arXiv subjects

François Leduc-Primeau

Publications and source records attributed to François Leduc-Primeau.

26 records · Page 2Linked to original sources

arXiv2020

RSSI-Based Hybrid Beamforming Design with Deep Learning

Hybrid beamforming is a promising technology for 5G millimetre-wave communications. However, its implementation is challenging in practical multiple-input multiple-output (MIMO) systems because non-convex optimization problems have to be solved, introducing additional latency and energy consumption. In addition, the channel-state information (CSI) must be either estimated from pilot signals or fed back through dedicated channels, introducing a large signaling overhead. In this paper, a hybrid precoder is designed based only on received signal strength indicator (RSSI) feedback from each user. A deep learning method is proposed to perform the associated optimization with reasonable complexity. Results demonstrate that the obtained sum-rates are very close to the ones obtained with full-CSI optimal but complex solutions. Finally, the proposed solution allows to greatly increase the spectral efficiency of the system when compared to existing techniques, as minimal CSI feedback is required.

eess.SP↗

arXiv2019

Layerwise Noise Maximisation to Train Low-Energy Deep Neural Networks

Deep neural networks (DNNs) depend on the storage of a large number of parameters, which consumes an important portion of the energy used during inference. This paper considers the case where the energy usage of memory elements can be reduced at the cost of reduced reliability. A training algorithm is proposed to optimize the reliability of the storage separately for each layer of the network, while incurring a negligible complexity overhead compared to a conventional stochastic gradient descent training. For an exponential energy-reliability model, the proposed training approach can decrease the memory energy consumption of a DNN with binary parameters by 3.3$\times$ at isoaccuracy, compared to a reliable implementation.

cs.LG↗

arXiv2019

Training Modern Deep Neural Networks for Memory-Fault Robustness

Because deep neural networks (DNNs) rely on a large number of parameters and computations, their implementation in energy-constrained systems is challenging. In this paper, we investigate the solution of reducing the supply voltage of the memories used in the system, which results in bit-cell faults. We explore the robustness of state-of-the-art DNN architectures towards such defects and propose a regularizer meant to mitigate their effects on accuracy. Our experiments clearly demonstrate the interest of operating the system in a faulty regime to save energy without reducing accuracy.

cs.LG↗

arXiv2017

Modeling and Energy Optimization of LDPC Decoder Circuits with Timing Violations

This paper proposes a "quasi-synchronous" design approach for signal processing circuits, in which timing violations are permitted, but without the need for a hardware compensation mechanism. The case of a low-density parity-check (LDPC) decoder is studied, and a method for accurately modeling the effect of timing violations at a high level of abstraction is presented. The error-correction performance of code ensembles is then evaluated using density evolution while taking into account the effect of timing faults. Following this, several quasi-synchronous LDPC decoder circuits based on the offset min-sum algorithm are optimized, providing a 23%-40% reduction in energy consumption or energy-delay product, while achieving the same performance and occupying the same area as conventional synchronous circuits.

cs.IT↗

arXiv2017

A Study of Deep Learning Robustness Against Computation Failures

For many types of integrated circuits, accepting larger failure rates in computations can be used to improve energy efficiency. We study the performance of faulty implementations of certain deep neural networks based on pessimistic and optimistic models of the effect of hardware faults. After identifying the impact of hyperparameters such as the number of layers on robustness, we study the ability of the network to compensate for computational failures through an increase of the network size. We show that some networks can achieve equivalent performance under faulty implementations, and quantify the required increase in computational complexity.

cs.NE↗

arXiv2017

A 9.52 dB NCG FEC scheme and 164 bits/cycle low-complexity product decoder architecture

Powerful Forward Error Correction (FEC) schemes are used in optical communications to achieve bit-error rates below $10^{-15}$. These FECs follow one of two approaches: concatenation of simpler hard-decision codes or usage of inherently powerful soft-decision codes. The first approach yields lower Net Coding Gains (NCGs), but can usually work at higher code rates and have lower complexity decoders. In this work, we propose a novel FEC scheme based on a product code and a post-processing technique. It can achieve an NCG of 9.52~dB at a BER of $10^{-15}$ and 9.96~dB at a BER of $10^{-18}$, an error-correction performance that sits between that of current hard-decision and soft-decision FECs. A decoder architecture is designed, tested on FPGA and synthesized in 65 nm CMOS technology: its 164 bits/cycle worst-case information throughput can reach 100 Gb/s at the achieved frequency of 609~MHz. Its complexity is shown to be lower than that of hard-decision decoders in literature, and an order of magnitude lower than the estimated complexity of soft-decision decoders.

cs.AR↗

arXiv2016

VLSI Implementation of Deep Neural Network Using Integral Stochastic Computing

The hardware implementation of deep neural networks (DNNs) has recently received tremendous attention: many applications in fact require high-speed operations that suit a hardware implementation. However, numerous elements and complex interconnections are usually required, leading to a large area occupation and copious power consumption. Stochastic computing has shown promising results for low-power area-efficient hardware implementations, even though existing stochastic algorithms require long streams that cause long latencies. In this paper, we propose an integer form of stochastic computation and introduce some elementary circuits. We then propose an efficient implementation of a DNN based on integral stochastic computing. The proposed architecture has been implemented on a Virtex7 FPGA, resulting in 45% and 62% average reductions in area and latency compared to the best reported architecture in literature. We also synthesize the circuits in a 65 nm CMOS technology and we show that the proposed integral stochastic architecture results in up to 21% reduction in energy consumption compared to the binary radix implementation at the same misclassification rate. Due to fault-tolerant nature of stochastic architectures, we also consider a quasi-synchronous implementation which yields 33% reduction in energy consumption w.r.t. the binary radix implementation without any compromise on performance.

cs.NE↗

arXiv2012

Relaxed Half-Stochastic Belief Propagation

Low-density parity-check codes are attractive for high throughput applications because of their low decoding complexity per bit, but also because all the codeword bits can be decoded in parallel. However, achieving this in a circuit implementation is complicated by the number of wires required to exchange messages between processing nodes. Decoding algorithms that exchange binary messages are interesting for fully-parallel implementations because they can reduce the number and the length of the wires, and increase logic density. This paper introduces the Relaxed Half-Stochastic (RHS) decoding algorithm, a binary message belief propagation (BP) algorithm that achieves a coding gain comparable to the best known BP algorithms that use real-valued messages. We derive the RHS algorithm by starting from the well-known Sum-Product algorithm, and then derive a low-complexity version suitable for circuit implementation. We present extensive simulation results on two standardized codes having different rates and constructions, including low bit error rate results. These simulations show that RHS can be an advantageous replacement for the existing state-of-the-art decoding algorithms when targeting fully-parallel implementations.

cs.AR↗