Searcharxiv⌕ Search

arXiv subjects

G. Gemme

Publications and source records attributed to G. Gemme.

32 records · Page 2Linked to original sources
arXiv2012

Scientific Objectives of Einstein Telescope

The advanced interferometer network will herald a new era in observational astronomy. There is a very strong science case to go beyond the advanced detector network and build detectors that operate in a frequency range from 1 Hz-10 kHz, with sensitivity a factor ten better in amplitude. Such detectors will be able to probe a range of topics in nuclear physics, astronomy, cosmology and fundamental physics, providing insights into many unsolved problems in these areas.

gr-qc↗
arXiv2011

Characterization of the Virgo Seismic Environment

The Virgo gravitational wave detector is an interferometer (ITF) with 3km arms located in Pisa, Italy. From July to October 2010, Virgo performed its third science run (VSR3) in coincidence with the LIGO detectors. Despite several techniques adopted to isolate the interferometer from the environment, seismic noise remains an important issue for Virgo. Vibrations produced by the detector infrastructure (such as air conditioning units, water chillers/heaters, pumps) are found to affect Virgo's sensitivity, with the main coupling mechanisms being through beam jitter and scattered light processes. The Advanced Virgo (AdV) design seeks to reduce ITF couplings to environmental noise by having most vibration-sensitive components suspended and in-vacuum, as well as muffle and relocate loud machines. During the months of June and July 2010, a Guralp-3TD seismometer was stationed at various locations around the Virgo site hosting major infrastructure machines. Seismic data were examined using spectral and coherence analysis with seismic probes close to the detector. The primary aim of this study was to identify noisy machines which seismically affect the ITF environment and thus require mitigation attention. Analyzed machines are located at various distances from the experimental halls, ranging from 10m to 100m. An attempt is made to measure the attenuation of emitted noise at the ITF and correlate it to the distance from the source and to seismic attenuation models in soil.

gr-qc↗
arXiv2011

Calibration and sensitivity of the Virgo detector during its second science run

The Virgo detector is a kilometer-length interferometer for gravitational wave detection located near Pisa (Italy). During its second science run (VSR2) in 2009, six months of data were accumulated with a sensitivity close to its design. In this paper, the methods used to determine the parameters for sensitivity estimation and gravitational wave reconstruction are described. The main quantities to be calibrated are the frequency response of the mirror actuation and the sensing of the output power. Focus is also put on their absolute timing. The monitoring of the calibration data as well as the parameter estimation with independent techniques are discussed to provide an estimation of the calibration uncertainties. Finally, the estimation of the Virgo sensitivity in the frequency-domain is described and typical sensitivities measured during VSR2 are shown.

gr-qc↗
arXiv2010

Sensitivity Studies for Third-Generation Gravitational Wave Observatories

Advanced gravitational wave detectors, currently under construction, are expected to directly observe gravitational wave signals of astrophysical origin. The Einstein Telescope, a third-generation gravitational wave detector, has been proposed in order to fully open up the emerging field of gravitational wave astronomy. In this article we describe sensitivity models for the Einstein Telescope and investigate potential limits imposed by fundamental noise sources. A special focus is set on evaluating the frequency band below 10Hz where a complex mixture of seismic, gravity gradient, suspension thermal and radiation pressure noise dominates. We develop the most accurate sensitivity model, referred to as ET-D, for a third-generation detector so far, including the most relevant fundamental noise contributions.

gr-qc↗
arXiv2010

Virgo calibration and reconstruction of the gravitational wave strain during VSR1

Virgo is a kilometer-length interferometer for gravitational waves detection located near Pisa. Its first science run, VSR1, occured from May to October 2007. The aims of the calibration are to measure the detector sensitivity and to reconstruct the time series of the gravitational wave strain h(t). The absolute length calibration is based on an original non-linear reconstruction of the differential arm length variations in free swinging Michelson configurations. It uses the laser wavelength as length standard. This method is used to calibrate the frequency dependent response of the Virgo mirror actuators and derive the detector in-loop response and sensitivity within ~5%. The principle of the strain reconstruction is highlighted and the h(t) systematic errors are estimated. A photon calibrator is used to check the sign of h(t). The reconstructed h(t) during VSR1 is valid from 10 Hz up to 10 kHz with systematic errors estimated to 6% in amplitude. The phase error is estimated to be 70 mrad below 1.9 kHz and 6 micro-seconds above.

gr-qc↗
arXiv2007

All-sky incoherent search for periodic signals with Explorer 2005 data

The data collected during 2005 by the resonant bar Explorer are divided into segments and incoherently summed in order to perform an all-sky search for periodic gravitational wave signals. The parameter space of the search spanned about 40 Hz in frequency, over 23927 positions in the sky. Neither source orbital corrections nor spindown parameters have been included, with the result that the search was sensible to isolated neutron stars with a frequency drift less than 6 X 10^{-11} Hz/s. No gravitational wave candidates have been found by means of the present analysis, which led to a best upper limit of 3.1 X 10^{-23} for the dimensionless strain amplitude.

