arXiv subjects

Feng Xi

Publications and source records attributed to Feng Xi.

29 records · Page 2Linked to original sources

arXiv2017

A General and Yet Efficient Scheme for Sub-Nyquist Radar Processing

We study the target parameter estimation for sub-Nyquist pulse-Doppler radar. Several past works have addressed this problem but either have low estimation accuracy for off-grid targets, take large computation load, or lack versatility for analog-to-information conversion (AIC) systems. To overcome these difficulties, we present a general and efficient estimation scheme. The scheme first formulates a general model in the sense that it is applicable to all AICs regardless of whether the targets are on or off the grids. The estimation of Doppler shifts and delays is performed sequentially, in which the Doppler estimation is formulated into a spatial spectrum estimation problem and the delay estimation is decomposed into a series of compressive parameter estimation problems with each corresponding to an estimated Doppler shift. By the sequential and decomposed processing, the computational complexity is substantially reduced, and by the parametric estimation techniques, the high accurate estimation is obtained. Theoretical analyses and numerical experiments show the effectiveness and the correctness of the proposed scheme.

cs.IT↗

arXiv2017

A General Sequential Delay-Doppler Estimation Scheme for Sub-Nyquist Pulse-Doppler Radar

Sequential estimation of the delay and Doppler parameters for sub-Nyquist radars by analog-to-information conversion (AIC) systems has received wide attention recently. However, the estimation methods reported are AIC-dependent and have poor performance for off-grid targets. This paper develops a general estimation scheme in the sense that it is applicable to all AICs regardless whether the targets are on or off the grids. The proposed scheme estimates the delay and Doppler parameters sequentially, in which the delay estimation is formulated into a beamspace direction-of- arrival problem and the Doppler estimation is translated into a line spectrum estimation problem. Then the well-known spatial and temporal spectrum estimation techniques are used to provide efficient and high-resolution estimates of the delay and Doppler parameters. In addition, sufficient conditions on the AIC to guarantee the successful estimation of off-grid targets are provided, while the existing conditions are mostly related to the on-grid targets. Theoretical analyses and numerical experiments show the effectiveness and the correctness of the proposed scheme.

cs.IT↗

arXiv2015

Segment-Sliding Reconstruction of Pulsed Radar Echoes with Sub-Nyquist Sampling

It has been shown that analog-to-information con- version (AIC) is an efficient scheme to perform sub-Nyquist sampling of pulsed radar echoes. However, it is often impractical, if not infeasible, to reconstruct full-range Nyquist samples because of huge storage and computational load requirements. Based on the analyses of AIC measurement system, this paper develops a novel segment-sliding reconstruction (SegSR) scheme to effectively reconstruct the Nyquist samples. The SegSR per- forms segment-by-segment reconstruction in a sliding mode and can be implemented in real-time. An important characteristic that distinguish the proposed SegSR from the existing methods is that the measurement matrix in each segment satisfies the restricted isometry property (RIP) condition. Partial support in the previous segment can be incorporated into the estimation of the Nyquist samples in the current segment. The effect of interference intro- duced from adjacent segments is theoretically analyzed, and it is revealed that the interference consists of two interference levels having different impacts to the signal reconstruction performance. With these observations, a two-step orthogonal matching pursuit (OMP) procedure is proposed for segment reconstruction, which takes into account different interference levels and partially known support of the previous segment. The proposed SegSR achieves nearly optimal reconstruction performance with a signi- ficant reduction of computational loads and storage requirements. Theoretical analyses and simulations verify its effectiveness.

