arXiv subjects

Ekaterina Al-Tavil

Publications and source records attributed to Ekaterina Al-Tavil.

2 recordsLinked to original sources

arXiv2026

Frequency-resolved decoherence spectroscopy of a semiconductor charge qubit coupled to a high-impedance resonator

Superconducting resonators coupled to semiconductor quantum dots provide a powerful platform to investigate light-matter interaction and decoherence mechanisms in solid-state quantum systems. Here we study a hybrid circuit quantum electrodynamics architecture consisting of a GaAs double-quantum-dot charge qubit capacitively coupled to a high-impedance, frequency-tunable SQUID-array resonator. By tuning the qubit transition frequency over the range $ω_\mathrm{q}/2π\sim 3$-$6$ GHz, we perform frequency-resolved decoherence spectroscopy of the charge qubit across a broad energy window. Time-resolved measurements enable us to disentangle relaxation and pure dephasing processes and to identify distinct decoherence regimes as a function of qubit frequency. We find that at lower frequencies ($\leq 4.5$ GHz) dephasing dominates the qubit linewidth, whereas at higher frequencies energy relaxation becomes the leading contribution. The measured frequency dependence of the relaxation rate exhibits a cubic scaling, consistent with charge-qubit decay dominated by coupling to a piezoelectric phonon bath and providing frequency-resolved access to the corresponding phonon-induced spectral density. Our results show that hybrid semiconductor--superconducting circuits can serve as sensitive spectroscopic tools to probe microscopic decoherence mechanisms relevant for a wide range of hybrid quantum devices.

cond-mat.mes-hall↗

arXiv2019

Fabrication and characterization of aluminum SQUID transmission lines

We report on the fabrication and characterization of 50 Ohms, flux-tunable, low-loss, SQUID-based transmission lines. The fabrication process relies on the deposition of a thin dielectric layer (few tens of nanometers) via Atomic Layer Deposition (ALD) on top of a SQUID array, the whole structure is then covered by a non-superconducting metallic top ground plane. We present experimental results from five different samples. We systematically characterize their microscopic parameters by measuring the propagating phase in these structures. We also investigate losses and discriminate conductor from dielectric losses. This fabrication method offers several advantages. First, the SQUID array fabrication does not rely on a Niobium tri-layer process but on a simpler double angle evaporation technique. Second, ALD provides high quality dielectric leading to low-loss devices. Further, the SQUID array fabrication is based on a standard, all-aluminum process, allowing direct integration with superconducting qubits. Moreover, our devices are in-situ flux tunable, allowing mitigation of incertitude inherent to any fabrication process. Finally, the unit cell being a single SQUID (no extra ground capacitance is needed), it is straightforward to modulate the size of the unit cell periodically, allowing band-engineering. This fabrication process can be directly applied to traveling wave parametric amplifiers.

cond-mat.mes-hall↗