arXiv subjects

Federico Paoletti

Publications and source records attributed to Federico Paoletti.

12 recordsLinked to original sources

arXiv2026

Modeling Newtonian noise of acoustic origin in the Virgo gravitational wave detector

Since the first gravitational-wave (GW) detection of September 14th 2015 and with hundreds of gravitational-wave sources identified by the LIGO-Virgo-KAGRA network, GW have produced many important results in astrophysics and fundamental physics. Along with planned new data takings, current detectors will be upgraded and new project, such as Einstein Telescope and Cosmic Explorer, are under study. Among noises limiting low frequency sensitivity, vibro-acoustic noises are particularly important. In this work, we focus on the gravity gradient noise (also called Newtonian noise) of acoustic origin, which refers to the small fluctuations in the gravity field resulting from the acoustic pressure field present in the experimental areas of the detector. The induced noise is quantified in an original way, using a detailed nu- merical acoustic model of the experimental room, when the pressure field is excited by the air conditioning system. The method is used for Virgo, but it can be easily extended for future detectors and used to guide the design of caverns and experimental areas.

physics.class-ph↗

arXiv2026

Reducing the Virgo site infrastructure noise in preparation of the O4 observing run

The heating, ventilation and air conditioning systems serving the experimental halls of the Virgo gravitational wave interferometer generate low-frequency noise - namely below 100 Hz - of seismic, acoustic, and electromagnetic origin. Such disturbances have repeatedly affected the interferometer sensitivity throughout its operational history, with particularly notable impacts during the third observing run. In preparation for the fourth run, a comprehensive investigation was carried out to identify the most critical noise sources within this infrastructure and to trace their transmission paths into the experimental areas. This manuscript presents the methodology and results of the noise characterization campaign, together with the design, implementation and assessment of targeted mitigation measures. The technical solutions adopted, along with the operational best practices developed, provide valuable guidance for the design of low-noise environments in future gravitational-wave observatories.

astro-ph.IM↗

arXiv2024

Adaptive algorithms for low-latency cancellation of seismic Newtonian-noise at the Virgo gravitational-wave detector

A system was recently implemented in the Virgo detector to cancel noise in its data produced by seismic waves directly coupling with the suspended test masses through gravitational interaction. The data from seismometers are being filtered to produce a coherent estimate of the associated gravitational noise also known as Newtonian noise. The first implementation of the system uses a time-invariant (static) Wiener filter, which is the optimal filter for Newtonian-noise cancellation assuming that the noise is stationary. However, time variations in the form of transients and slow changes in correlations between sensors are possible and while time-variant filters are expected to cope with these variations better than a static Wiener filter, the question is what the limitations are of time-variant noise cancellation. In this study, we present a framework to study the performance limitations of time-variant noise cancellation filters and carry out a proof-of-concept with adaptive filters on seismic data at the Virgo site. We demonstrate that the adaptive filters, at least those with superior architecture, indeed significantly outperform the static Wiener filter with the residual noise remaining above the statistical error bound.

gr-qc↗

arXiv2024

Correlated 0.01Hz-40Hz seismic and Newtonian noise and its impact on future gravitational-wave detectors

We report correlations in underground seismic measurements with horizontal separations of several hundreds of meters to a few kilometers in the frequency range 0.01Hz to 40Hz. These seismic correlations could threaten science goals of planned interferometric gravitational-wave detectors such as the Einstein Telescope as well as atom interferometers such as MIGA and ELGAR. We use seismic measurements from four different sites, i.e. the former Homestake mine (USA) as well as two candidate sites for the Einstein Telescope, Sos Enattos (IT) and Euregio Maas-Rhein (NL-BE-DE) and the site housing the MIGA detector, LSBB (FR). At all sites, we observe significant coherence for at least 50% of the time in the majority of the frequency region of interest. Based on the observed correlations in the seismic fields, we predict levels of correlated Newtonian noise from body waves. We project the effect of correlated Newtonian noise from body waves on the capabilities of the triangular design of the Einstein Telescope's to observe an isotropic gravitational-wave background (GWB) and find that, even in case of the most quiet site, its sensitivity will be affected up to $\sim$20Hz. The resolvable amplitude of a GWB signal with a negatively sloped power-law behaviour would be reduced by several orders of magnitude. However, the resolvability of a power-law signal with a slope of e.g. $\alpha=0$ ($\alpha=2/3$) would be more moderately affected by a factor $\sim$ 6-9 ($\sim$3-4) in case of a low noise environment. Furthermore, we bolster confidence in our results by showing that transient noise features have a limited impact on the presented results.

