arXiv subjects

Federico Perini

Publications and source records attributed to Federico Perini.

8 recordsLinked to original sources

arXiv2026

A High-frequency Geodetic VLBI Experiment for Optical Clock Comparison

An intercontinental metrological clock comparison between Italy and the Republic of Korea was performed by means of geodetic K-band VLBI observations. The comparison involved the hydrogen masers (H-masers) used at Medicina and Sejong radio telescopes. The same clocks were simultaneously compared by a satellite link and by high-precision optical clocks maintained at the National Metrology Institutes, KRISS in Korea and INRIM in Italy, and delivered to VLBI antennas via optical fiber. The H-masers frequency difference was estimated by extrapolating the clock rate from VLBI data using two geodetic VLBI software. This was subsequently compared with clock differences derived by satellite link and by local optical clocks. Results obtained with different approaches were in agreement at the level of $10^{-15}$ s/s. This pilot study demonstrates that standard high-frequency (K-band) geodetic VLBI campaigns could be a viable approach to conduct intercontinental clock comparisons, now only possible via satellite links. This uncertainty can be reduced thanks to the planned installation of new-generation, broadband, high-frequency receivers on the involved telescopes. K/Q/W-band geodetic observations will allow an improvement of the accuracy of the resulting group delays through broad bandwidth synthesis from 20 to 100 GHz. Furthermore, the Frequency Phase Transfer (FPT) method will also be explored together with the use of PCAL systems installed at the radio telescopes to improve phase stability and thus allow a better estimation of the station clock parameters.

astro-ph.IM↗

arXiv2025

Intrinsic Cross Polarization Ratio maps from all-sky observations with the SKA-Low prototype station Aperture Array Verification System 2

The low-frequency radio telescope of the Square Kilometre Array (SKA-Low), currently under construction in the remote Murchison shire in the Western Australia's outback, will observe the sky between 50 MHz and 350 MHz with unprecedented sensitivity and stringent requirements for polarization accuracy. In this work, we investigate the instrumental polarization purity of a SKA-Low prototype station by means of the Intrinsic Cross-Polarization Ratio (IXR) figure of merit. We derive all-sky experimental IXR maps using data from the Aperture Array Verification System 2 (AAVS2). The results are presented at three frequencies within the SKA-Low bandwidth (110, 160, and 230 MHz) with a quantitative comparison between observed and simulated all-sky IXR maps. Our findings show good agreement in IXR map distributions and promising consistency in their radial profiles, meeting SKA-Low's IXR specification overall. This study offers an empirical approach to verifying SKA-Low's polarization performance using all-sky observations from individual stations and will potentially support the telescope's early science commissioning phase.

astro-ph.IM↗

arXiv2023

The Northern Cross Fast Radio Burst project -- III. The FRB-magnetar connection in a sample of nearby galaxies

Fast radio bursts (FRBs) are millisecond radio transients observed at cosmological distances. The nature of their progenitors is still a matter of debate, although magnetars are invoked by most models. The proposed FRB-magnetar connection was strengthened by the discovery of an FRB-like event from the Galactic magnetar SGR J1935+2154. In this work, we aim to investigate how prevalent magnetars such as SGR J1935+2154 are within FRB progenitors. We carried out an FRB search in a sample of seven nearby (< 12 Mpc) galaxies with the Northern Cross radio telescope for a total of 692 h. We detected one 1.8 ms burst in the direction of M101 with a fluence of $58 \pm 5$ Jy ms. Its dispersion measure of 303 pc cm$^{-3}$ places it most-likely beyond M101. Considering that no significant detection comes indisputably from the selected galaxies, we place a 38 yr$^{-1}$ upper limit on the total burst rate (i.e. including the whole sample) at the 95\% confidence level. This upper limit constrains the event rate per magnetar $\lambda_{\rm mag} < 0.42$ magnetar$^{-1}$ yr$^{-1}$ or, if combined with literature observations of a similar sample of nearby galaxies, it yields a joint constraint of $\lambda_{\rm mag} < 0.25$ magnetar$^{-1}$ yr$^{-1}$. We also provide the first constraints on the expected rate of FRBs hypothetically originating from ultraluminous X-ray (ULX) sources, since some of the galaxies observed during our observational campaign host confirmed ULXs. We obtain $< 13$ yr$^{-1}$ per ULX for the total sample of galaxies observed. Our results indicate that bursts with energies $E>10^{34}$ erg from magnetars like SGR J1935+2154 appear more rarely compared to previous observations and further disfavour them as unique progenitors for the cosmological FRB population, leaving more space open to the contribution from a population of more exotic magnetars, not born via core-collapsed supernovae.

