Searcharxiv⌕ Search

arXiv subjects

Eric Lauga

Publications and source records attributed to Eric Lauga.

205 records · Page 12Linked to original sources

Swimming in circles: Motion of bacteria near solid boundaries

Near a solid boundary, E. coli swims in clockwise circular motion. We provide a hydrodynamic model for this behavior. We show that circular trajectories are natural consequences of force-free and torque-free swimming, and the hydrodynamic interactions with the boundary, which also leads to a hydrodynamic trapping of the cells close to the surface. We compare the results of the model with experimental data and obtain reasonable agreement. In particular, we show that the radius of curvature of the trajectory increases with the length of the bacterium body.

cond-mat.soft↗

Brownian motion near a partial-slip boundary: A local probe of the no-slip condition

Motivated by experimental evidence of violations of the no-slip boundary condition for liquid flow in micron-scale geometries, we propose a simple, complementary experimental technique that has certain advantages over previous studies. Instead of relying on externally-induced flow or probe motion, we suggest that colloidal diffusivity near solid surfaces contains signatures of the degree of fluid slip exhibited on those surfaces. To investigate, we calculate the image system for point forces (Stokeslets) oriented perpendicular and parallel to a surface with a finite slip length, analogous to Blake's solution for a Stokeslet near a no-slip wall. Notably, the image system for the point source and perpendicular Stokeslet contain the same singularities as Blake's solution; however, each is distributed along a line with a magnitude that decays exponentially over the slip length. The image system for the parallel Stokeslet involves a larger set of fundamental singularities, whose magnitude does not decay exponentially from the surface. Using these image systems, we determine the wall-induced correction to the diffusivity of a small spherical particle located `far' from the wall. We also calculate the coupled diffusivities between multiple particles near a partially-slipping wall. Because, in general, the diffusivity depends on `local' wall conditions, patterned surfaces would allow differential measurements to be obtained within a single experimental cell, eliminating potential cell-to-cell variability encountered in previous experiments. In addition to motivating the proposed experiments, our solutions for point forces and sources near a partial-slip wall will be useful for boundary integral calculations in slip systems.

cond-mat.soft↗

A note on the stability of slip channel flows

We consider the influence of slip boundary conditions on the modal and non-modal stability of pressure-driven channel flows. In accordance with previous results by Gersting (1974) (Phys. Fluids, 17) but in contradiction with the recent investigation of Chu (2004) (C.R. Mecanique, 332), we show that slip increases significantly the value of the critical Reynolds number for linear instability. The non-modal stability analysis however reveals that the slip has a very weak influence on the maximum transient energy growth of perturbations at subcritical Reynolds numbers. Slip boundary conditions are therefore not likely to have a significant effect on the transition to turbulence in channel flows.

physics.flu-dyn↗

Evaporation-driven assembly of colloidal particles

Colloidal particles absorbed at the interface of a liquid droplet arrange into unique packings during slow evaporation (Manoharan et al. Science 301 pp 483-487). We present a numerical and theoretical analysis of the packing selection problem. The selection of a unique packing arises almost entirely from geometrical constraints during the drying.

cond-mat.soft↗

Shear-dependent apparent slip on hydrophobic surfaces: The Mattress Model

Recent experiments (Zhu & Granick (2001) Phys. Rev. Lett. 87 096105) have measured a large shear dependent fluid slip at partially wetting fluid-solid surfaces. We present a simple model for such slip, motivated by the recent observations of nanobubbles on hydrophobic surfaces. The model considers the dynamic response of bubbles to change in hydrodynamic pressure due to the oscillation of a solid surface. Both the compression and diffusion of gas in the bubbles decrease the force on the oscillating surface by a ``leaking mattress'' effect, thereby creating an apparent shear-dependent slip. With bubbles similar to those observed by atomic force microscopy to date, the model is found to lead to force decreases consistent with the experimental measurements of Zhu & Granick.

cond-mat.soft↗

Apparent slip due to the motion of suspended particles in flows of electrolyte solutions

We consider pressure-driven flows of electrolyte solutions in small channels or capillaries in which tracer particles are used to probe velocity profiles. Under the assumption that the double layer is thin compared to the channel dimensions, we show that the flow-induced streaming electric field can create an apparent slip velocity for the motion of the particles, even if the flow velocity still satisfies the no-slip boundary condition. In this case, tracking of particle would lead to the wrong conclusion that the no-slip boundary condition is violated. We evaluate the apparent slip length, compare with experiments, and discuss the implications of these results.

physics.flu-dyn↗

Three-dimensional flows in slowly-varying planar geometries

We consider laminar flow in channels constrained geometrically to remain between two parallel planes; this geometry is typical of microchannels obtained with a single step by current microfabrication techniques. For pressure-driven Stokes flow in this geometry and assuming that the channel dimensions change slowly in the streamwise direction, we show that the velocity component perpendicular to the constraint plane cannot be zero unless the channel has both constant curvature and constant cross-sectional width. This result implies that it is, in principle, possible to design "planar mixers", i.e. passive mixers for channels that are constrained to lie in a flat layer using only streamwise variations of their in-plane dimensions. Numerical results are presented for the case of a channel with sinusoidally varying width.

cond-mat.soft↗