arXiv subjects

Fabio Federici

Publications and source records attributed to Fabio Federici.

7 recordsLinked to original sources

arXiv2024

Evolution of radiation profiles in a strongly baffled divertor on MAST Upgrade

Plasma detachment involves interactions of the plasma with impurities and neutral particles, leading to significant losses of plasma power, momentum, and particles. Accurate mapping of plasma emissivity in the divertor and X-point region is essential for assessing the relationship between particle flux and radiative detachment. The recently validated InfraRed Video Bolometer (IRVB) diagnostic, in MAST-U enables this mapping with higher spatial resolution than more established methods like resistive bolometers. In previous preliminary work, the evolution of radiative detachment was characterised in L-mode (power entering the scrape-off layer, PSOL ~0.4MW). With a conventional divertor the inner leg consistently detached ahead of the outer leg, and radiative detachment preceded particle flux detachment. This work presents results also from the third MAST-U experimental campaign, fuelled from the low field side instead of the high field side, including Ohmic and beam heated L-mode shots (with a power exiting the core up to PSOL ~1-1.5MW). The radiation peak moves upstream from the target at lower upstream densities than the ion target flux roll-over (typically considered the detachment onset), while the inner leg detaches before the outer one. The movement of the radiation is in partial agreement with the expectations from the DLS model, predicting a sudden shift from the target to the X-point. The energy confinement is found to be related to detachment, but there seems to be some margin between the radiation on the inner leg reaching the X-point and confinement being affected, a beneficial characteristic if it could be extrapolated to future reactors. For increasing PSOL the particle flux roll over is almost unaffected, while radiative detachment occurs at higher density in both legs, but much higher on the outer, suggesting an uneven distribution of the power exiting the core.

physics.plasm-ph↗

arXiv2024

Increased accuracy and signal-to-noise ratio through recent improvements in Infra-Red Video Bolometer fabrication and calibration

The Infra-Red Video Bolometer (IRVB) is a diagnostic equipped with an infra-red camera that measures the total radiated power in thousands of LOSs within a large field of view (FOV). Recently validated in MAST-U, it offers a high spatial resolution map of the radiated power in the divertor region, where large gradients are expected. The IRVB's sensing element comprises a thin layer of high Z absorbing material, typically Platinum, usually coated with Carbon to reduce reflections. It is here explored the possibility of using a relatively inert material like Titanium, that can be produced in layers up to 1mum compared to 2.5mum for Pt, and then coat it with Pt of the desired thickness (0.3mum per side here) and Carbon. This leads to a higher temperature signal (2 to 3 times), and better spatial resolution (about 4 times), resulting in higher accuracy in the measured power. This assembly is also expected to improve foil uniformity, as the Pt layer is obtained via deposition rather than mechanical processes. Given its multi-material composition, measuring the thermal properties of the foil assembly is vital. Various methods using a calibrated laser as a heat source have been developed, analysing the temperature profile shape or fitting the calculated laser power for different intensities and frequencies. It is here presented a simpler approach, that relies on analysing the separate components of the foil heat equation for a single laser exposure in a given area. This can then be iterated over the entire foil to capture local deviations.

physics.plasm-ph↗

arXiv2024

Effect of detachment on Magnum-PSI ELM-like pulses: I. Direct observations and qualitative results

Conditions similar to those at the end of the divertor leg in a tokamak were replicated in the linear plasma machine Magnum-PSI. The neutral pressure in the target chamber is then increased to cause the target to transition from an attached to a detached state. Superimposed to this steady state regime, ELM-like pulses are reproduced, resulting in a sudden increase in plasma temperature and density, such that the heat flux increases transiently by half an order of magnitude. Visible light emission, target thermography, and Thomson scattering are used to demonstrate that the higher the neutral pressure the more energy is removed from the ELM-like pulse in the volume. If the neutral pressure is sufficiently high, the ELM-like pulse can be prevented from affecting the target and the plasma energy is fully dissipated in the volume instead (ID 4 in Table 1). The visible light images allow the division of the ELM-plasma interaction process of ELM energy dissipation into 3 "stages" ranging from no dissipation to full dissipation (the target plasma is detached). In the second publication related to this study, spectroscopic data is analysed with a Bayesian approach, to acquire insights into the significance of molecular processes in dissipating the plasma energy and particles.

physics.plasm-ph↗

arXiv2023

Effect of detachment on Magnum-PSI ELM-like pulses: II. Spectroscopic analysis and role of molecular assisted reactions

