arXiv subjects

F. Stivoli

Publications and source records attributed to F. Stivoli.

6 recordsLinked to original sources

arXiv2011

Estimating the tensor-to-scalar ratio and the effect of residual foreground contamination

We consider future balloon-borne and ground-based suborbital experiments designed to search for inflationary gravitational waves, and investigate the impact of residual foregrounds that remain in the estimated cosmic microwave background maps. This is achieved by propagating foreground modelling uncertainties from the component separation, under the assumption of a spatially uniform foreground frequency scaling, through to the power spectrum estimates, and up to measurement of the tensor to scalar ratio in the parameter estimation step. We characterize the error covariance due to subtracted foregrounds, and find it to be subdominant compared to instrumental noise and sample variance in our simulated data analysis. We model the unsubtracted residual foreground contribution using a two-parameter power law and show that marginalization over these foreground parameters is effective in accounting for a bias due to excess foreground power at low $\ell$. We conclude that, at least in the suborbital experimental setups we have simulated, foreground errors may be modeled and propagated up to parameter estimation with only a slight degradation of the target sensitivity of these experiments derived neglecting the presence of the foregrounds.

astro-ph.CO↗

arXiv2010

Maximum likelihood, parametric component separation and CMB B-mode detection in suborbital experiments

We investigate the performance of the parametric Maximum Likelihood component separation method in the context of the CMB B-mode signal detection and its characterization by small-scale CMB suborbital experiments. We consider high-resolution (FWHM=8') balloon-borne and ground-based observatories mapping low dust-contrast sky areas of 400 and 1000 square degrees, in three frequency channels, 150, 250, 410 GHz, and 90, 150, 220 GHz, with sensitivity of order 1 to 10 micro-K per beam-size pixel. These are chosen to be representative of some of the proposed, next-generation, bolometric experiments. We study the residual foreground contributions left in the recovered CMB maps in the pixel and harmonic domain and discuss their impact on a determination of the tensor-to-scalar ratio, r. In particular, we find that the residuals derived from the simulated data of the considered balloon-borne observatories are sufficiently low not to be relevant for the B-mode science. However, the ground-based observatories are in need of some external information to permit satisfactory cleaning. We find that if such information is indeed available in the latter case, both the ground-based and balloon-borne experiments can detect the values of r as low as ~0.04 at 95% confidence level. The contribution of the foreground residuals to these limits is found to be then subdominant and these are driven by the statistical uncertainty due to CMB, including E-to-B leakage, and noise. We emphasize that reaching such levels will require a sufficient control of the level of systematic effects present in the data.

astro-ph.CO↗

arXiv2009

Maximum Likelihood algorithm for parametric component separation in CMB experiments

We discuss an approach to the component separation of microwave, multi-frequency sky maps as those typically produced from Cosmic Microwave Background (CMB) Anisotropy data sets. The algorithm is based on the two step, parametric, likelihood-based technique recently elaborated on by Eriksen et al., (2006), where the foreground spectral parameters are estimated prior to the actual separation of the components. In contrast with the previous approaches, we accomplish the former task with help of an analytically-derived likelihood function for the spectral parameters, which, we show, yields estimates equal to the maximum likelihood values of the full multi-dimensional data problem. We then use these estimates to perform the second step via the standard, generalized-least-square-like procedure. We demonstrate that the proposed approach is equivalent to a direct maximization of the full data likelihood, which is recast in a computationally tractable form. We use the corresponding curvature matrices to characterize statistical properties of the recovered parameters. We incorporate in the formalism some of the essential features of the CMB data sets, such as inhomogeneous pixel domain noise, unknown map offsets as well as calibration errors and study their consequences for the separation. We find that the calibration is likely to have a dominant effect on the precision of the spectral parameter determination for a realistic CMB experiment. We apply the algorithm to simulated data and discuss the results. Our focus is on partial-sky, total-intensity and polarization, CMB experiments such as planned balloon-borne and ground-based efforts, however, the techniques presented here should be also applicable to the full-sky data as for instance, those produced by WMAP and anticipated from Planck.

