arXiv subjects

E. S. Sadki

Publications and source records attributed to E. S. Sadki.

4 recordsLinked to original sources

arXiv2014

Temperature Dependence of the Electrical Transport Properties of Multilayer Graphene

Multilayer graphene (MLG) thin films are deposited on silicon oxide substrates by mechanical exfoliation (or 'scotch-tape method') from Kish graphite. The thickness and number of layers are determined from both Atomic Force Microscopy (AFM) and Raman Spectroscopy. Electrical terminals are deposited on MLGs in a four-probe configuration by electron-beam lithography, gold/titanium thermal evaporation, and lift-off. The electrical resistance is measured from room temperature down to 2 K. The electrical resistance of the MLGs shows an increase with decreasing temperature, and then decreases after reaching a maximum value. These results are compared with recent experimental and theoretical data from the literature.

cond-mat.mes-hall↗

arXiv2013

Embedding a carbon nanotube across the diameter of a solid state nanopore

A fabrication method for positioning and embedding a single-walled carbon nanotube (SWNT) across the diameter of a solid state nanopore is presented. Chemical vapor deposition (CVD) is used to grow SWNTs over arrays of focused ion beam (FIB) milled pores in a thin silicon nitride membrane. This typically yields at least one pore whose diameter is centrally crossed by a SWNT. The final diameter of the FIB pore is adjusted to create a nanopore of any desired diameter by atomic layer deposition (ALD), simultaneously embedding and insulating the SWNT everywhere but in the region that crosses the diameter of the final nanopore, where it remains pristine and bare. This nanotube-articulated nanopore is an important step towards the realization of a new type of detector for biomolecule sensing and electronic characterization, including DNA sequencing.

physics.bio-ph↗

arXiv2004

Focused-ion-beam-induced deposition of superconducting nanowires

Superconducting nanowires, with a critical temperature of 5.2 K, have been synthesized using an ion-beam-induced deposition, with a Gallium focused ion beam and Tungsten Carboxyl, W(CO)6, as precursor. The films are amorphous, with atomic concentrations of about 40, 40, and 20 % for W, C, and Ga, respectively. Zero Kelvin values of the upper critical field and coherence length of 9.5 T and 5.9 nm, respectively, are deduced from the resistivity data at different applied magnetic fields. The critical current density is Jc= 1.5 10^5 A/cm2 at 3 K. This technique can be used as a template-free fabrication method for superconducting devices.

cond-mat.supr-con↗

arXiv2000

Effects of interlayer coupling on the irreversibility lines of NbN/AlN superconducting multilayers

We have studied the temperature dependence of the in-plane resistivity of NbN/AlN multilayer samples with varying insulating layer thickness in magnetic fields up to 7 Tesla parallel and perpendicular to the films. The upper critical field shows a crossover from 2D to 3D behavior in parallel fields. The irreversibility lines have the form (1-T/Tc)^alpha, where alpha varies from 4/3 to 2 with increasing anisotropy. The results are consistent with simultaneous melting and decoupling transitions for low anisotropy sample, and with melting of decoupled pancakes in the superconducting layers for higher anisotropy samples.

cond-mat.supr-con↗