gr-qc↗
arXiv2006

Superconducting cavity transducer for resonant gravitational radiation antennas

Parametric transducers, such as superconducting rf cavities, can boost the bandwidth and sensitivity of the next generation resonant antennas, thanks to a readily available technology. We have developed a fully coupled dynamic model of the system "antenna--transducer" and worked out some estimates of signal--to--noise ratio and the stability conditions in various experimental configurations. We also show the design and the prototype of a rf cavity which, together with a suitable read--out electronic, will be used as a test bench for the parametric transducer.

gr-qc↗
arXiv2002

A detector of gravitational waves based on coupled microwave cavities

Since 1978 superconducting coupled cavities have been proposed as sensitive detector of gravitational waves. The interaction of the gravitational wave with the cavity walls, and the resulting motion, induces the transition of some electromagnetic energy from an initially excited cavity mode to an empty one. The energy transfer is maximum when the frequency of the wave is equal to the frequency difference of the two cavity modes. In this paper the basic principles of the detector are discussed. The interaction of a gravitational wave with the cavity walls is studied in the proper reference frame of the detector, and the coupling between two electromagnetic normal modes induced by the wall motion is analyzed in detail. Noise sources are also considered; in particular the noise coming from the brownian motion of the cavity walls is analyzed. Some ideas for the developement of a realistic detector of gravitational waves are discussed; the outline of a possible detector design and its expected sensitivity are also shown.

gr-qc↗
arXiv2001

Parametric gravity wave detector

Since 1978 superconducting coupled cavities have been proposed as a sensitive detector of gravitational waves. The interaction of the gravitational wave with the cavity walls, and the esulting motion, induces the transition of some energy from an initially excited cavity mode to an empty one. The energy transfer is maximum when the frequency of the wave is equal to the frequency difference of the two cavity modes. In 1984 Reece, Reiner and Melissinos built a detector of the type proposed, and used it as a transducer of harmonic mechanical motion, achieving a sensitivity to fractional deformations of the order dx/x ~ 10^(-18). In this paper the working principles of the detector are discussed and the last experimental results summarized. New ideas for the development of a realistic gravitational waves detector are considered; the outline of a possible detector design and its expected sensitivity are also shown.

gr-qc↗
arXiv2001

A detector of small harmonic displacements based on two coupled microwave cavities

The design and test of a detector of small harmonic displacements is presented. The detector is based on the principle of the parametric conversion of power between the resonant modes of two superconducting coupled microwave cavities. The work is based on the original ideas of Bernard, Pegoraro, Picasso and Radicati, who, in 1978, suggested that superconducting coupled cavities could be used as sensitive detectors of gravitational waves, and on the work of Reece, Reiner and Melissinos, who, {in 1984}, built a detector of this kind. They showed that an harmonic modulation of the cavity length l produced an energy transfer between two modes of the cavity, provided that the frequency of the modulation was equal to the frequency difference of the two modes. They achieved a sensitivity to fractional deformations of dl/l~10^{-17} Hz^{-1/2}. We repeated the Reece, Reiner and Melissinos experiment, and with an improved experimental configuration and better cavity quality, increased the sensitivity to dl/l~10^{-20} Hz^{-1/2}. In this paper the basic principles of the device are discussed and the experimental technique is explained in detail. Possible future developments, aiming at gravitational waves detection, are also outlined.

gr-qc↗
arXiv2000

The rf control and detection system for PACO the parametric converter detector

In this technical note the rf control and detection system for a detector of small harmonic displacements based on two coupled microwave cavities (PACO) is presented. The basic idea underlying this detector is the principle of parametric power conversion between two resonant modes of the system, stimulated by the (small) harmonic modulation of one system parameter. In this experiment we change the cavity length applying an harmonic voltage to a piezo-electric crystal. The system can achieve a great sensitivity to small harmonic displacements and can be an interesting candidate for the detection of small, mechanically coupled, interactions (e.g. high frequency gravitational waves).

physics.ins-det↗
arXiv2000

The Stern-Gerlach interaction between a traveling particle and a time varying magnetic field

The general expression of the Stern-Gerlach force is deduced for a charged particle, endowed with a magnetic moment, which travels inside a time varying magnetic field. Then, the energy integral of the Stern-Gerlach force is evaluated in the case of a particle crossing a TE rf cavity with its magnetic moment oriented in different ways with respect as the cavity axis. We shall demonstrate that appropriate choices of the cavity characteristics and of the spin orientation confirm the possibility of separating in energy the opposite spin states of a fermion beam circulating in a storage ring and, in addition, make feasible an absolute polarimeter provide that a parametric converter acting between two coupled cavities is implemented

physics.acc-ph↗
arXiv1999

Two Coupled Superconducting Cavities as a Gravitational Wave Detector: First Experimental Results

First experimental results of a feasibility study of a gravitational wave detector based on two coupled superconducting cavities are presented. Basic physical principles underlying the detector behaviour and sensitivity limits are discussed. The detector layout is described in detail and its rf properties are showed. The limit sensitivity to small harmonic displacements at the detection frequency (around 1 MHz) is showed. The system performance as a potential g.w. detector is discussed and future developments are foreseen.

gr-qc↗