arXiv subjects

Eric Eyraud

Publications and source records attributed to Eric Eyraud.

8 recordsLinked to original sources

arXiv2026

An ultracompact dilution refrigerator for fast quantum device characterization

Rapid thermal cycling is a central bottleneck in the development of superconducting quantum devices: conventional dilution refrigerators require cooldowns of a day or more and substantial cryogenic infrastructure, which throttles the fabricate-measure-redesign loop. We present an ultracompact dilution refrigerator (3 kg in mass and 100 mm in diameter) that completes a full cooldown-warm-up cycle to a base temperature of 70 mK in 1.2 hours when unloaded, and in 2.1 hours when fully equipped with the microwave wiring required for qubit measurements, while delivering 20 microW of cooling power at 100 mK. We validate the platform through a complete characterization of a two-fluxonium device: we extract the full circuit Hamiltonian by two-tone spectroscopy, measure energy-relaxation and coherence times, and benchmark single-qubit control. Although the relaxation time is limited by the base temperature of the system, we reach a single-qubit gate fidelity of up to 99%, at the coherence limit set by our operating temperature. These results demonstrate that compact, fast-cycling dilution refrigeration can support state-of-the-art quantum-device characterization without sacrificing measurement quality, offering a practical route to high-throughput quantum-hardware development.

quant-ph↗

arXiv2026

Origins of microwave losses in superconducting circuits made with silicon-on-insulator substrates

Silicon-on-insulator technology is widely used to fabricate silicon based devices, from advanced transistors to photonic circuits or nanomechanical systems. Integrating low loss superconducting quantum circuits with silicon-on-insulator substrates enables to couple the advantages offered by the mature silicon technology to the exquisite sensitivity of superconducting circuits. The natural approach, inherited from research in superconducting microwave devices, is to use a substrate made with highly resistive silicon, known for its low level of microwave losses. In this work, using superconducting microwave resonators, we show that counterintuitively, standard resistivity silicon-on-insulator substrates perform better than high resistivity silicon-on-insulator substrates at cryogenic temperatures. In the latter case, the presence of a parasitic sheet conduction at the interface between bulk silicon and silicon oxide acts as the dominant loss mechanism. This parasitic sheet can be suppressed using substrates with intentionally induced traps. In such substrates, losses are ultimately limited by the dielectric losses of the silicon oxide layer. These substrates offer interesting perspectives for the development of superconducting nanoelectromechanical systems. First, the release, i.e. the removal of the silicon oxide, could be limited to the moving parts, thereby maintaining the mechanical integrity of the rest of the device. Additionally, such structure would enhance heat evacuation into the bulk of the substrate which is an issue in current devices such as microwave-to-optics converters.

cond-mat.mes-hall↗

arXiv2025

Gate-tunable spectrum and charge dispersion mitigation in a graphene superconducting qubit

Controlling the energy spectrum of quantum-coherent superconducting circuits, i.e. the energies of excited states, the circuit anharmonicity and the states' charge dispersion, is essential for designing performant qubits. This control is usually achieved by adjusting the circuit's geometry. In-situ control is traditionally obtained via an external magnetic field, in the case of tunnel Josephson junctions. More recently, semiconductor-weak-links-based Josephson junctions have emerged as an alternative building block with the advantage of tunability via the electric-field effect. Gate-tunable Josephson junctions have been succesfully integrated in superconducting circuits using for instance semiconducting nanowires or two-dimensional electron gases. In this work we demonstrate, in a graphene superconducting circuit, a large gate-tunability of qubit properties: frequency, anharmonicity and charge dispersion. We rationalize these features using a model considering the transmission of Cooper pairs through Andreev bound states. Noticeably, we show that the high transmission of Cooper pairs in such weak link strongly suppresses the charge dispersion. Our work illustrates the potential for graphene-based qubits as versatile building-blocks in advanced quantum circuits.

cond-mat.mes-hall↗

arXiv2025

Gain compression in Josephson Traveling-Wave Parametric Amplifiers

Superconducting traveling-wave parametric amplifiers (TWPAs) are increasingly used in various applications, including quantum computing, quantum sensing, and dark matter detection. However, one important characteristic of these amplifiers, gain compression, has not received much attention. As a result, there is a lack of comprehensive experimental exploration of this phenomenon in the existing literature. In this study, we present an experimental investigation of gain compression in a Josephson traveling-wave parametric amplifier based on a four-wave mixing process. We have implemented a novel setup to monitor the complex transmission of both the pump and signal tones, which allows us to simultaneously track pump depletion and signal amplification as functions of signal power and frequency across the entire bandwidth of the device. Our findings indicate that, while pump depletion occurs during gain compression, it is not the only mechanism involved in the saturation of a TWPA. Power-induced phase-matching processes also take place within the device. This study provides valuable insights for optimizing TWPAs for applications that require high total input power, such as multiplexed qubit readout or broadband photon emission.

