arXiv subjects

Feby Jose

Publications and source records attributed to Feby Jose.

4 recordsLinked to original sources

arXiv2016

Reduction of residual stress in AlN thin Films synthesized by magnetron sputtering technique

We report the reduction in residual stress of AlN thin films and also the crystal structure, surface morphology and nanomechanical properties of magnetron sputtered as a function of substrate temperature (Ts, 35 - 600 ?C). The residual stress of these films was calculated by sin2 technique and found that they are varying from tensile to compression with temperature (Ts). Evolution of crystalline growth of AlN films was studied by GIXRD and transmission electron microscopy (TEM) and a preferred a-axis orientation was observed at 400 ?C. The cross-sectional TEM micrograph and selected area electron difraction (SAED) of this film exhibited a high degree of orientation as well as a columnar structure. Hardness (H) measured by Nanoindentation technique on these films ranged between 12.8 - 19 GPa.

cond-mat.mtrl-sci↗

arXiv2014

Preferentially orientated E-beam TiN thin films using focused jet of nitrogen gas

A modified electron beam evaporator has been used judiciously to synthesize TiN thin films with (111) preferred orientation. This new design involved in creating local plasma by accelerating the secondary electrons emitted from the evaporating ingot by a positively biased semi-cylindrical anode plate kept in the vicinity and a jet of N2 gas has been focused towards the substrate as a reactive gas. We have observed a preferred orientation (111) with 25 degree angle to the surface normal and this was confirmed by pole figure analysis. The phenomenon of preferred orientation (111) has been explained based on the rate of evaporation. The residual stress by the classical sin2psi technique did not yield any tangible result due to the preferred orientation. The hardness and modulus measured by nanoindentation technique was around 19.5 GPa and 214 GPa. The continuous multicycle indentation test on these films exhibited a stress relaxation.

cond-mat.mtrl-sci↗

arXiv2013

Temperature dependence of dielectric constants in Titanium Nitride

The temperature dependence of optical constants of titanium nitride thin film is investigated using spectroscopic ellipsometry between 1.4 to 5 eV in the temperature range 300 K to 650 K in steps of 50 K. The real and imaginary parts of the dielectric functions "1(E) and "2(E) increase marginally with increase in temperature. A Drude Lorentz dielectric analysis based on free electron and oscillator model are carried out to describe the temperature behavior. The parameters of the Lorentz oscillator model also showed that the relaxation time decreased with temperature while the oscillator energies increased. This study shows that owing to marginal change in the refractive index with temperature, titanium nitride can be employed for surface plasmon sensor applications even in environments where rise in temperature is imminent.

cond-mat.mtrl-sci↗

arXiv2012

Optical properties and hardness of highly a-axis oriented AlN films

This paper reports optical and nanomechanical properties of seldom studied highly a-axis oriented AlN thin films for the first time. These films were deposited by reactive DC magnetron sputtering technique at an optimal target to substrate distance of 180 mm. Bragg-Brentano geometry X-ray and rocking curve (FWHM = 52 arcsec) studies confirmed the preferred orientation. Spectroscopic ellipsometry revealed that these films exhibit a refractive index of 1.93 at a wavelength of 546 nm. The hardness and elastic modulus of these films were 17 GPa and 190 GPa, respectively. The mechanical properties obtained here are much higher than the earlier reported and therefore can be useful as protective coating in thermo printing devices, piezoelectric films in bulk acoustic wave resonators.

cond-mat.mtrl-sci↗