gr-qc↗

arXiv2023

Design and implementation of a seismic Newtonian-noise cancellation system for the Virgo gravitational-wave detector

Terrestrial gravity perturbations caused by seismic fields produce the so-called Newtonian noise in gravitational-wave detectors, which is predicted to limit their sensitivity in the upcoming observing runs. In the past, this noise was seen as an infrastructural limitation, i.e., something that cannot be overcome without major investments to improve a detector's infrastructure. However, it is possible to have at least an indirect estimate of this noise by using the data from a large number of seismometers deployed around a detector's suspended test masses. The noise estimate can be subtracted from the gravitational-wave data; a process called Newtonian-noise cancellation (NNC). In this article, we present the design and implementation of the first NNC system at the Virgo detector as part of its AdV+ upgrade. It uses data from 110 vertical geophones deployed inside the Virgo buildings in optimized array configurations. We use a separate tiltmeter channel to test the pipeline in a proof-of-principle. The system has been running with good performance over months.

gr-qc↗

arXiv2022

External environmental noise influences on Virgo during O3

Sources of geophysical noise, such as wind, sea waves and earthquakes, can have an impact on gravitational wave interferometers causing sensitivity worsening and gaps in data taking. During the 1-year long O3 run (April 1st 2019 to March 27th 2020), the Virgo Collaboration collected a statistically significant dataset to study the response of the detector to a variety of environmental conditions. We used these data to correlate environmental parameters to global detector performance, such as observation range, duty cycle and control losses. Where possible, we identified weaknesses in the detector and we elaborated strategies to improve Virgo robustness against external disturbances for the next run O4, planned to start in summer 2022. In this article we present preliminary results of this study.

gr-qc↗

arXiv2021

Characterization of the seismic field at Virgo and improved estimates of Newtonian-noise suppression by recesses

Fluctuations of gravitational forces cause so-called Newtonian noise (NN) in gravitational-wave (GW) detectors which is expected to limit their low-frequency sensitivity in upcoming observing runs. Seismic NN is produced by seismic waves passing near a detector's suspended test masses. It is predicted to be the strongest contribution to NN. Modeling this contribution accurately is a major challenge. Arrays of seismometers were deployed at the Virgo site to characterize the seismic field near the four test masses. In this paper, we present results of a spectral analysis of the array data from one of Virgo's end buildings to identify dominant modes of the seismic field. Some of the modes can be associated with known seismic sources. Analyzing the modes over a range of frequencies, we provide a dispersion curve of Rayleigh waves. We find that the Rayleigh speed in the NN frequency band 10 Hz - 20 Hz is very low ($\lesssim$100\,m/s), which has important consequences for Virgo's seismic NN. Using the new speed estimate, we find that the recess formed under the suspended test masses by a basement level at the end buildings leads to a 10 fold reduction of seismic NN.