The linear plasma machine Magnum-PSI can replicate similar conditions to those found in a tokamak at the end of the divertor leg. A dedicated capacitor bank, in parallel to the plasma source, can release a sudden burst of energy, leading to a rapid increase in plasma temperature and density, resulting in a transient heat flux increase of half of an order of magnitude, a so called ELM-like pulse. Throughout both the steady state and the pulse, the neutral pressure in the target chamber is then increased, causing the target to transition from an attached to a detached state. In the first paper related to this study\cite{Federici} direct measurements of the plasma properties are used to qualitatively determine the effect of detachment on the ELM-like pulse. This is used to show the importance of molecular assisted reactions. Molecular processes, and especially molecular activated dissociation, are found to be important in the exchange of potential energy with the plasma, while less so in radiating the energy from the ELM-like pulse. At low target chamber pressure, the plasma generated via ionisation during the part of the ELM-like pulse with the higher temperature is more than that produced by the plasma source, a unique case in linear machines. At high target chamber pressure molecular activated recombination contributes up to a third of the total recombination rate, contributing to the reduction of the target particle flux. Some metrics that estimate the energy lost by the plasma per interactions with neutrals, potentially relevant for the portion of the tokamak divertor leg below $\sim10eV$, are then tentatively obtained.

physics.plasm-ph↗

arXiv2023

The role of plasma-atom and molecule interactions on power \& particle balance during detachment on the MAST Upgrade Super-X divertor

This paper shows first quantitative analysis of the detachment processes in the MAST Upgrade Super-X divertor (SXD). We identify an unprecedented impact of plasma-molecular interactions involving molecular ions (likely $D_2^+$), resulting in strong ion sinks (Molecular Activated Recombination - MAR), leading to a reduction of ion target flux. The MAR ion sinks exceed the divertor ion sources before electron-ion recombination (EIR) starts to occur, suggesting that significant ionisation occurs outside of the divertor chamber. In the EIR region, $T_e \ll 0.2$ eV is observed and MAR remains significant in these deep detached phases. The total ion sink strength demonstrates the capability for particle (ion) exhaust in the Super-X Configuration. Molecular Activated Dissociation (MAD) is the dominant volumetric neutral atom creation process can lead to an electron cooling of 20\% of $P_{SOL}$. The measured total radiative power losses \emph{in the divertor chamber} are consistent with inferred hydrogenic radiative power losses. This suggests that intrinsic divertor impurity radiation, despite the carbon walls, is minor in the divertor chamber. This contrasts previous TCV results, which may be associated with enhanced plasma-neutral interactions and reduced chemical erosion in the detached, tightly baffled SXD. The above observations have also been observed in higher heat flux (narrower SOL width) type I ELMy H-mode discharges. This provides evidence that the characterisation in this paper may be general.

physics.plasm-ph↗

arXiv2022

Spectroscopic investigations of detachment on the MAST Upgrade Super-X divertor

We present the first analysis of the atomic and molecular processes at play during detachment in the MAST-U Super-X divertor using divertor spectroscopy data. Our analysis indicates detachment in the MAST-U Super-X divertor can be separated into four sequential phases: First, the ionisation region detaches from the target at detachment onset leaving a region of increased molecular densities downstream. The plasma interacts with these molecules, resulting in molecular ions ($D_2^+$ and/or $D_2^- \rightarrow D + D^-$) that further react with the plasma leading to Molecular Activated Recombination and Dissociation (MAR and MAD), which results in excited atoms and significant Balmer line emission. Second, the MAR region detaches from the target leaving a sub-eV temperature region downstream. Third, an onset of strong emission from electron-ion recombination (EIR) ensues. Finally, the electron density decays near the target, resulting in a density front moving upstream. The analysis in this paper indicates that plasma-molecule interactions have a larger impact than previously reported and play a critical role in the intensity and interpretation of hydrogen atomic line emission characteristics on MAST-U. Furthermore, we find that the Fulcher band emission profile in the divertor can be used as a proxy for the ionisation region and may also be employed as a plasma temperature diagnostic for improving the separation of hydrogenic emission arising from electron-impact excitation and that from plasma-molecular interactions. We provide evidences for the presence of low electron temperatures ($<0.5$ eV) during detachment phases III-IV based on quantitative spectroscopy analysis, a Boltzmann relation of the high-n Balmer line transitions together with an analysis of the brightness of high-n Balmer lines.

physics.plasm-ph↗

arXiv2021

The role of plasma-molecule interactions on power and particle balance during detachment on the TCV tokamak

This paper shows experimental results from the TCV tokamak that indicate plasma-molecule interactions involving $D_2^+$ and possibly $D^-$ play an important role as sinks of energy (through hydrogenic radiation as well as dissociation) and particles during divertor detachment if low target temperatures ($< 3$ eV) are achieved. Both molecular activated recombination (MAR) and ion source reduction due to a power limitation effect are shown to be important in reducing the ion target flux during a density ramp. In contrast, the electron-ion recombination (EIR) ion sink is too small to play an important role in reducing the ion target flux. MAR or EIR do not occur during $N_2$ seeding induced detachment as the target temperatures are not sufficiently low. The impact of $D_2^+$ is shown to be underestimated in present (vibrationally unresolved) SOLPS-ITER simulations, which could result from an underestimated $D_2 + D^+ \rightarrow D_2^+ + D$ rate. The converged SOLPS-ITER simulations are post-processed with alternative reaction rates, resulting in considerable contributions of $D_2^+$ to particle and power losses as well as dissociation below the $D_2$ dissociation area. Those findings are in quantitative agreement with the experimental results.

physics.plasm-ph↗