Searcharxiv⌕ Search

arXiv subjects

Evgeni Il'ichev

Publications and source records attributed to Evgeni Il'ichev.

11 recordsLinked to original sources

Measuring coherent dynamics of a superconducting qubit in an open waveguide

We measured the relaxation and decoherence rates of a superconducting transmon qubit in a resonator-free setting. In our experiments, the qubit is coupled to an open coplanar waveguide such that the transmission of microwaves through this line depends on the qubit's state. To determine the occupation of the first excited qubit energy level, we introduced a two-pulse technique. The first applied pulse, at a frequency close to the eigenfrequency of the qubit, serves to excite the qubit. A second pulse is then used for probing the transition between the first and second excited energy levels. Utilizing this measurement technique allowed for the reconstruction of the relaxation dynamics and Rabi oscillations. Furthermore, we demonstrate the consistency between the extracted parameters and the corresponding estimations from frequency-domain measurements.

quant-ph↗

Sharpness of the Berezinskii-Kosterlitz-Thouless transition in ultrathin NbN films

We present a comprehensive investigation of the Berezinskii-Kosterlitz-Thouless (BKT) transition in ultrathin strongly disordered NbN films. Measurements of resistance, current-voltage characteristics and kinetic inductance on the very same device reveal a consistent picture of a sharp unbinding transition of vortex-antivortex pairs that fit standard renormalization group theory without extra assumptions in terms of inhomogeneity. Our experiments demonstrate that the previously observed broadening of the transition is not an intrinsic feature of strongly disordered superconductors and provide a clean starting point for the study of dynamical effects at the BKT transition.

cond-mat.supr-con↗

Simulating long-distance entanglement in quantum spin chains by superconducting flux qubits

We investigate the performance of superconducting flux qubits for the adiabatic quantum simulation of long distance entanglement (LDE), namely a finite ground-state entanglement between the end spins of a quantum spin chain with open boundary conditions. As such, LDE can be considered an elementary precursor of edge modes and topological order. We discuss two possible implementations which simulate open chains with uniform bulk and weak end bonds, either with Ising or with XX nearest-neighbor interactions. In both cases we discuss a suitable protocol for the adiabatic preparation of the ground state in the physical regimes featuring LDE. In the first case the adiabatic manipulation and the Ising interactions are realized using dc currents, while in the second case microwaves fields are used to control the smoothness of the transformation and to realize the effective XX interactions. We demonstrate the adiabatic preparation of the end-to-end entanglement in chains of four qubits with realistic parameters and on a relatively fast time scale.

quant-ph↗

Toroidal qubits: naturally-decoupled quiet artificial atoms

The requirements of quantum computations impose high demands on the level of qubit protection from perturbations; in particular, from those produced by the environment. Here we propose a superconducting flux qubit design that is naturally protected from ambient noise. This decoupling is due to the qubit interacting with the electromagnetic field only through its toroidal moment, which provides an unusual qubit-field interaction.

quant-ph↗

Implementation of a Quantum Metamaterial

Manipulating the propagation of electromagnetic waves through sub-wavelength sized artificial structures is the core function of metamaterials. Resonant structures, such as split ring resonators, play the role of artificial "atoms" and shape the magnetic response. Superconducting metamaterials moved into the spotlight for their very low ohmic losses and the possibility to tune their resonance frequency by exploiting the Josephson inductance. Moreover, the nonlinear nature of the Josephson inductance enables the fabrication of truly artificial atoms. Arrays of such superconducting quantum two-level systems (qubits) can be used for the implementation of a quantum metamaterial. Here, we perform an experiment in which 20 superconducting flux qubits are embedded into a single microwave resonator. The phase of the signal transmitted through the resonator reveals the collective resonant coupling of up to 8 qubits. Quantum circuits of many artificial atoms based on this proof-of-principle experiment offer a wide range of prospects, from detecting single microwave photons to phase switching, quantum birefringence and superradiant phase transitions.

quant-ph↗

Frequency Division Multiplexing Readout and Simultaneous Manipulation of an Array of Flux Qubits

An important desired ingredient of superconducting quantum circuits is a readout scheme whose complexity does not increase with the number of qubits involved in the measurement. Here, we present a readout scheme employing a single microwave line, which enables simultaneous readout of multiple qubits. Consequently, scaling up superconducting qubit circuits is no longer limited by the readout apparatus. Parallel readout of 6 flux qubits using a frequency division multiplexing technique is demonstrated, as well as simultaneous manipulation and time resolved measurement of 3 qubits. We discuss how this technique can be scaled up to read out hundreds of qubits on a chip.

quant-ph↗

Measuring the influence of Casimir energy on superconducting phase transitions: a cross-correlation data analysis

The ALADIN experiment aims at observing how the critical magnetic field of a superconducting Aluminum film is modified, when it constitutes one of the reflecting surfaces of a Casimir cavity. If successful, such an observation would reveal the influence of vacuum energy on the superconducting phase transition. In this paper a rigorous analysis of experimental data is reported, the results are discussed and compared with theoretical predictions based on Lifshitz theory of dispersion forces, and the BCS formula for the optical conductivity of superconductors. The main novelty with respect to a previous data analysis by some of the authors, is the use of a cross-correlation method which is more rigorous and leads to better estimates.

hep-th↗

Low noise cryogenic system for the measurement of Casimir energy in rigid cavities

We report on preliminary results on the measurement of variations of the Casimir energy in rigid cavities through its influence on the superconducting transition of in-cavity aluminium (Al) thin films. After a description of the experimental apparatus we report on a measurement made with thermal photons, discussing its implications for the zero-point photons case. Finally we show the preliminary results for the zero-point case.

quant-ph↗

The Aladin2 experiment: sensitivity study

Aladin2 is an experiment devoted to the first measurement of variations of Casimir energy in a rigid body. The main short-term scientific motivation relies on the possibility of the first demonstration of a phase transition influenced by vacuum fluctuations while, in the long term and in the mainframe of the cosmological constant problem, it can be regarded as the first step towards a measurement of the weight of vacuum energy. In this paper, after a presentation of the guiding principle of the measurement, the experimental apparatus and sensitivity studies on final cavities will be presented.

quant-ph↗

The Aladin2 experiment: status and perspectives

Aladin2 is an experiment devoted to the first measurement of variations of Casimir energy in a rigid cavity. The main scientific motivation relies on the possibility of the first demonstration of a phase transition influenced by vacuum fluctuations. The guiding principle of the measurement, based on the behaviour of the critical field for an in-cavity superconducting film, will be only briefly recalled. In this paper, after an introduction to the long term motivations, the experimental apparatus and the results of the first measurement of sensitivity will be presented in detail, particularly in comparison with the expected signal. Last, the most important steps towards the final measurement will be discussed.

quant-ph↗