SearcharxivSearch

arXiv subjects

E. Mannila

Publications and source records attributed to E. Mannila.

3 recordsLinked to original sources

Equivalence of flexible stripline and coaxial cables for superconducting qubit control and readout pulses

We report a comparative study on microwave control lines for a transmon qubit using: (i) flexible stripline transmission lines, and (ii) semi-rigid coaxial cables. During each experiment we performed repeated measurements of the energy relaxation and coherence times of a transmon qubit using one of the wiring configurations. Each measurement run spanned 70 h to 250 h of measurement time, and four separate cooldowns were performed so that each configuration could be tested twice. From these datasets we observe that changing the microwave control lines from coaxial cables to flexible stripline transmission lines does not have a measurable effect on coherence compared to thermal cycling the system, or random coherence fluctuations. Our results open up the possibility of large scale integration of qubit control lines with integrated component with planar layouts on flexible substrate.

quant-ph

InAs nanowire with epitaxial aluminium as a single-electron transistor with fixed tunnel barriers

We report on fabrication of single-electron transistors using InAs nanowires with epitaxial aluminium with fixed tunnel barriers made of aluminium oxide. The devices exhibit a hard superconducting gap induced by the proximized aluminium cover shell and they behave as metallic single-electron transistors. In contrast to the typical few channel contacts in semiconducting devices, our approach forms opaque multichannel contacts to a semiconducting wire and thus provides a complementary way to study them. In addition, we confirm that unwanted extra quantum dots can appear at the surface of the nanowire. Their presence is prevented in our devices, and also by inserting a protective layer of GaAs between the InAs and Al, the latter being suitable for standard measurement methods.

cond-mat.mes-hall

On-chip error counting for hybrid metallic single-electron turnstiles

We perform in-situ detection of individual electrons pumped through a single-electron turnstile based on ultrasmall normal metal - insulator - superconductor tunnel junctions. In our setup, limited by the detector bandwidth, at low repetition rates we observe errorless sequential transfer of up to several hundred electrons through the system. At faster pumping speeds up to 100 kHz, we show relative error rates down to 10^-3, comparable to typical values obtained from measurements of average pumped current in non-optimized individual turnstiles. The work constitutes an initial step towards a self-referenced current standard realized with metallic single-electron turnstiles, complementing approaches based on semiconductor quantum dot pumps. It is the first demonstration of on-chip pumping error detection at operation frequencies exceeding the detector bandwidth, in a configuration where the average pumped current can be simultaneously measured. The scheme in which electrons are counted from the superconducting lead of the turnstile, instead of direct probing of the normal metal island, also enables studies of fundamental higher-order tunneling processes in the hybrid structures, previously not in reach with simpler configurations.

cond-mat.mes-hall