astro-ph.IM↗

arXiv2021

The KAGRA underground environment and lessons for the Einstein Telescope

The KAGRA gravitational-wave detector in Japan is the only operating detector hosted in an underground infrastructure. Underground sites promise a greatly reduced contribution of the environment to detector noise thereby opening the possibility to extend the observation band to frequencies well below 10 Hz. For this reason, the proposed next-generation infrastructure Einstein Telescope in Europe would be realized underground aiming for an observation band that extends from 3 Hz to several kHz. However, it is known that ambient noise in the low-frequency band 10 Hz - 20 Hz at current surface sites of the Virgo and LIGO detectors is predominantly produced by the detector infrastructure. It is of utmost importance to avoid spoiling the quality of an underground site with noisy infrastructure, at least at frequencies where this noise can turn into a detector-sensitivity limitation. In this paper, we characterize the KAGRA underground site to determine the impact of its infrastructure on environmental fields. We find that while excess seismic noise is observed, its contribution in the important band below 20 Hz is minor preserving the full potential of this site to realize a low-frequency gravitational-wave detector. Moreover, we estimate the Newtonian-noise spectra of surface and underground seismic waves and of the acoustic field inside the caverns. We find that these will likely remain a minor contribution to KAGRA's instrument noise in the foreseeable future.

astro-ph.IM↗

arXiv2020

Site-selection criteria for the Einstein Telescope

The Einstein Telescope (ET) is a proposed next-generation, underground gravitational-wave (GW) detector to be based in Europe. It will provide about an order of magnitude sensitivity increase with respect to currently operating detectors, and furthermore, extend the observation band towards lower frequencies, i.e., down to about 3Hz. One of the first decisions that needs to be made is about the future ET site following an in-depth site characterization. Site evaluation and selection is a complicated process, which takes into account science, financial, political, and socio-economic criteria. In this paper, we provide an overview of the site-selection criteria for ET, provide a formalism to evaluate the direct impact of environmental noise on ET sensitivity, and outline the necessary elements of a site-characterization campaign.

physics.ins-det↗

arXiv2018

Measurement and subtraction of Schumann resonances at gravitational-wave interferometers

Correlated magnetic noise from Schumann resonances threatens to contaminate the observation of a stochastic gravitational-wave background in interferometric detectors. In previous work, we reported on the first effort to eliminate global correlated noise from the Schumann resonances using Wiener filtering, demonstrating as much as a factor of two reduction in the coherence between magnetometers on different continents. In this work, we present results from dedicated magnetometer measurements at the Virgo and KAGRA sites, which are the first results for subtraction using data from gravitational-wave detector sites. We compare these measurements to a growing network of permanent magnetometer stations, including at the LIGO sites. We show how dedicated measurements can reduce coherence to a level consistent with uncorrelated noise. We also show the effect of mutual magnetometer attraction, arguing that magnetometers should be placed at least one meter from one another.

gr-qc↗

arXiv2018

Impact of infrasound atmospheric noise on gravity detectors used for astrophysical and geophysical applications

Density changes in the atmosphere produce a fluctuating gravity field that affect gravity strainmeters or gravity gradiometers used for the detection of gravitational-waves and for geophysical applications. This work addresses the impact of the atmospheric local gravity noise on such detectors, extending previous analyses. In particular we present the effect introduced by the building housing the detectors, and we analyze local gravity-noise suppression by constructing the detector underground. We present also new sound spectra and correlations measurements. The results obtained are important for the design of future gravitational-wave detectors and gravity gradiometers used to detect prompt gravity perturbations from earthquakes.

astro-ph.IM↗

arXiv2016

Subtraction of correlated noise in global networks of gravitational-wave interferometers

The recent discovery of merging black holes suggests that a stochastic gravitational-wave background is within reach of the advanced detector network operating at design sensitivity. However, correlated magnetic noise from Schumann resonances threatens to contaminate observation of a stochastic background. In this paper, we report on the first effort to eliminate intercontinental correlated noise from Schumann resonances using Wiener filtering. Using magnetometers as proxies for gravitational-wave detectors, we demonstrate as much as a factor of two reduction in the coherence between magnetometers on different continents. While much work remains to be done, our results constitute a proof-of-principle and motivate follow-up studies with a dedicated array of magnetometers.

gr-qc↗