arXiv subjects

Gabriel Ycas

Publications and source records attributed to Gabriel Ycas.

11 recordsLinked to original sources

arXiv2020

Open-path Dual-comb Spectroscopy for Multispecies Trace Gas Detection in the 4.5 μm to 5 μm Spectral Region

Open-path dual-comb spectroscopy provides multi-species atmospheric gas concentration measurements with high precision. Here, we extend open-path dual comb spectroscopy to the mid-infrared 5 μm atmospheric window, enabling atmospheric concentration retrievals of the primary greenhouse gases, N$_2$O, CO$_2$, and H$_2$O as well as the criterion air pollutants O$_3$ and CO across 600 m and 2 km round-trip paths. We demonstrate measurements over a five-day period at two-minute temporal resolution with 80% uptime. The achieved precision is sufficient to resolve the atmospheric concentration variations of the multiple gas species; retrieved dry mixing ratios of CO and N$_2$O are in good agreement with a co-located point sensor. In addition, the retrieved ratio of excess CO vs CO$_2$ agrees with similar urban studies but disagrees with the US National Emission Inventory by a factor of 3. Our retrieved ratio of excess N$_2$O vs CO$_2$ exhibits a plume-dependent value, indicating the variability of sources of the greenhouse gas N$_2$O.

physics.ao-ph↗

arXiv2019

Stellar Spectroscopy in the Near-infrared with a Laser Frequency Comb

The discovery and characterization of exoplanets around nearby stars is driven by profound scientific questions about the uniqueness of Earth and our Solar System, and the conditions under which life could exist elsewhere in our Galaxy. Doppler spectroscopy, or the radial velocity (RV) technique, has been used extensively to identify hundreds of exoplanets, but with notable challenges in detecting terrestrial mass planets orbiting within habitable zones. We describe infrared RV spectroscopy at the 10 m Hobby-Eberly telescope that leverages a 30 GHz electro-optic laser frequency comb with nanophotonic supercontinuum to calibrate the Habitable Zone Planet Finder spectrograph. Demonstrated instrument precision <10 cm/s and stellar RVs approaching 1 m/s open the path to discovery and confirmation of habitable zone planets around M-dwarfs, the most ubiquitous type of stars in our Galaxy.

astro-ph.EP↗

arXiv2018

Dual-comb spectroscopy with tailored spectral broadening in Si$_3$N$_4$ nanophotonics

Si$_3$N$_4$ waveguides, pumped at 1550 nm, can provide spectrally smooth, broadband light for gas spectroscopy in the important 2 ${\mathrmμ}$m to 2.5 ${\mathrmμ}$m atmospheric water window, which is only partially accessible with silica-fiber based systems. By combining Er+:fiber frequency combs and supercontinuum generation in tailored Si$_3$N$_4$ waveguides, high signal-to-noise dual-comb spectroscopy (DCS) spanning 2 ${\mathrmμ}$m to 2.5 ${\mathrmμ}$m is demonstrated. Acquired broadband dual-comb spectra of CO and CO$_2$ agree well with database line shape models and have a spectral-signal-to-noise as high as 48$/\sqrt{\mathrm{s}}$, showing that the high coherence between the two combs is retained in the Si$_3$N$_4$ supercontinuum generation. The DCS figure of merit is 6$\times 10^6/\sqrt{\mathrm{s}}$, equivalent to that of all-fiber DCS systems in the 1.6 ${\mathrmμ}$m band. Based on these results, future DCS can combine fiber comb technology with Si$_3$N$_4$ waveguides to access new spectral windows in a robust non-laboratory platform.

physics.optics↗

arXiv2018

Mid-infrared frequency comb generation via cascaded quadratic nonlinearities in quasi-phase-matched waveguides

We experimentally demonstrate a simple configuration for mid-infrared (MIR) frequency comb generation in quasi-phase-matched lithium niobate waveguides using the cascaded-$χ^{(2)}$ nonlinearity. With nanojoule-scale pulses from an Er:fiber laser, we observe octave-spanning supercontinuum in the near-infrared with dispersive-wave generation in the 2.5--3 $\textμ$m region and intra-pulse difference-frequency generation in the 4--5 $\textμ$m region. By engineering the quasi-phase-matched grating profiles, tunable, narrow-band MIR and broadband MIR spectra are both observed in this geometry. Finally, we perform numerical modeling using a nonlinear envelope equation, which shows good quantitative agreement with the experiment---and can be used to inform waveguide designs to tailor the MIR frequency combs. Our results identify a path to a simple single-branch approach to mid-infrared frequency comb generation in a compact platform using commercial Er:fiber technology.

physics.optics↗

arXiv2017

Dual frequency comb spectroscopy in the molecular fingerprint region

Spectroscopy in the molecular fingerprint spectral region (6.5-20 $μ$m) yields critical information on material structure for physical, chemical and biological sciences. Despite decades of interest and effort, this portion of the electromagnetic spectrum remains challenging to cover with conventional laser technologies. In this report, we present a simple and robust method for generating super-octave, optical frequency combs in the fingerprint region through intra-pulse difference frequency generation in an orientation-patterned gallium phosphide crystal. We demonstrate the utility of this unique coherent light source for high-precision, dual-comb spectroscopy in methanol and ethanol vapor. These results highlight the potential of laser frequency combs for a wide range of molecular sensing applications, from basic molecular spectroscopy to nanoscopic imaging.

