arXiv subjects

Felipe Guzman Cervantes

Publications and source records attributed to Felipe Guzman Cervantes.

4 recordsLinked to original sources

arXiv2015

Optomechanical reference accelerometer

We present an optomechanical accelerometer with high dynamic range, high bandwidth and read-out noise levels below 8 $μ$g/$\sqrt{\mathrm{Hz}}$. The straightforward assembly and low cost of our device make it a prime candidate for on-site reference calibrations and autonomous navigation. We present experimental data taken with a vacuum sealed, portable prototype and deduce the achieved bias stability and scale factor accuracy. Additionally, we present a comprehensive model of the device physics that we use to analyze the fundamental noise sources and accuracy limitations of such devices.

physics.optics↗

arXiv2014

A self-calibrating optomechanical force sensor with femtonewton resolution

We report the development of an ultrasensitive optomechanical sensor designed to improve the accuracy and precision of force measurements with atomic force microscopy. The sensors reach quality factors of 4.3x10^6 and force resolution on the femtonewton scale at room temperature. Self-calibration of the sensor is accomplished using radiation pressure to create a reference force. Self-calibration enables in situ calibration of the sensor in extreme environments, such as cryogenic ultra-high vacuum. The senor technology presents a viable route to force measurements at the atomic scale with uncertainties below the percent level.

cond-mat.mes-hall↗

arXiv2014

High sensitivity optomechanical reference accelerometer over 10 kHz

We present an optically-detected mechanical accelerometer that achieves a sensitivity of 100 ng/rtHz over a bandwidth of 10kHz and is traceable. We have incorporated a Fabry-Perot fiber-optic micro-cavity that is currently capable of measuring the test-mass displacement with sensitivities of 200 am/rtHz, and whose length determination enables traceability to the International System of Units (SI). The compact size and high mQ-product achieved combined with the high sensitivity and simplicity of the implemented optical detection scheme highlight our device and this category of accelerometers, outlining a path for high sensitivity reference acceleration measurements and observations in seismology and gravimetry.

physics.optics↗

arXiv2006

Phase locking to a LISA arm: first results on a hardware model

We present the first experimental confirmation of the so-called "self-phaselocked delay interferometry". This laser frequency stabilization technique consists basically in comparing the prompt laser signal with a delayed version of itself that has been reflected in another LISA satellite 5 million km away. In our table-top experiment, the phase of a voltage-controlled oscillator is stabilized by means of a control loop based on this technique. In agreement with the theory, the measured unity gain frequency is not limited by the inverse of the used delay (1.6 microseconds). In the time domain, the system also behaves as predicted, including the appearance of a quasi-periodic "ringing" just after the lock acquisition, which decays exponentially. Its initial amplitude is smaller when the loop gain is slowly ramped up instead of suddenly switched on.

physics.ins-det↗