arXiv subjects

G. Blanchot

Publications and source records attributed to G. Blanchot.

4 recordsLinked to original sources

arXiv2021

Quality Inspection Aspects of Hybrid Prototypes for the CMS Outer Tracker Upgrade at HL-LHC

At the High Luminosity LHC (HL-LHC), the CMS experiment will need to operate at up to 200 interactions per 25 ns beam crossing time and with up to 4000 fb-1 of integrated luminosity. To achieve the physics goals the experiment needs to improve the tracking resolution and the ability to selectively trigger on specific physics events. The CMS tracker upgrade requires designing a new detector to cope with the HL-LHC conditions. The new Outer Tracker is based on two types of silicon modules (strip-strip and pixel-strip). Each module type has a few types of high-density interconnect hybrid circuits which house the front-end and auxiliary electronics. This paper introduces the technological choices for modules and hybrids and presents the quality inspection aspects of the first hybrid prototypes.

physics.ins-det↗

arXiv2021

Prototyping and qualification of 2S modules for the CMS Outer Tracker upgrade at the HL-LHC

In preparation for the High Luminosity LHC, the entire tracker detector of the CMS experiment will be exchanged as part of the Phase-2 Upgrade. The new Outer Tracker will comprise approximately 13,000 silicon sensor modules, of which 7608 are "2S modules" consisting of two parallel mounted silicon strip sensors, and 5592 are "PS modules" consisting of one pixel and one strip sensor in a single module. These modules provide tracking information to the Level 1 trigger by correlating the hit information of both sensor layers, allowing discrimination of particle tracks by their transverse momentum. To guarantee successful operation during data-taking, the production of the outer tracker modules has to fulfill strict requirements. This note will discuss the assembly procedures as well as some key results of the electronic, thermal and vibration tests performed at CERN for qualifying the 2S module design and for preparing the module assembly procedures.

physics.ins-det↗

arXiv2020

The Cesium Source Calibration and Monitoring System of the ATLAS Tile Calorimeter: Design, Construction and Results

This article describes the design, construction and use of a calibration and monitoring system, based on movable 137Cs gamma-ray sources, for the ATLAS Tile Calorimeter (TileCal). The sources, propelled by a water-based liquid through tubes that traverse all the calorimeter's cells, produce signals that precisely characterise the response of each tile, thereby providing very granular and accurate data on the response of TileCal to particles. The system has been used to guide and control the quality of the optical instrumentation of all TileCal modules, to set and equalise the dynamic range of the response to physics data, and to set the energy scale of the readout system. In the ATLAS cavern, periodic measurements of the whole detector's response to 137Cs sources allow monitoring the uniformity and stability of all the calorimeter's cells as well as maintaining precise knowledge of its energy calibration. The design of the source hydraulic drive system's hardware and software, the data acquisition system and the data processing algorithms are described. Finally, the results of this two-decade program are shown.

physics.ins-det↗

arXiv2016

The ALFA Roman Pot Detectors of ATLAS

The ATLAS Roman Pot system is designed to determine the total proton-proton cross-section as well as the luminosity at the Large Hadron Collider (LHC) by measuring elastic proton scattering at very small angles. The system is made of four Roman Pot stations, located in the LHC tunnel in a distance of about 240~m at both sides of the ATLAS interaction point. Each station is equipped with tracking detectors, inserted in Roman Pots which approach the LHC beams vertically. The tracking detectors consist of multi-layer scintillating fibre structures readout by Multi-Anode-Photo-Multipliers.

physics.ins-det↗