SearcharxivSearch

arXiv subjects

Fayu Wan

Publications and source records attributed to Fayu Wan.

2 recordsLinked to original sources

Channel Knowledge Map Enabled Low-Complexity Dynamic Radio Environment Reconstruction

Accurate and timely radio environment reconstruction is important but challenging under particularly dynamic transmitter configurations. The conventional methods such as compressed sensing (CS), Kriging method or U-Net typically require environment measurements and reconstruction overhead for radio environment updating as the transmitter locations or radiation patterns change. In this paper, we propose a novel channel knowledge map (CKM)-enabled dynamic radio environment reconstruction method for efficient radio map updating. Specifically, the recently proposed CKM can store reusable path-level propagation knowledge that is decoupled from the transmitter-side radiation characteristics. We can leverage CKM for lightweight forward radio map generation as the transmitter locations and radiation patterns are known, without requiring new target-map measurements. Simulation results show that the proposed method outperforms CS, Kriging, and U-Net in reconstruction accuracy and exhibits strong robustness performance under dynamic transmitter configurations, which demonstrates the potential of the proposed method for flexible and efficient radio environment reconstruction in dynamic wireless networks.

eess.SP

Experimental Study of Magnetic Near-Field Microstrip Electronic Probe for PCB EMC Emission Measurement

An experimental study on magnetic near-field (NF) scanning of printed circuit board (PCB) emission radiation is developed in this paper. The design and installation of the electromagnetic (EM) NF scanner is introduced. The test bed of magnetic NF emission in the microwave frequency range is described. The methodology of the microstrip magnetic NF probe is discussed. The probe calibration process was performed following the IEC 61967-1 NF scanning standard. The NF scanner functioning is tested with passive microstrip circuit square loop probe and device under test (DUT) PCB radiation in the test plan positioned at 1-mm above the ground plane. Based on the standard test with I-shape 50-$\Omega$ transmission line (TL), the calibration process of radiated magnetic field was validated by comparison between HFSS__ simulation and experimentation in very wideband frequency from 0.1-GHz to 3-GHz. Then, a nonstandard TL based DUT was experimented. Accordingly, the cartographies of scanned magnetic NF at two different test frequencies, 2 GHz and 3 GHz, are discussed. The NF scanner is under development for targeting the EMC radiated emission of PCB dedicated to operate in 6G wireless communication.

cs.NI