astro-ph.HE↗

arXiv2022

Optimal Dithering Configuration Mitigating Rayleigh-Backscattering-Induced Distortion in Radioastronomic Optical Fiber Systems

In the context of Radioastronomic applications where the Analog Radio-over-Fiber technology is used for the antenna downlink, detrimental nonlinearity effects arise because of the interference between the forward signal generated by the laser and the Rayleigh backscattered one which is re-forwarded by the laser itself toward the photodetector. The adoption of the so called dithering technique, which involves the direct modulation of the laser with a sinusoidal tone and takes advantage of the laser chirping phenomenon, has been proved to reduce such Rayleigh Back Scattering - induced nonlinearities. The frequency and the amplitude of the dithering tone should both be as low as possible, in order to avoid undesired collateral effects on the received spectrum as well as keep at low levels the global energy consumption. Through a comprehensive analysis of dithered Radio over Fiber systems, it is demonstrated that a progressive reduction of the dithering tone frequency affects in a peculiar fashion both the chirping characteristics of the field emitted by the laser and the spectrum pattern of the received signal at the fiber end. Accounting for the concurrent effects caused by such phenomena, optimal operating conditions are identified for the implementation of the dithering tone technique in radioastronomic systems.

astro-ph.IM↗

arXiv2021

The Engineering Development Array 2: design, performance and lessons from an SKA-Low prototype station

We present the Engineering Development Array 2, which is one of two instruments built as a second generation prototype station for the future Square Kilometre Array Low Frequency Array. The array is comprised of 256 dual-polarization dipole antennas that can work as a phased array or as a standalone interferometer. We describe the design of the array and the details of design changes from previous generation instruments, as well as the motivation for the changes. Using the array as an imaging interferometer, we measure the sensitivity of the array at five frequencies ranging from 70 to 320 MHz.

astro-ph.IM↗

arXiv2021

Characterization of the SKA1-Low prototype station Aperture Array Verification System 2

The low frequency component of the Square Kilometre Array (SKA1-Low) will be an aperture phased array located at the Murchison Radio-astronomy Observatory (MRO) site in Western Australia. It will be composed of 512 stations, each of them consisting of 256 log-periodic dual polarized antennas, and will operate in the low frequency range (50 MHz - 350 MHz) of the SKA bandwidth. The Aperture Array Verification System 2 (AAVS2), operational since late 2019, is the last full-size engineering prototype station deployed at the MRO site before the start of the SKA1-Low construction phase. The aim of this paper is to characterize the station performance through commissioning observations at six different frequencies (55, 70, 110, 160, 230 and 320 MHz) collected during its first year of activities. We describe the calibration procedure, present the resulting all-sky images and their analysis, and discuss the station calibratability and system stability. Using the difference imaging method, we also derive estimates of the SKA1-Low sensitivity for the same frequencies, and compare them to those obtained through electromagnetic simulations across the entire telescope bandwidth, finding good agreement (within $\leq 13%$). Moreover, our estimates exceed the SKA1-Low requirements at all the considered frequencies, by up to a factor of $\sim$2.3. Our results are very promising and allow an initial validation of the AAVS2 prototype station performance, which is an important step towards the upcoming SKA-Low telescope construction and science.

astro-ph.IM↗

arXiv2020

Controlling Rayleigh-Backscattering-Induced Distortion in Radio over Fiber Systems for Radioastronomic Applications

Radio over Fiber (RoF) Systems exploiting a direct modulation of the laser source are presently utilized within important Radioastronomic scenarios. Due to the particular operating conditions of some of these realizations, the phenomena which typically generate nonlinearities in RoF links for telecommunications applications can be here regarded as substantially harmless. However, these same operating conditions can make the RoF systems vulnerable to different kinds of nonlinear effects, related to the influence of the Rayleigh Backscattered signal on the transmitted one. A rigorous description of the phenomenon is performed, and an effective countermeasure to the problem is proposed and demonstrated, both theoretically and experimentally.

astro-ph.IM↗

arXiv2020

Signal Processing Firmware for the Low Frequency Aperture Array

The signal processing firmware that has been developed for the Low Frequency Aperture Array component of the Square Kilometre Array is described. The firmware is implemented on a dual FPGA board, that is capable of processing the streams from 16 dual polarization antennas. Data processing includes channelization of the sampled data for each antenna, correction for instrumental response and for geometric delays and formation of one or more beams by combining the aligned streams. The channelizer uses an oversampling polyphase filterbank architecture, allowing a frequency continuous processing of the input signal without discontinuities between spectral channels. Each board processes the streams from 16 antennas, as part of larger beamforming system, linked by standard Ethernet interconnections. There are envisaged to be 8192 of these signal processing platforms in the first phase of the Square Kilometre array so particular attention has been devoted to ensure the design is low cost and low power.

astro-ph.IM↗