astro-ph↗

arXiv2008

Component separation methods for the Planck mission

The Planck satellite will map the full sky at nine frequencies from 30 to 857 GHz. The CMB intensity and polarization that are its prime targets are contaminated by foreground emission. The goal of this paper is to compare proposed methods for separating CMB from foregrounds based on their different spectral and spatial characteristics, and to separate the foregrounds into components of different physical origin. A component separation challenge has been organized, based on a set of realistically complex simulations of sky emission. Several methods including those based on internal template subtraction, maximum entropy method, parametric method, spatial and harmonic cross correlation methods, and independent component analysis have been tested. Different methods proved to be effective in cleaning the CMB maps from foreground contamination, in reconstructing maps of diffuse Galactic emissions, and in detecting point sources and thermal Sunyaev-Zeldovich signals. The power spectrum of the residuals is, on the largest scales, four orders of magnitude lower than that of the input Galaxy power spectrum at the foreground minimum. The CMB power spectrum was accurately recovered up to the sixth acoustic peak. The point source detection limit reaches 100 mJy, and about 2300 clusters are detected via the thermal SZ effect on two thirds of the sky. We have found that no single method performs best for all scientific objectives. We foresee that the final component separation pipeline for Planck will involve a combination of methods and iterations between processing steps targeted at different objectives such as diffuse component separation, spectral estimation and compact source extraction.

astro-ph↗

arXiv2007

WMAP 3yr data with the CCA: anomalous emission and impact of component separation on the CMB power spectrum

The Correlated Component Analysis (CCA) allows us to estimate how the different diffuse emissions mix in CMB experiments, exploiting also complementary information from other surveys. It is especially useful to deal with possible additional components. An application of CCA to WMAP maps assuming that only the canonical Galactic emissions are present, highlights the widespread presence of a spectrally flat "synchrotron" component, largely uncorrelated with the synchrotron template, suggesting that an additional foreground is indeed required. We have tested various spectral shapes for such component, namely a power law as expected if it is flat synchrotron, and two spectral shapes that may fit the spinning dust emission: a parabola in the logS - log(frequency) plane, and a grey body. Quality tests applied to the reconstructed CMB maps clearly disfavour two of the models. The CMB power spectra, estimated from CMB maps reconstructed exploiting the three surviving foreground models, are generally consistent with the WMAP ones, although at least one of them gives a significantly higher quadrupole moment than found by the WMAP team. Taking foreground modeling uncertainties into account, we find that the mean quadrupole amplitude for the three "good" models is less than 1 sigma below the expectation from the standard LambdaCDM model. Also the other reported deviations from model predictions are found not to be statistically significant, except for the excess power at l~40. We confirm the evidence for a marked North-South asymmetry in the large scale (l < 20) CMB anisotropies. We also present a first, albeit preliminary, all-sky map of the "anomalous" component.

astro-ph↗

arXiv2006

CMB signal in WMAP 3yr data with FastICA

We present an application of the fast Independent Component Analysis (FastICA) to the WMAP 3yr data with the goal of extracting the CMB signal. We evaluate the confidence of our results by means of Monte Carlo simulations including CMB, foreground contaminations and instrumental noise specific of each WMAP frequency band. We perform a complete analysis involving all or a subset of the WMAP channels in order to select the optimal combination for CMB extraction, using the frequency scaling of the reconstructed component as a figure of merit. We found that the combination KQVW provides the best CMB frequency scaling, indicating that the low frequency foreground contamination in Q, V and W bands is better traced by the emission in the K band. The CMB angular power spectrum is recovered up to the degree scale, it is consistent within errors for all WMAP channel combination considered, and in close agreement with the WMAP 3yr results. We perform a statistical analysis of the recovered CMB pattern, and confirm the sky asymmetry reported in several previous works with independent techniques.

astro-ph↗