quant-ph↗

arXiv2024

A Traveling Wave Parametric Amplifier Isolator

Superconducting traveling-wave parametric amplifiers have emerged as highly promising devices for near-quantum-limited broadband amplification of microwave signals and are essential for high quantum-efficiency microwave readout lines. Built-in isolation, as well as gain, would address their primary limitation: lack of true directionality due to potential backward travel of electromagnetic radiation to their input port. Here, we demonstrate a Josephson-junction-based traveling-wave parametric amplifier isolator. It utilizes third-order nonlinearity for amplification and second-order nonlinearity for frequency upconversion of backward propagating modes to provide reverse isolation. These parametric processes, enhanced by a novel phase matching mechanism, exhibit gain of up to 20~dB and reverse isolation of up to 30~dB over a static 3~dB bandwidth greater than 500~MHz, while keeping near-quantum limited added noise. This demonstration of a broadband truly directional amplifier ultimately paves the way towards broadband quantum-limited microwave amplification lines without bulky magnetic isolators and with inhibited back-action.

quant-ph↗

arXiv2024

Direct measurement of a $\sin(2\varphi)$ current phase relation in a graphene superconducting quantum interference device

In a Josephson junction, the current phase relation relates the phase variation of the superconducting order parameter, $\varphi$, between the two superconducting leads connected through a weak link, to the dissipationless current . This relation is the fingerprint of the junction. It is usually dominated by a $\sin(\varphi)$ harmonic, however its precise knowledge is necessary to design superconducting quantum circuits with tailored properties. Here, we directly measure the current phase relation of a superconducting quantum interference device made with gate-tunable graphene Josephson junctions and we show that it can behave as a $\sin(2\varphi)$ Josephson element, free of the traditionally dominant $\sin(\varphi)$ harmonic. Such element will be instrumental for the development of superconducting quantum bits protected from decoherence.

cond-mat.mes-hall↗

arXiv2023

Broadband parametric amplification for multiplexed SiMOS quantum dot signals

Spins in semiconductor quantum dots hold great promise as building blocks of quantum processors. Trapping them in SiMOS transistor-like devices eases future industrial scale fabrication. Among the potentially scalable readout solutions, gate-based dispersive radiofrequency reflectometry only requires the already existing transistor gates to readout a quantum dot state, relieving the need for additional elements. In this effort towards scalability, traveling-wave superconducting parametric amplifiers significantly enhance the readout signal-to-noise ratio (SNR) by reducing the noise below typical cryogenic low-noise amplifiers, while offering a broad amplification band, essential to multiplex the readout of multiple resonators. In this work, we demonstrate a 3GHz gate-based reflectometry readout of electron charge states trapped in quantum dots formed in SiMOS multi-gate devices, with SNR enhanced thanks to a Josephson traveling-wave parametric amplifier (JTWPA). The broad, tunable 2GHz amplification bandwidth combined with more than 10dB ON/OFF SNR improvement of the JTWPA enables frequency and time division multiplexed readout of interdot transitions, and noise performance near the quantum limit. In addition, owing to a design without superconducting loops and with a metallic ground plane, the JTWPA is flux insensitive and shows stable performances up to a magnetic field of 1.2T at the quantum dot device, compatible with standard SiMOS spin qubit experiments.

cond-mat.mes-hall↗

arXiv2020

Ultrasensitive nano-optomechanical force sensor at dilution temperatures

Cooling down nanomechanical force probes is a generic strategy to enhance their sensitivities through the concomitant reduction of their thermal noise and mechanical damping rates. However, heat conduction mechanisms become less efficient at low temperatures, which renders difficult to ensure and verify their proper thermalization. To operate with minimally perturbing measurements, we implement optomechanical readout techniques operating in the photon counting regime to probe the dynamics of suspended silicon carbide nanowires in a dilution refrigerator. Readout of their vibrations is realized with sub-picowatt optical powers, in a regime where less than one photon is collected per oscillation period. We demonstrate their thermalization down to $32\pm2$ mK and report on record sensitivities for scanning probe force sensors, at the $40\,\rm zN/Hz^{1/2}$ level, with a sensitivity to lateral force field gradients in the fN/m range. This work opens the road toward nanomechanical vectorial imaging of faint forces at dilution temperatures, at minimal excitation levels.

cond-mat.mes-hall↗