SearcharxivSearch

arXiv subjects

Frank Tsui

Publications and source records attributed to Frank Tsui.

4 recordsLinked to original sources

Modulating Surface Acoustic Wave Generation through Superconductivity

Surface acoustic waves (SAWs), with their five orders-of-magnitude slower propagation velocity, allow for considerably shorter wavelengths at the same frequency compared to electromagnetic waves. The short wavelengths allow for device miniaturization and on-chip integration. The generic design of these devices involve piezoelectric substrates with comblike arrays of Al or Au electrodes known as interdigitated transducers deposited on the surface. However, Al and Au both have shortcomings at the cryogenic temperatures required for quantum applications, namely the formation of two-level systems and the lack of superconductivity perpetuating Ohmic losses, respectively. In this work, SAWs are generated in the high-MHz to low-GHz range using niobium nitride (NbN) interdigitated transducers (IDTs) and Bragg reflectors. We demonstrate the fabrication of acoustic devices through photolithography and reactive ion etching (RIE). The sharp transition between superconducting and normal states and the corresponding change in SAW transmission allows for fine control of the 'on' (superconducting) and 'off' (normal) states of NbN, with a \Delta_T = K separating the transmission minimum and maximum. We demonstrate a 16x difference in transmission between the 'on' and 'off' states of the device. The SAW transmission behavior mirrors the change in resistance of NbN at its Tc. These findings open up new possibilities for the integration of NbN SAW resonators into existing quantum architectures based on NbN and a method for adjusting transmission properties independent of applied voltage.

cond-mat.mes-hall

Magneto-optical spectroscopy based on pump-probe strobe light

We demonstrate a pump-probe strobe light spectroscopy for sensitive detection of magneto-optical dynamics in the context of hybrid magnonics. The technique uses a combinatorial microwave-optical pump-probe scheme, leveraging both the high-energy resolution of microwaves and the high-efficiency detection using optical photons. In contrast to conventional stroboscopy using a continuous-wave light, we apply microwave and optical pulses with varying pulse widths, and demonstrate magnetooptical detection of magnetization dynamics in Y3Fe5O12 films. The detected magneto-optical signals strongly depend on the characteristics of both the microwave and the optical pulses as well as their relative time delays. We show that good magneto-optical sensitivity and coherent stroboscopic character are maintained even at a microwave pump pulse of 1.5 ns and an optical probe pulse of 80 ps, under a 7 megahertz clock rate, corresponding to a pump-probe footprint of ~1% in one detection cycle. Our results show that time-dependent strobe light measurement of magnetization dynamics can be achieved in the gigahertz frequency range under a pump-probe detection scheme.

cond-mat.mes-hall

Tuning Magneto-Optical Zero-Reflection via Dual-Channel Hybrid Magnonics

Multi-channel coupling in hybrid systems makes an attractive testbed not only because of the distinct advantages entailed in each constituent mode, but also the opportunity to leverage interference among the various excitation pathways. Here, via combined analytical calculation and experiment, we demonstrate that the phase of the magnetization precession at the interface of a coupled yttrium iron garnet(YIG)/permalloy(Py) bilayer is collectively controlled by the microwave photon field torque and the interlayer exchange torque, manifesting a coherent, dual-channel excitation scheme that effectively tunes the magneto-optic spectrum. The different torque contributions vary with frequency, external bias field, and types of interlayer coupling between YIG and Py, which further results in destructive or constructive interferences between the two excitation channels, and hence, selective suppression or amplification of the hybridized magnon modes.

cond-mat.mtrl-sci

Phase-resolving spin-wave microscopy using infrared strobe light

The needs for sensitively and reliably probing magnetization dynamics have been increasing in various contexts such as studying novel hybrid magnonic systems, in which the spin dynamics strongly and coherently couple to other excitations, including microwave photons, light photons, or phonons. Recent advances in quantum magnonics also highlight the need for employing magnon phase as quantum state variables, which is to be detected and mapped out with high precision in on-chip micro- and nano-scale magnonic devices. Here, we demonstrate a facile optical technique that can directly perform concurrent spectroscopic and imaging functionalities with spatial- and phase-resolutions, using infrared strobe light operating at 1550-nm wavelength. To showcase the methodology, we spectroscopically studied the phase-resolved spin dynamics in a bilayer of Permalloy and Y3Fe5O12 (YIG), and spatially imaged the backward volume spin wave modes of YIG in the dipolar spin wave regime. Using the strobe light probe, the detected precessional phase contrast can be directly used to construct the map of the spin wave wavefront, in the continuous-wave regime of spin-wave propagation and in the stationary state, without needing any optical reference path. By selecting the applied field, frequency, and detection phase, the spin wave images can be made sensitive to the precession amplitude and phase. Our results demonstrate that infrared optical strobe light can serve as a versatile platform for magneto-optical probing of magnetization dynamics, with potential implications in investigating hybrid magnonic systems.

cond-mat.mtrl-sci