cs.IT↗

arXiv2015

Gridless Quadrature Compressive Sampling with Interpolated Array Technique

Quadrature compressive sampling (QuadCS) is a sub-Nyquist sampling scheme for acquiring in-phase and quadrature (I/Q) components in radar. In this scheme, the received intermediate frequency (IF) signals are expressed as a linear combination of time-delayed and scaled replicas of the transmitted waveforms. For sparse IF signals on discrete grids of time-delay space, the QuadCS can efficiently reconstruct the I/Q components from sub-Nyquist samples. In practice, the signals are characterized by a set of unknown time-delay parameters in a continuous space. Then conventional sparse signal reconstruction will deteriorate the QuadCS reconstruction performance. This paper focuses on the reconstruction of the I/Q components with continuous delay parameters. A parametric spectrum-matched dictionary is defined, which sparsely describes the IF signals in the frequency domain by delay parameters and gain coefficients, and the QuadCS system is reexamined under the new dictionary. With the inherent structure of the QuadCS system, it is found that the estimation of delay parameters can be decoupled from that of sparse gain coefficients, yielding a beamspace direction-of-arrival (DOA) estimation formulation with a time-varying beamforming matrix. Then an interpolated beamspace DOA method is developed to perform the DOA estimation. An optimal interpolated array is established and sufficient conditions to guarantee the successful estimation of the delay parameters are derived. With the estimated delays, the gain coefficients can be conveniently determined by solving a linear least-squares problem. Extensive simulations demonstrate the superior performance of the proposed algorithm in reconstructing the sparse signals with continuous delay parameters.

cs.IT↗

arXiv2014

Pulse-Doppler Signal Processing with Quadrature Compressive Sampling

Quadrature compressive sampling (QuadCS) is a newly introduced sub-Nyquist sampling for acquiring inphase and quadrature (I/Q) components of radio-frequency signals. For applications to pulse-Doppler radars, the QuadCS outputs can be arranged in 2-dimensional data similar to that by Nyquist sampling. This paper develops a compressive sampling pulse-Doppler (CoSaPD) processing scheme from the sub-Nyquist samples. The CoSaPD scheme follows Doppler estimation/detection and range estimation and is conducted on the sub-Nyquist samples without recovering the Nyquist samples. The Doppler estimation is realized through spectrum analyzer as in classic processing. The detection is done on the Doppler bin data. The range estimation is performed through sparse recovery algorithms on the detected targets and thus the computational load is reduced. The detection threshold can be set at a low value for improving detection probability and then the introduced false targets are removed in the range estimation stage through inherent detection characteristic in the recovery algorithms. Simulation results confirm our findings. The CoSaPD scheme with the data at one eighth the Nyquist rate and for SNR above -25dB can achieve performance of the classic processing with Nyquist samples.

cs.IT↗

arXiv2014

Quadrature Compressive Sampling for Radar Signals

Quadrature sampling has been widely applied in coherent radar systems to extract in-phase and quadrature (I and Q) components in the received radar signal. However, the sampling is inefficient because the received signal contains only a small number of significant target signals. This paper incorporates the compressive sampling (CS) theory into the design of the quadrature sampling system, and develops a quadrature compressive sampling (QuadCS) system to acquire the I and Q components with low sampling rate. The QuadCS system first randomly projects the received signal into a compressive bandpass signal and then utilizes the quadrature sampling to output compressive I and Q components. The compressive outputs are used to reconstruct the I and Q components. To understand the system performance, we establish the frequency domain representation of the QuadCS system. With the waveform-matched dictionary, we prove that the QuadCS system satisfies the restricted isometry property with overwhelming probability. For K target signals in the observation interval T, simulations show that the QuadCS requires just O(Klog(BT/K)) samples to stably reconstruct the signal, where B is the signal bandwidth. The reconstructed signal-to-noise ratio decreases by 3dB for every octave increase in the target number K and increases by 3dB for every octave increase in the compressive bandwidth. Theoretical analyses and simulations verify that the proposed QuadCS is a valid system to acquire the I and Q components in the received radar signals.

cs.IT↗

arXiv2013

Chaotic Analog-to-Information Conversion with Chaotic State Modulation

Chaotic compressive sensing is a nonlinear framework for compressive sensing. Along the framework, this paper proposes a chaotic analog-to-information converter, chaotic modulation, to acquire and reconstruct band-limited sparse analog signals at sub-Nyquist rate. In the chaotic modulation, the sparse signal is randomized through state modulation of continuous-time chaotic system and one state output is sampled as compressive measurements. The reconstruction is achieved through the estimation of the sparse coefficients with principle of chaotic impulsive synchronization and Lp-norm regularized nonlinear least squares. The concept of supreme local Lyapunov exponents (SLLE) is introduced to study the reconstructablity. It is found that the sparse signals are reconstructable, if the largest SLLE of the error dynamical system is negative. As examples, the Lorenz system and Liu system excited by the sparse multi-tone signals are taken to illustrate the principle and the performance.

