arXiv subjects

G. Volpe

Publications and source records attributed to G. Volpe.

8 recordsLinked to original sources

arXiv2026

Efficient and precise Cherenkov-based charged particle timing using SiPMs

Dedicated R&D efforts are currently underway to couple a thin Cherenkov radiator to Silicon Photomultiplier (SiPM) arrays for precise charged particle Time-of-Flight (ToF) measurements. The prompt nature of Cherenkov radiation makes it an ideal candidate for achieving ultimate timing performance in a ToF detector. Using a thin radiator with a high refractive index, such as fused silica, enables the generation of a fast signal from charged particles that exceed the Cherenkov threshold. A crucial requirement for approaching the target time resolution is the optimization of both the radiator material and thickness, as well as the optical coupling to the SiPM arrays. In this work, we present the main factors that affect the time resolution and the expected performance achieved through a detailed Monte Carlo simulation and the comparison with beam test results.

physics.ins-det↗

arXiv2026

Development of a novel compact and fast SiPM-based RICH detector for the future ALICE 3 PID system at LHC

A dedicated R\&D is ongoing for the charged particle identification system of the \mbox{ALICE 3} experiment proposed for the LHC Run 5 and beyond. One of the subsystems for the high-energy charged particle identification will be a Ring-Imaging Cherenkov (RICH) detector. The possibility of integrating Cherenkov-based charged particle timing measurements is currently under study. The proposed system is based on a proximity-focusing RICH configuration including an aerogel radiator separated from a SiPM array layer by an expansion gap. A thin high-refractive index window of transparent material, acting as a second Cherenkov radiator, is glued on the SiPM array to enable time-of-flight measurements of charged particles by exploiting the yield of Cherenkov photons in the thin window. We assembled a small-scale prototype instrumented with different Hamamatsu SiPM array sensors with pitches ranging from 1 to 3 mm, readout by custom boards equipped with the front-end Petiroc 2A ASICs to measure charges and times. The primary Cherenkov radiator consisted of a 2 cm thick aerogel tile, while various window materials, including SiO$_2$ and MgF$_2$, were used as secondary Cherenkov radiators. The prototype was successfully tested in a campaign at the CERN PS T10 beam line with pions and protons. This paper summarizes the results achieved in the 2023 test beam campaign.

physics.ins-det↗

arXiv2026

Test beam performance of a novel RICH detector with timing capabilities for the future ALICE~3 PID system at LHC

The ALICE Collaboration is proposing a completely new apparatus, ALICE 3, for the LHC Run 5 and beyond. A key subsystem for charged particle identification will be a Ring-Imaging Cherenkov (RICH) detector consisting of an aerogel radiator and a photosensitive surface based on Silicon Photomultiplier (SiPM) arrays in a proximity-focusing configuration. A thin high-refractive index slab of transparent material (window), acting as a second Cherenkov radiator, is glued on the entrance face of the SiPM arrays to achieve precise charged particle timing. Requiring time matching between aerogel Cherenkov photon and track hits leads to an improvement of pattern recognition by discarding the uncorrelated SiPM dark count hits. In this work we present the current status of the R\&D performed for the ALICE 3 RICH detector prototype and the expected full scale system performance. A special focus will be given to the beam test results obtained with a small-scale prototype instrumented with various array of Hamamatsu SiPMs with pitches ranging from 1 to 3 mm. The Cherenkov radiator consisted of a 2 cm thick aerogel tile with a refractive index of 1.03 at 400 nm wavelength. For timing measurements SiPM arrays coupled with two different window materials (SiO$_2$ and MgF$_2$) were used. The prototype was successfully tested in beam test campaigns at the CERN PS T10 beam line. The data were collected with a complete chain of front-end and readout electronics based on the Petiroc 2A and Radioroc 2 together with a picoTDC to measure charges and times. We measured a charged particle detection efficiency above 99\% and a single photon angular resolution better than 4.2 mrad at the Cherenkov angle saturation with a time resolution better than 70 ps for charged particles.

physics.ins-det↗

arXiv2026

Beam test studies for a SiPM-based RICH detector prototype for the future ALICE~3 experiment

