arXiv subjects

Edoardo Trabaldo

Publications and source records attributed to Edoardo Trabaldo.

7 recordsLinked to original sources

arXiv2022

Mapping the phase diagram of a YBa$_2$Cu$_3$O$_{7-δ}$ nanowire through electromigration

We use electromigration (EM) to tune the oxygen content of YBa$_2$Cu$_3$O$_{7-δ}$ (YBCO) nanowi\-res. During EM, the dopant oxygen atoms in the nanowire are moved under the combined effect of electrostatic force and Joule heating. The EM current can be tuned to either deplete or replenish nanowires with oxygen, allowing fine tuning of its hole doping level. Electrical transport measurements and Kelvin probe microscopy corroborate good homogeneity of the doping level along the electromigrated nanowires. Thus, EM provides an effective method to study transport properties of YBCO in a wide doping range at the nanoscale in one and the same device.

cond-mat.supr-con↗

arXiv2019

Untwinned YBa$_2$Cu$_3$O$_{7-δ}$ thin films on MgO substrates: a platform to study strain effects on the local orders in cuprates

We have grown untwinned YBa$_2$Cu$_3$O$_{7-δ}$ (YBCO) films on (110) MgO substrates that were pre-annealed at high temperature in oxygen atmosphere. The annealing results in surface reconstruction with shallow facets, which induce the suppression of the YBCO twinning domains, and the preferential alignment of the CuO chains along one of the in-plane directions of the substrate. Because of the large mismatch between the in-plane lattice parameters of film and substrate, the strain induced by the MgO into the YBCO layer is strong and very peculiar. The YBCO film is compressed, with respect to the bulk, and presents a unidirectional buckling of the atomic planes, along the chains' direction, due to a deformation of the copper-oxygen octahedra. The YBCO films, which can be grown with thicknesses down to few unit cells and oxygen doping levels spanning most of the superconducting dome, are patterned into nanowires with dimensions down to 50 nm. The anisotropies due to the untwinning state are preserved in these structures; moreover, additional anisotropies appear, in ultrathin structures where strain effects become more pronounced. Such untwinned and compressively strained films can therefore be used as a platform to study the interplay between strain and the various local orders in the normal state of YBCO.

cond-mat.supr-con↗

arXiv2019

Fabrication and electrical transport characterization of high quality underdoped YBa$_2$Cu$_3$O$_{7-δ}$ nanowires

We present the fabrication and electrical transport characterization of underdoped YBa$_2$Cu$_3$O$_{7-δ}$ nanowires. The nanowires have been realized without any protective capping layer and they show transport properties similar to those of the parent thin film, demonstrating that they have not been damaged by the nanopatterning. The current-voltage characteristics of the underdoped nanowires show large hysteretic voltage switching at the critical current, in contrast to the flux-flow like characteristics of optimally doped nanostructures, indicating the formation of a self-stabilizing hot spot. These results open up new possibilities of using the underdoped nanowires for single photon detection and for exploring the underdoped side of the YBa$_2$Cu$_3$O$_{7-δ}$ phase diagram at the nanoscale.

cond-mat.supr-con↗

arXiv2019

High transparency Bi2Se3 topological insulator nanoribbon Josephson junctions with low resistive noise properties

Bi$_2$Se$_3$ nanoribbons, grown by catalyst-free Physical Vapour Deposition, have been used to fabricate high quality Josephson junctions with Al superconducting electrodes. The conductance spectra (dI/dV) of the junctions show clear dip-peak structures characteristic of multiple Andreev reflections. The temperature dependence of the dip-peak features reveals a highly transparent Al/Bi$_2$Se$_3$ topological insulator nanoribbon interface and Josephson junction barrier. This is supported by the high values of the Bi$_2$Se$_3$ induced gap and of I$_c$R$_n$ (I$_c$ critical current, R$_n$ normal resistance of the junction) product both of the order of 160 $μ$eV, a value close to the Al gap. The devices present an extremely low relative resistance noise below 1$\times$10$^{-12}$ $μ$m$^2$/Hz comparable to the best Al tunnel junctions, which indicates a high stability in the transmission coefficients of transport channels. The ideal Al/Bi$_2$Se$_3$ interface properties, perfect transparency for Cooper pair transport in conjunction with low resistive noise make these junctions a suitable platform for further studies of the induced topological superconductivity and Majorana bound states physics.

cond-mat.supr-con↗

arXiv2019

SQUID magnetometer based on Grooved Dayem nanobridges and a flux transformer

We report noise measurements performed on a SQUID magnetometer implementing Grooved Dayem nanobridge of YBCO as weak-links. The SQUID shows magnetic flux noise as low as 10 $μΦ_0$/Hz$^{0.5}$. The magnetometer is realized by coupling the SQUID to a flux transformer with a two-level coupling scheme using a flip-chip approach. This improves the effective area of the SQUID and result in a magnetic field noise of 50 fT/Hz$^{0.5}$ at T=77 K.

cond-mat.supr-con↗

arXiv2019

Grooved Dayem nanobridges as building blocks of high-performance YBa$_2$Cu$_3$O$_{7-δ}$ SQUID magnetometers

We present noise measurements performed on a YBa$_2$Cu$_3$O$_{7-δ}$ nanoscale weak-link-based magnetometer consisting of a Superconducting QUantum Interference Device (SQUID) galvanically coupled to a $3.5 \times 3.5~$mm$^2$ pick-up loop, reaching white flux noise levels and magnetic noise levels as low as $6~μΦ_0 / \sqrt{\mathrm{Hz}}$ and $100$~fT/$\sqrt{\mathrm{Hz}}$ at $T=77$~K, respectively. The low noise is achieved by introducing Grooved Dayem Bridges (GDBs), a new concept of weak-link. A fabrication technique has been developed for the realization of nanoscale grooved bridges, which substitutes standard Dayem bridge weak links. The introduction of these novel key blocks reduces the parasitic inductance of the weak links and increases the differential resistance of the SQUIDs. This greatly improves the device performance, thus resulting in a reduction of the white noise.

cond-mat.supr-con↗

arXiv2017

Probing the phase diagram of cuprates with YBa$_2$Cu$_3$O$_{7-δ}$ thin films and nanowires

We have grown and characterized 30 nm thick YBa$_2$Cu$_3$O$_{7-δ}$ (YBCO) films, deposited by pulsed laser deposition on both MgO (110) and SrTiO$_3$ (001) substrates, which induce opposite strain to the superconducting layer. By carefully tuning the in-situ post-annealing oxygen pressure, we achieved, in a reproducible way, films at different oxygen doping, spanning from the slightly overdoped down to the strongly underdoped region of the phase diagram. The transport properties of the films, investigated through resistance versus temperature measurements, are in perfect qualitative agreement with single crystals. Starting from these films, we have also successfully fabricated nanowires with widths down to 65 nm, at different oxygen doping. The nanostructures exhibit characteristic temperatures (as the critical temperature $T_{\mathrm{c}}$ and the pseudogap temperature $T^*$) similar to those of the as-grown films and carry critical current densities $J_{\mathrm{c}}$ close to the critical depairing value, limited by vortex entry. This implies that the superconducting and the normal state properties of underdoped YBCO are preserved in our films, and they can be studied as a function of the dimensionality of the system, down to the nanoscale.

cond-mat.supr-con↗