SearcharxivSearch

arXiv subjects

Eliana Bortot

Publications and source records attributed to Eliana Bortot.

3 recordsLinked to original sources

Analysis of multilayer electro-active tubes under different constraints

Dielectric elastomers are an emerging class of highly deformable electro-active materials employed for electromechanical transduction technology. For practical applications, the design of such transducers requires a model accounting for insulation of the active membrane, non-perfectly compliant behaviour of the electrodes or interaction of the transducer with a soft actuated body. To this end, a three-layer model, in which the active membrane is embedded between two soft passive layers, can be formulated. In this paper, the theory of nonlinear electro-elasticity for heterogeneous soft dielectrics is used to investigate the electromechanical response of multilayer electro-active tubes---formed either by the active membrane only (single-layer tube) or by the coated active membrane (multilayer tube). Numerical results showing the influence of the mechanical and the geometrical properties of the soft coating layers on the electromechanical response of the active membrane are presented for different constraint conditions.

cond-mat.soft

Analysis of viscoelastic soft dielectric elastomer generators operating in an electrical circuit

A predicting model for soft Dielectric Elastomer Generators (DEGs) must consider a realistic model of the electromechanical behaviour of the elastomer filling, the variable capacitor and of the electrical circuit connecting all elements of the device. In this paper such an objective is achieved by proposing a complete framework for reliable simulations of soft energy harvesters. In particular, a simple electrical circuit is realised by connecting the capacitor, stretched periodically by a source of mechanical work, in parallel with a battery through a diode and with an electrical load consuming the energy produced. The electrical model comprises resistances simulating the effect of the electrodes and of the conductivity current invariably present through the dielectric film. As these devices undergo a high number of electro-mechanical loading cycles at large deformation, the time-dependent response of the material must be taken into account as it strongly affects the generator outcome. To this end, the viscoelastic behaviour of the polymer and the possible change of permittivity with strains are analysed carefully by means of a proposed coupled electro-viscoelastic constitutive model, calibrated on experimental data available in the literature for an incompressible polyacrilate elastomer (3M VHB4910). Numerical results showing the importance of time-dependent behaviour on the evaluation of performance of DEGs for different loading conditions, namely equi-biaxial and uniaxial, are reported in the final section.

cond-mat.soft

Performance of soft dielectric laminated composites

This paper contains a thorough investigation of the performance of electrically activated layered soft dielectric composite actuators under plane deformation. Noting that the activation can be induced controlling either the voltage or the surface charge, the overall behaviour of the system is obtained via homogenization at large strains taking either the macroscopic electric field or the macroscopic electric displacement field as independent electrical variable. The performance of a two-phase composite actuator compared to that of the homogeneous case is highlighted for few boundary-value problems and for different values of stiffness and permittivity ratios between constituents being significant for applications, where the soft matrix is reinforced by a relatively small volume fraction of a stiff and high-permittivity phase. For charge-controlled devices, it is shown that some composite layouts admit, on one hand, the occurrence of pull-in/snap-through instabilities that can be exploited to design release-actuated systems, on the other, the possibility of thickening at increasing surface charge density.

cond-mat.soft