The ALICE Collaboration is proposing a completely new apparatus, ALICE~3, for the LHC Runs~5 and beyond. In this context, a key subsystem for high-energy charged particle identification will be a proximity-focusing ring-imaging Cherenkov detector using aerogel as radiator and silicon photomultipliers (SiPMs) as photon sensors. We assembled a small-scale prototype instrumented with Hamamatsu S13352 and S13361-3075AE-08 SiPM arrays, readout by custom boards equipped with front-end Petiroc 2A ASICs. The Cherenkov radiator consisted of a 2 cm thick hydrophobic aerogel tile with a refractive index of 1.03 separated from the SiPM plane by a 23 cm expansion gap. The prototype was successfully tested in a campaign at the CERN PS T10 beam line with the goal of validating the design bRICH specifications in terms to achieve the target separation power. We measured a single photon angular resolution of 3.8~mrad at the Cherenkov angle saturation value of 242~mrad, as well as the expected scaling of the angular resolution with the increasing number of detected photons. We also studied the contribution of uncorrelated and correlated background sources with respect to the signal and proved the effectiveness of time matching between charged tracks and photon hits to achieve efficient suppression of the SiPM dark count rate background. In this paper, the detector concept, the description of the tested prototype layout and the main beam test results are reported.

physics.ins-det↗

arXiv2017

A GEM-based detector for detection and imaging sparks and flames

Earlier we have developed and successfully tested a RICH detector prototype consisting in a CsI coated triple GEM operated in gas flushed mode In the given work, a modified version of this detector for a completely different application - fire safety- is presented. The detector operates in sealed mode and is combined with an optical system and a narrow band filter As a photosensitive element, a CsI photocathode coated with a thin layer of ethylferrocene was used. This detector is almost 1000 times more sensitive than the best commercial flame sensor; it has 100 times better time resolution and allows determining the location where the spark or flame appears

physics.ins-det↗

arXiv2013

A Very High Momentum Particle Identification Detector

The construction of a new detector is proposed to extend the capabilities of ALICE in the high transverse momentum (pT) region. This Very High Momentum Particle Identification Detector (VHMPID) performs charged hadron identification on a track-by-track basis in the 5 GeV/c < p < 25 GeV/c momentum range and provides ALICE with new opportunities to study parton-medium interactions at LHC energies. The VHMPID covers up to 30% of the ALICE central barrel and presents sufficient acceptance for triggered- and tagged-jet studies, allowing for the first time identified charged hadron measurements in jets. This Letter of Intent summarizes the physics motivations for such a detector as well as its layout and integration into ALICE.

nucl-ex↗

arXiv2011

VHMPID: a new detector for the ALICE experiment at LHC

This article presents the basic idea of VHMPID, an upgrade detector for the ALICE experiment at LHC, CERN. The main goal of this detector is to extend the particle identification capabilities of ALICE to give more insight into the evolution of the hot and dense matter created in Pb-Pb collisions. Starting from the physics motivations and working principles the challenges and current status of development is detailed.

hep-ex↗

arXiv2008

Contribution of the HMPID detector to the high-pT physics at LHC

The LHC will deliver unexplored energy regimes for proton-proton and heavy-ion collisions. As shown by the RHIC experiments, particle identification over a large momentum range is essential to disentangle physics processes, especially in the intermediate p$_T$ (1 $<p_{T}<5$ GeV/c) region. The novel design of the High-Momentum Particle Identification Detector (HMPID), based on large surface CsI photocathodes, is able to identify $π^{\pm}$, $K^{\pm}$, $p$ and $\bar{p}$ in the momentum region where bulk medium properties and hard scatterings interplay. Furthermore, measurement of resonance particles such as the $ϕ\to K^+K^-$ could provide information on the system evolution. The HMPID layout and segmentation are optimized to study particle correlations at high momenta describing the early phase and the dynamical evolution of the collision. At LHC, the increased hard cross section will significantly be enhanced compared to RHIC. Jet reconstruction via Deterministic Annealing can address jet quenching and detailed measurements of jet properties. In this paper, we present these selected topics from the possible HMPID contributions to the physics goals of LHC.

nucl-ex↗