physics.optics↗

arXiv2017

High Coherence Mid-Infrared Dual Comb Spectroscopy Spanning 2.6 to 5.2 microns

Mid-infrared dual-comb spectroscopy has the potential to supplant conventional high-resolution Fourier transform spectroscopy in applications that require high resolution, accuracy, signal-to-noise ratio, and speed. Until now, dual-comb spectroscopy in the mid-infrared has been limited to narrow optical bandwidths or to low signal-to-noise ratios. Using a combination of digital signal processing and broadband frequency conversion in waveguides, we demonstrate a mid-infrared dual-comb spectrometer that can measure comb-tooth resolved spectra across an octave of bandwidth in the mid-infrared from 2.6-5.2 $μ$m with sub-MHz frequency precision and accuracy and with a spectral signal-to-noise ratio as high as 6500. As a demonstration, we measure the highly structured, broadband cross-section of propane (C3H8) in the 2860-3020 cm-1 region, the complex phase/amplitude spectrum of carbonyl sulfide (COS) in the 2000 to 2100 cm-1 region, and the complex spectra of methane, acetylene, and ethane in the 2860-3400 cm-1 region.

physics.optics↗

arXiv2017

Frequency stability characterization of a broadband fiber Fabry-Perot interferometer

An optical etalon illuminated by a white light source provides a broadband comb-like spectrum that can be employed as a calibration source for astronomical spectrographs in radial velocity (RV) surveys for extrasolar planets. For this application the frequency stability of the etalon is critical, as its transmission spectrum is susceptible to frequency fluctuations due to changes in cavity temperature, optical power and input polarization. In this paper we present a laser frequency comb measurement technique to characterize the frequency stability of a custom-designed fiber Fabry-Perot interferometer (FFP). Simultaneously probing the stability of two etalon resonance modes, we assess both the absolute stability of the etalon and the long-term stability of the cavity dispersion. We measure mode positions with MHz precision, which corresponds to splitting the FFP resonances by a part in 500 and to RV precision of ~1 m/s. We address limiting systematic effects, including the presence of parasitic etalons, that need to be overcome to push the metrology of this system to the equivalent RV precision of 10 cm/s. Our results demonstrate a means to characterize environmentally-driven perturbations of etalon resonance modes across broad spectral bandwidths, as well as motivate the benefits and challenges of FFPs as spectrograph calibrators.

astro-ph.IM↗

arXiv2016

Rapid, broadband spectroscopic temperature measurement of CO2 using VIPA spectroscopy

Time-resolved spectroscopic temperature measurements of a sealed carbon dioxide sample cell were realized with an optical frequency comb combined with a two-dimensional dispersive spectrometer. A supercontinuum laser source based on an erbium fiber mode-locked laser was employed to generate coherent light around 2000 nm (5000 cm-1). The laser was passed through a 12-cm long cell containing CO2, and the transmitted light was analyzed in a virtually imaged phased array- (VIPA-) based spectrometer. Broadband spectra spanning more than 100 cm-1 with a spectral resolution of roughly 0.075 cm-1 (2.2 GHz) were acquired with an integration period of 2 ms. The temperature of the CO2 sample was deduced from fitting a modeled spectrum to the line intensities of the experimentally acquired spectrum. Temperature dynamics on the time scale of milliseconds were observed with a temperature resolution of 2.6 K. The spectroscopically-deduced temperatures agreed with temperatures of the sample cell measured with a thermistor. Potential applications of this technique include quantitative measurement of carbon dioxide concentration and temperature dynamics in gas-phase chemical reactions (e.g., combustion), and plasma diagnostics.

physics.optics↗

arXiv2015

Mid-Infrared Optical Frequency Combs based on Difference Frequency Generation for Molecular Spectroscopy

Mid-infrared femtosecond optical frequency combs were produced by difference frequency generation of the spectral components of a near-infrared comb in a 3-mm-long MgO:PPLN crystal. We observe strong pump depletion and 9.3 dB parametric gain in the 1.5 μm signal, which yields powers above 500 mW (3 μW/mode) in the idler with spectra covering 2.8 μm to 3.5 μm. Potential for broadband, high-resolution molecular spectroscopy is demonstrated by absorption spectra and interferograms obtained by heterodyning two combs.

physics.optics↗

arXiv2014

Tunable, Stable Source of Femtosecond Pulses Near 2 μm via Supercontinuum of an Erbium Mode-Locked Laser

A source of ultrashort pulses of light in the 2 μm region was constructed using supercontinuum broadening from an erbium mode-locked laser. The output spectrum spanned 1000 nm to 2200 nm with an average power of 250 mW. A pulse width of 39 fs for part of the spectrum in the 2000 nm region, corresponding to less than six optical cycles, was achieved. A heterodyne measurement of the free-running mode-locked laser with a narrow-linewidth continuous wave laser resulted in a near shot noise-limited beat note with a signal-to-noise ratio of 45 dB in a 10 kHz resolution bandwidth. The relative intensity noise of the broadband system was investigated over the entire supercontinuum, and the integrated relative intensity noise of the 2000 nm portion of the spectrum was 0.0017. The long-term stability of the system was characterized, and intensity fluctuations in the spectrum were found to be highly correlated throughout the supercontinuum. Spectroscopic limitations due to the laser noise characteristics are discussed.

physics.optics↗

arXiv2013

Generation of a 650 nm - 2000 nm Laser Frequency Comb based on an Erbium-Doped Fiber Laser

We present a laser frequency comb based upon a 250 MHz mode-locked erbium-doped fiber laser that spans more than 300 terahertz of bandwidth, from 660 nm to 2000 nm. The system generates 1.2 nJ, 70 fs pulses at 1050 nm by amplifying the 1580 nm laser light in Er:fiber, followed by nonlinear broadening to 1050 nm and amplification in Yb:fiber. Extension of the frequency comb into the visible is achieved by supercontinuum generation from the 1050 nm light. Comb coherence is verified with cascaded f-2f interferometry and comparison to a frequency stabilized laser.

physics.optics↗