SearcharxivSearch

arXiv subjects

Eva M. Herzig

Publications and source records attributed to Eva M. Herzig.

3 recordsLinked to original sources

Rethinking Charge Transport and Recombination in Donor-diluted Organic Solar Cells

We systematically investigate PM6:Y12 bulk-heterojunction solar cells with donor fractions ranging from 1% to 45%, linking morphology, charge transport, and recombination to device performance. Complementary structural and spectroscopic methods reveal that a percolating PM6 network forms even at below 5% donor content, with lamellar stacking and vertical composition gradients that do not hinder the charge extraction. The reduction of the effective active layer conductivity towards low donor fractions obeys a three-dimensional percolation model, indicating that charge transport is governed by network topology rather without a pronounced percolation threshold. A transition from nongeminate Langevin recombination to a dispersive Smoluchowski-type loss occurs below 5% donor fraction. The latter regime is also nongeminate, i.e., pertains to recombination of the total charge carrier density. Correspondingly, we observe that the Langevin reduction in the higher donor fractions - mostly dominated by redissociation of electron-hole pairs after encounter - changes towards low donor fractions: in these cases, the nongeminate loss rate exceeds the prediction of the Langevin model. This regime coincides with increasing transport resistance due to topology-limited hole conduction, leading to reduced fill factors despite a high retained charge-generation efficiency. Our results demonstrate that strong donor dilution preserves photogeneration if a continuous donor network is maintained, and unveil how topology-controlled transport and non-Langevin recombination jointly define the performance limits of donor-diluted organic solar blends.

cond-mat.mtrl-sci

Traps and transport resistance: the next frontier for stable state-of-the-art non-fullerene acceptor solar cells

Stability is one of the most important challenges facing organic solar cells (OSC) on their path to commercialization. In the high-performance material system PM6:Y6 studied here, investigate degradation mechanisms of inverted photovoltaic devices. We have identified two distinct degradation pathways: one requires presence of both illumination and oxygen and features a short-circuit current reduction, the other one is induced thermally and marked by severe losses of open-circuit voltage and fill factor. We focus our investigation on the thermally accelerated degradation. Our findings show that bulk material properties and interfaces remain remarkably stable, however, aging-induced defect state formation in the active layer remains the primary cause of thermal degradation. The increased trap density leads to higher non-radiative recombination, which limits open-circuit voltage and lowers charge carrier mobility in the photoactive layer. Furthermore, we find the trap-induced transport resistance to be the major reason for the drop in fill factor. Our results suggest that device lifetimes could be significantly increased by marginally suppressing trap formation, leading to a bright future for OSC.

cond-mat.mtrl-sci

A multi-purpose modular system for high-resolution microscopy at high hydrostatic pressure

We have developed a modular system for high-resolution microscopy at high hydrostatic pressure. The system consists of a pressurised cell of volume ~100 microlitres, a temperature controlled holder, a ram and a piston. We have made each of these components in several versions which can be interchanged to allow a wide range of applications. Here, we report two pressure cells with pressure ranges 0.1-700MPa and 0.1-100MPa, which can be combined with hollow or solid rams and pistons. Our system is designed to work with fluorescent samples (using a confocal or epifluorescence microscope), but also allows for transmitted light microscopy via the hollow ram and piston. The system allows precise control of pressure and temperature [-20-70C], as well as rapid pressure quenching. We demonstrate its performance and versatility with two applications: time-resolved imaging of colloidal phase transitions caused by pressure changes between 0.1MPa and 101MPa, and imaging the growth of Escherichia coli bacteria at 50MPa. We also show that the isotropic-nematic phase transition of pentyl-cyanobiphenyl (5CB) liquid crystal provides a simple, convenient and accurate method for calibrating pressure in the range 0.1-200MPa.

physics.optics