cs.IT↗

arXiv2013

Supreme Local Lyapunov Exponents and Chaotic Impulsive Synchronization

Impulsively synchronized chaos with criterion from conditional Lyapunov exponent is often interrupted by desynchronized bursts. This is because the Lyapunov exponent cannot characterize local instability of synchronized attractor. To predict the possibility of the local instability, we introduce a concept of supreme local Lyapunov exponent (SLLE), which is defined as supremum of local Lyapunov exponents over the attractor. The SLLE is independent of the system trajectories and therefore, can characterize the extreme expansion behavior in all local regions with prescribed finite-time interval. It is shown that the impulsively synchronized chaos can be kept forever if the largest SLLE of error dynamical systems is negative and then the burst behavior will not appear. In addition, the impulsive synchronization with negative SLLE allows large synchronizable impulsive interval, which is significant for applications.

nlin.CD↗

arXiv2013

Chaotic Analog-to-Information Conversion: Principle and Reconstructability with Parameter Identifiability

This paper proposes a chaos-based analog-to-information conversion system for the acquisition and reconstruction of sparse analog signals. The sparse signal acts as an excitation term of a continuous-time chaotic system and the compressive measurements are performed by sampling chaotic system outputs. The reconstruction is realized through the estimation of the sparse coefficients with principle of chaotic parameter estimation. With the deterministic formulation, the analysis on the reconstructability is conducted via the sensitivity matrix from the parameter identifiability of chaotic systems. For the sparsity-regularized nonlinear least squares estimation, it is shown that the sparse signal is locally reconstructable if the columns of the sparsity-regularized sensitivity matrix are linearly independent. A Lorenz system excited by the sparse multitone signal is taken as an example to illustrate the principle and the performance.

cs.IT↗

arXiv2013

Predicted alternative structure for tantalum metal under high pressure and high temperature

First-principles simulations have been performed to investigate the phase stability of tantalum metal under high pressure and high temperature (HPHT). We searched its low-energy structures globally using our developed multi-algorithm collaborative (MAC) crystal structure prediction technique. The body-centred cubic (bcc) was found to be stable at pressure up to 300 GPa. The previously reported $ω$ and \textit{A}15 structures were also reproduced successfully. More interestingly, we observed another phase (space group: \textit{Pnma}, 62) that is more stable than $ω$ and \textit{A}15. Its stability is confirmed by its phonon spectra and elastic constants. For $ω$-Ta, the calculated elastic constants and high-temperature phonon spectra both imply that it is neither mechanically nor dynamically stable. Thus, $ω$ is not the structure to which bcc-Ta transits before melting. On the contrary, the good agreement of \textit{Pnma}-Ta shear sound velocities with experiment suggests \textit{Pnma} is the new structure of Ta implied by the discontinuation of shear sound velocities in recent shock experiment [J. Appl. Phys. \textbf{111}, 033511 (2012)].

cond-mat.mtrl-sci↗

arXiv2011

A Compressed Sensing Framework of Frequency-Sparse Signals through Chaotic Systems

This paper proposes a compressed sensing (CS) framework for the acquisition and reconstruction of frequency-sparse signals with chaotic dynamical systems. The sparse signal is acting as an excitation term of a discrete-time chaotic system and the compressed measurement is obtained by downsampling the system output. The reconstruction is realized through the estimation of the excitation coefficients with principle of impulsive chaos synchronization. The -norm regularized nonlinear least squares is used to find the estimation. The proposed framework is easily implementable and creates secure measurements. The Henon map is used as an example to illustrate the principle and the performance.

cs.IT↗