arXiv subjects

Emilio Ancillotti

Publications and source records attributed to Emilio Ancillotti.

3 recordsLinked to original sources

arXiv2025

Toward Hybrid COTS-based LiFi/WiFi Networks with QoS Requirements in Mobile Environments

We consider a hybrid LiFi/WiFi network consisting of commercially available equipment, for mobile scenarios, where WiFi backs up communications, through vertical handovers, in case of insufficient LiFi QoS. When QoS requirements in terms of goodput are defined, tools are needed to anticipate the vertical handover relative to what is possible with standard basic mechanisms, which are only based on a complete loss of connectivity. We introduce two such mechanisms, based on signal power level readings and CRC-based packet failure ratio, and evaluate their performance in terms of QoS-outage duration, considering as a benchmark an existing baseline solution based on the detection of a connectivity loss. In doing this, we provide insights into the interplay between such mechanisms and the LiFi protocol channel adaptation capabilities. Our experimental results are obtained using a lab-scale testbed equipped with a conveyor belt, which allows us to accurately replicate experiments with devices in motion. With the proposed methods, we achieve QoS outages below one second for a QoS level of 20 Mbps, compared to outage durations of a few seconds obtained with the baseline solution.

cs.NI↗

arXiv2022

Performance evaluation of switching between WiFi and LiFi under a common virtual network interface

We consider a hybrid wireless local area network composed of both WiFi and LiFi Access Points (AP) and wireless devices. Each device is identified in the network by a unique IP address, using a virtual network interface obtained by bonding the WiFi and LiFi physical interfaces, implemented through commercially available products. We measure the time it takes to switch between the two physical interfaces and its impact on the traffic flow, under different settings of the mechanisms used by the interface bonding driver. Different specific triggering events are considered for the switch, namely: an (simulated) interface malfunctioning or unintended shutdown, a signal loss, and a manual (intended) switch. Our experimental results show that the different types of triggering events have an impact on the time it takes to reconfigure the currently active physical interface (which is used by the virtual interface to send/receive data), with connection recovery times ranging from few tens milliseconds to few seconds. This entails a packet loss on active flows which, in the worst case, we quantify in a maximum loss of up to 1% of the traffic flowing during 1 second.

cs.NI↗

arXiv2022

A reinforcement learning-based link quality estimation strategy for RPL and its impact on topology management

Over the last few years, standardisation efforts are consolidating the role of the Routing Protocol for LowPower and Lossy Networks (RPL) as the standard routing protocol for IPv6 based Wireless Sensor Networks (WSNs). Although many core functionalities are well defined, others are left implementation dependent. Among them, the definition of an efficient link quality estimation (LQE) strategy is of paramount importance, as it influences significantly both the quality of the selected network routes and nodes' energy consumption. In this paper, we present RLProbe, a novel strategy for link quality monitoring in RPL, which accurately measures link quality with minimal overhead and energy waste. To achieve this goal, RLProbe leverages both synchronous and asynchronous monitoring schemes to maintain up-to-date information on link quality and to promptly react to sudden topology changes, e.g. due to mobility. Our solution relies on a reinforcement learning model to drive the monitoring procedures in order to minimise the overhead caused by active probing operations. The performance of the proposed solution is assessed by means of simulations and real experiments. Results demonstrated that RLProbe helps in effectively improving packet loss rates, allowing nodes to promptly react to link quality variations as well as to link failures due to node mobility.

cs.NI↗