma blob. These events were observed not only by SOHO and STEREO-A missions, but also by the suite of remote sensing instruments on-board Solar Orbiter (SolO). This work shows how data acquired by the Full Sun Imager (FSI), Metis coronagraph, and Heliospheric Imager (SoloHI) from the SolO perspective can be combined to study the eruptions and the different source regions. Moreover, we show how Metis data can be analyzed to provide new information about solar eruptions. Different 3D reconstruction methods were applied to the data acquired by different spacecraft including remote sensing instruments on-board SolO. Images acquired by both Metis channels in the Visible Light (VL) and H I Lyman$-α$ line (UV) were combined to derive physical information on the expanding plasma. The polarization ratio technique was also applied for the first time to the Metis images acquired in the VL channel. The two eruptions were followed in 3D from their source region to their expansion in the intermediate corona. Thanks to the combination of VL and UV Metis data, the formation of a post-CME Current Sheet (CS) was followed for the first time in the intermediate corona. The plasma temperature gradient across a post-CME blob propagating along the CS was also measured for the first time. Application of the polarization ratio technique to Metis data shows that, thanks to the combination of four different polarization measurements, the errors are reduced by $\sim 5-7$\%, thus better constraining the 3D distribution of plasma.

astro-ph.SR↗

arXiv2020

Analysis of large deflections of prominence-CME events during the rising phase of solar cycle 24

Motivated by the need to improve the ability to forecast whether a certain coronal mass ejection (CME) is to impact Earth, and by the insufficiency of statistical studies that analyze the whole erupting system with the focus on the governing conditions under CME deflections, we performed a careful analysis of 13 events along a one-year time interval showing large deflections from their source region. We used telescopes imaging the solar corona at different heights and wavelengths on board the Project for Onboard Autonomy 2 (PROBA2), Solar Dynamics Observatory (SDO), Solar TErrestrial RElations Observatory (STEREO), Solar and Heliospheric Observatory (SOHO) spacecraft and from National Solar Observatory (NSO). By taking advantage of the quadrature position of these spacecraft from October 2010 until September 2011, we inspected the 3D trajectory of CMEs and their associated prominences with respect to their solar sources by means of a tie-pointing tool and a forward model. Considering the coronal magnetic fields as computed from a potential field source surface model, we investigate the roles of magnetic energy distribution and kinematic features in the non-radial propagation of both structures. The magnetic environment present during the eruption is found to be crucial in determining the trajectory of CMEs, in agreement with previous reports.

astro-ph.SR↗

arXiv2020

Numerical simulations of shear-induced consecutive coronal mass ejections

Methods: Stealth CMEs represent a particular class of solar eruptions that are clearly distinguished in coronagraph observations, but they don't have a clear source signature. A particular type of stealth CMEs occurs in the trailing current sheet of a previous ejection, therefore, we used the 2.5D MHD package of the code MPI-AMRVAC to numerically simulate consecutive CMEs by imposing shearing motions onto the inner boundary. The initial magnetic configuration consists of a triple arcade structure embedded into a bimodal solar wind, and the sheared polarity inversion line is found in the southern loop system. The mesh was continuously adapted through a refinement method that applies to current carrying structures. We then compared the obtained eruptions with the observed directions of propagation of an initial multiple coronal mass ejection (MCME) event that occurred in September 2009. We further analysed the simulated ejections by tracking the centre of their flux ropes in latitude and their total speed. Radial Poynting flux computation was employed as well to follow the evolution of electromagnetic energy introduced into the system. Results: Changes within 1\% in the shearing speed result in three different scenarios for the second CME, although the preceding eruption seems insusceptible to such small variations. Depending on the applied shearing speed, we thus obtain a failed eruption, a stealth, or a CME driven by the imposed shear, as the second ejection. The dynamics of all eruptions are compared with the observed directions of propagation of an MCME event and a good correlation is achieved. The Poynting flux analysis reveals the temporal variation of the important steps of eruptions. For the first time, a stealth CME is simulated in the aftermath of a first eruption, through changes in the applied shearing speed.

astro-ph.SR↗

arXiv2014

Observational Characteristics of CMEs without Low Coronal Signatures

Solar eruptions are usually associated with a variety of phenomena occurring in the low corona before, during, and after onset of eruption. Though easily visible in coronagraph observations, so-called stealth coronal mass ejections (CMEs) do not obviously exhibit any of these low-coronal signatures. The presence or absence of distinct low coronal signatures can be linked to different theoretical models to establish the mechanisms by which the eruption is initiated and driven. In this study, 40 CMEs without low coronal signatures, occurring in 2012, are identified. Their observational and kinematic properties are analyzed and compared to those of regular CMEs. Solar eruptions without clear on-disk or low coronal signatures can lead to unexpected space weather impacts, since many early warning signs for significant space weather activity are not present in these events. A better understanding of their initiation mechanism(s) will considerably improve the ability to predict such space weather events.

astro-ph.SR↗

arXiv2012

The SWAP EUV Imaging Telescope Part I: Instrument Overview and Pre-Flight Testing

The Sun Watcher with Active Pixels and Image Processing (SWAP) is an EUV solar telescope on board ESA's Project for Onboard Autonomy 2 (PROBA2) mission launched on 2 November 2009. SWAP has a spectral bandpass centered on 17.4 nm and provides images of the low solar corona over a 54x54 arcmin field-of-view with 3.2 arcsec pixels and an imaging cadence of about two minutes. SWAP is designed to monitor all space-weather-relevant events and features in the low solar corona. Given the limited resources of the PROBA2 microsatellite, the SWAP telescope is designed with various innovative technologies, including an off-axis optical design and a CMOS-APS detector. This article provides reference documentation for users of the SWAP image data.

astro-ph.IM↗